Top 20 2002 GMC Yukon Denali Questions & Answers

Have the vehicle checked for code's . will show what cylinders are missing . Do drive it like that , check engine light flashing , will damage the catalytic converters

2002 GMC Yukon... | 117 views | 0 helpful votes

Try setting the cams to the correct clearance. Maybe a worn cam.

2002 GMC Yukon... | 84 views | 0 helpful votes

get the factory service and repair manual from the given link it will help to fix the problem your self

2002 GMC Yukon... | 34 views | 0 helpful votes

I was also facing a problem like this and i got the solution of my problem at the site .They provide best service manuals. .Try to visit it once.

2002 GMC Yukon... | 146 views | 0 helpful votes

have it looked at by a professional please

2002 GMC Yukon... | 51 views | 0 helpful votes

That is called the sway bar. You really really need that

2002 GMC Yukon... | 50 views | 0 helpful votes

You need to have the systems control module scanned for fault codes, anytime the light stays on there will be a fault code

2002 GMC Yukon... | 46 views | 0 helpful votes

a broken CV or UJ on a drive shaft can cause the steering to lock up , jack up front end and check for damage to the drive shaft's rubber covers to the drive joints, push/pull wheels in and out , as in steering motion while spinning wheel and feel if there is anything restricting a smoth movement , hope this helps

2002 GMC Yukon... | 74 views | 0 helpful votes

Are the cooling fans working when AC is 'ON'?

2002 GMC Yukon... | 63 views | 1 helpful votes

Have you tried to go to a near by autoparts store, ask them to check your computer, they can help you for free and they have part you need. Good luck

2002 GMC Yukon... | 37 views | 0 helpful votes

Did you pull a coil an check for spark before replacing the crank sensor ? Does it have fuel pressure ? Are there any lights lit on the SECURITY ? No Start Diagnostic Basics EricTheCarGuy

2002 GMC Yukon... | 89 views | 0 helpful votes

In fuse box under hood

2002 GMC Yukon... | 23 views | 1 helpful votes

atleast a couple hours if someone knows what they are doing

2002 GMC Yukon... | 32 views | 0 helpful votes

Check the solenoid switch on the electrical panel under the hood. Just switch the solenoid for the lights with one of the others just to test it. This is a cheap thing to replace.

2002 GMC Yukon... | 335 views | 0 helpful votes

Under the dash , steering wheel side, The panel right under steering wheel has to be taken off, two screws an two clips . The end of the dash has to be taken off first ! There are three connectors going to the BCM .
Removal Procedure

  1. Remove the IP cluster trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
  2. Move the IP extension rearwards. Refer to Instrument Panel Extension Replacement .
  3. tif.gif
  4. Remove the knee bolster screws.
  5. Unsnap the top of the knee bolster from the IP assembly

2002 GMC Yukon... | 99 views | 1 helpful votes

I am not familiar with your vehicle but if you call an auto parts store they will pull up a schematic for you and show you where it is exactly. Most likely a dealer would do the same.

2002 GMC Yukon... | 59 views | 0 helpful votes

There might be a short strap in the center of each section where the back and the seat come together. Pull that strap to release and fold the seat aginst the front seat. Then you should seelatches to release the backs and fold them down. Hope this helps

2002 GMC Yukon... | 320 views | 0 helpful votes

Not finding what you are looking for?
2002 GMC Yukon Denali Logo

586 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top GMC Experts


Level 3 Expert

85216 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Yukon Denali GMC

  • Yukon Denali GMC

Most Popular Question

find fan relay fuse ac

  • Cars & Trucks