20 Most Recent 2006 Mitsubishi Endeavor Questions & Answers


Do you have anything aftermarket in the vehicle?

2006 Mitsubishi... | Answered on Jun 03, 2018


connect a volt meter across the battery with the engine running must be around 14 volts, if not alternator or regulator at fault or drive belt loose . connect a amp in series with the battery with every thing switched off the draw must be less then 1/4 amp ,if not check for lights in trunk a glove box staying on.

2006 Mitsubishi... | Answered on May 03, 2017


Some of the new vehicles You can't change the fluid the old way
You have to take them to a certified Mechanic to have the system
evacuated and new fluid pumped in. not a cheap thing.
Good Luck.

2006 Mitsubishi... | Answered on Oct 13, 2016


It doesn't come with them.

2006 Mitsubishi... | Answered on Apr 26, 2016


It will be on the lower left hand side of the engine as you are looking at if from the front.

2006 Mitsubishi... | Answered on Dec 30, 2015


The part is 22.99 at Autozone,The freon has to be removed,then the old part has to be taken out,then new part installed,then system has to be leak tested,then new freon has to be installed,Since you probably don't have all the tools needed like me,I had my system done by Midas,my evaporator core was clogged up from a mouse nest and air from the blower motor couldn't go thru it,I couldn't take it out of the box cause I would have to unscrew lines and let freon out,so I let Midas do it,my 85 Nissan 720 4x4 is 30 years old,so I had them put a new expansion valve on.It is in the same box as the evaporator core,was only 20 something bucks,plus my truck had the old type freon in it and they put different fittings on the lines to install new type of freon,now my a.c. is ice cold.I recently myself put a new heater core in it and replaced the carpet,and changed the color from black to gray,it is so hot here in Georgia.I looked around on prices and Midas was the best,get a warranty too.Here's my 30 year old truck,had her for 22 years,better than new.
25826172-rdoomhept01zht4hc5mezemm-3-0.jpg

2006 Mitsubishi... | Answered on Aug 17, 2015


Have a look at the bulbs on the left side when the signal light is on. Are both bulbs on and not flashing or is there just one bulb on? If only one bulb on then the one that isn't on is most likely burned out

2006 Mitsubishi... | Answered on Apr 12, 2015


Not sure but most of them take a CR2025. When replacing it check if the two battery terminals are properly soldered to the circuit board. Its very common for the solder joints to become loose and the unit works intermittently, even with new batteries!

2006 Mitsubishi... | Answered on Mar 11, 2015


Drain plug on the bottom tank of radiator or remove hose (lower one ).

2006 Mitsubishi... | Answered on Aug 13, 2014

Not finding what you are looking for?
2006 Mitsubishi Endeavor Logo

153 questions posted

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Endeavor Mitsubishi

  • Endeavor Mitsubishi

Most Popular Question

2006 mitsubishi endeavor starter

  • Cars & Trucks
Loading...