20 Most Recent 2006 Peugeot 207 1.6 Questions & Answers


needs 3 people
one to hold the bonnet up and one on each side to undo the hinge bolts and gas struts if used
replacement is reverse with an adjustment before the bolts are properly tightened
about 10 minutes work

2006 Peugeot 207... | Answered on Jun 30, 2017


temp sensor on engine check that has wire on it in the manifold

2006 Peugeot 207... | Answered on Apr 20, 2016


If you suspect low refrigerant you can use paperclip to jumper the low pressure switch momentarily. Relay should be in main fuse block under the hood, I think.

2006 Peugeot 207... | Answered on Jun 12, 2015


Hi all, i got an lamp light indicator on, with an error message on car computer display indicating an error in "either airbag or pretensionator belt". I conduct the diagnosis and the error message that appear was "C3362" on the passenger seat. what kind of problem is this? my car is peugeot 308 from 2008 HDI engine. thanks to all

2006 Peugeot 207... | Answered on Apr 30, 2015


Go and check the rear left and right tail lights. take off connector and you'll notice that earth wire and pin is blown.

2006 Peugeot 207... | Answered on Apr 08, 2015


Hi Stephen, I think the problem is a leakage from either the clutch master or slave cylinder. Open the hood and check the fluid level in the clutch reservoir. If it's empty my suspicion is confirmed. Look for signs of leakage first from the master cylinder, then the pipes and finally the slave cylinder. It's a good idea to replace both cylinders at the same time. To do so requires the following work. Inside the cabin the push rod connecting the pedal to the piston must be disconnected and then under the hood (bonnet) the fluid pipe disconnected followed by removal of the securing bolts. The same operation applies to the slave cylinder. When assembling always connect the pipes before securing the cylinders.Hand tighten the pipe connections, leaving just one final turn for the wrench (spanner). The pipe connectors are easily damaged by cross threading the connectors which results in leakage. Once the clutch operating system has been installed, fill the reservoir and have someone kind keep it full with dot 4 brake fluid. Open the slave cylinder bleed nipple and allow the fluid to flow into a container until the it flows without air bubbles and then close the nipple. Happy driving Regards John

2006 Peugeot 207... | Answered on Oct 27, 2013


get inside the car turn the ignition on look at the electronic controls that operate the mirrors where you select left and right mirrors and just pull it backwards, It had me stumped for a while a quick look at the owners manual made it all clear (207 GTI) hope it helps

2006 Peugeot 207... | Answered on Oct 11, 2012

Not finding what you are looking for?
2006 Peugeot 207 1.6 Logo

29 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85222 Answers

scj103

Level 2 Expert

104 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

207 Peugeot

  • 207 Peugeot

Most Popular Question

temp gauge rises in idle but when

  • Cars & Trucks
Loading...