1990 Chevrolet Celebrity - Answered Questions & Fixed issues


at front of engine below the exhaust manifold.

1990 Chevrolet... | Answered on Apr 18, 2015 | 58 views


When was the last time you changed the air filter ?? Do you pour a bottle of fuel injector cleaner once a month into the fuel tank ?? Clogged dirty fuel injectors will give the symptoms you describe.

1990 Chevrolet... | Answered on Mar 20, 2014 | 205 views


It may very well be the turn signal flasher itself, which will be located near the fuse block at the lower right of the steering column. Once you remove the fuse block cover, you should be able to see the flasher (usually dangling free by its wires) just above the fuse block, although sometimes you have to feel around a bit because, as it's dangling free, it can sometimes bounce around and get behind or to the side of the fuse block. Once you find it, you should be able to gently pull the flasher/wiring assembly down enough to be able to remove the flasher and replace it.
If you do NOT find it relatively easily, it should be noted that on certain models of the Celebrity, the flasher is actually clipped to the side of the ashtray rather than dangling free; I do not believe that this will be the case on your '90, but it's the only other place to look if you can't find it right around the fuses.
Good luck!

1990 Chevrolet... | Answered on Dec 03, 2013 | 68 views


Not even defrost?

1990 Chevrolet... | Answered on Nov 19, 2013 | 53 views


check for a possible short in your wiring.

1990 Chevrolet... | Answered on Oct 06, 2013 | 75 views


Its .044 Caution! Gap is not adjustable on certain plugs.

1990 Chevrolet... | Answered on Oct 06, 2013 | 193 views


Just a suggestion, but I would say check over your new wires and just to be sure, check all of your fuses as well. Do not do a half job on checking all of your fuses though. Take each one out and inspect it well just to be sure.

1990 Chevrolet... | Answered on Oct 06, 2013 | 111 views


Check the fuse and the relay

1990 Chevrolet... | Answered on Mar 20, 2013 | 35 views


sounds like it's out of time,chain must be on wrong.

1990 Chevrolet... | Answered on Feb 11, 2013 | 92 views


not sure, but on my 89 camaro it was the courtesy fuse. the courtesy light fuse should be in the fuse box directly below the ashtray. worth a shot to see if you can get the lighter working

1990 Chevrolet... | Answered on Feb 06, 2013 | 132 views


you could go to an autoparts store and have them try to read the codes coming out of it. if it says that it cannot communicate it could be bad. if you cannot get it to the store then the computer should run about $100, replace it if it fixes your problem then it was bad. if nothing changes take it back. also the computer is behind the glove box. i had trouble finding it.

1990 Chevrolet... | Answered on Feb 06, 2013 | 43 views


If it is a 2.5 i found if in the oil pan has large ring you need to remove and replace with new one
the oil filter is an open type filter not canaster contained. drain oil and remove ring socket size is close to an inch but metric the you will see the filter just pull it off with a pair of pliers and slide on a new one then replace ring
dont over tighten ring as you might squish the rubber seal to much hope this helps >

1990 Chevrolet... | Answered on Feb 06, 2013 | 105 views


on mine it is the trunk release

1990 Chevrolet... | Answered on Feb 06, 2013 | 39 views


The ignition module and the coil pack are not the same thing .. i think the coil pack is mounted on the front side of the engine nearest the radiator it might have three separate coils or they maybe all be in one pack . the ignition module is mounted under the coil pack . i would look at the ignition module 1st if the coil are separate and the crank sensor before i would replace the coils . a lot of these cars suffer from heat soak . which means when they get hot and some of the circuits open and cause a no spark condition . which is what the ignition module do a lot .

1990 Chevrolet... | Answered on Apr 08, 2011 | 423 views


ignition coils packs sits on top of the ignition module.cant miss it.

1990 Chevrolet... | Answered on Apr 02, 2011 | 180 views


that sounds like there maybe damaged wires or that there is a wiring fault. the new fuse you put in wasn't a bigger fuse then it is meant to have in it is it? cause if so instead of the fuse blowing the wires may melt together and damage parts or catch on fire etc.

1990 Chevrolet... | Answered on Mar 19, 2011 | 152 views


If you have no spark, have it scanned to see if you have an rpm reading. If not, the the crankshaft sensor would be the most likely culprit.

1990 Chevrolet... | Answered on Mar 10, 2011 | 580 views


Injectors shouldn't effect each other
You may have a bad coolant temp sensor, and it doesn't go into closed loop.
That is when it is warm and the O2 Sensors control the injector timing.
A bad thermostat also
Egr Valve ? Rusted out exhaust tube to egr
Vacuum Leaks?
Exhaust Leaks,near sensors?

1990 Chevrolet... | Answered on Nov 24, 2010 | 180 views

Not finding what you are looking for?
1990 Chevrolet Celebrity Logo

56 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...