1993 Chevrolet S-10 - Answered Questions & Fixed issues

93 s10 2.8 5speed. if

Sounds more like your motor is pressurised causing oil to flow out the easiest orifice. Put a compression test on cylinders if OK check valve stem seals for hardness.
But I would say you have blow by on rings.

1993 Chevrolet... | Answered on Apr 03, 2019 | 82 views

1 Answer

I have a 93 S10 2.5l 4 cyl it starts and after i cleaned the throttle body it idled almost wonderful but when i shift from park to reverse or drive it jerks and bogs down and dies. I also changed the

Go to online store reliable they have repair manuals I am sure you will get the solution. Here's the link
Best Manuals

1993 Chevrolet... | Answered on Nov 14, 2017 | 58 views

1 Answer

No break pedal

Have you checked the thing under the brake pedal? I can't recall what it is, a regulator or tensioner or something?

1993 Chevrolet... | Answered on Sep 30, 2017 | 48 views

1 Answer

Tail light ground (possibly)

Look for chaffed wires. A bad ground will not let the bulb work at all. Look closely at the wires on the reverse light. Follow them back to where they join the harness checking for pinch points or bare wires.

1993 Chevrolet... | Answered on May 13, 2017 | 44 views

1 Answer

I replaced the turn signal switch on my 93 chevy

the little contact could have bent and is sitting on the ring, you may have to bend it so it only makes contact when you push on the horn pad. things should fit easily if the force it things can get bent out of their original shape and cause issues.

1993 Chevrolet... | Answered on Apr 25, 2017 | 49 views

2 Answers

Where can I find the fuse box on 1993 4-cylinder chevy s-10?

cigarette lighter don;t work.dome light non;t work what fuse do i need chevy S10 1993 truck

1993 Chevrolet... | Answered on Apr 25, 2017 | 175 views

2 Answers

93 s10 2.8 manual. Overcharging problem. Truck sat for 2years before I bought it I did full time up. Starts and idles fine. Anything over 50mph and it jerks and tries to turn off.

Check the fuel system pressure - sounds like the fuel pump or fuel pressure regulator. As you increase speed the engine requires more gas and it sounds like it's starting to starve at 50+.

1993 Chevrolet... | Answered on Mar 11, 2017 | 72 views

1 Answer

Were is the spark core block located on a 93s10 tuck located

There is a pick up coil in the distributor. And an ignition module by the throttle body. The is also a coil. best to check power and ground to them before replacing good parts.

1993 Chevrolet... | Answered on Dec 21, 2016 | 20 views

1 Answer

1993 chevorlet s10 truck 2.8 5sp. small starter wires,from harness to solenoid.need to know witch wires go where.is the wires differant sizes? mine have been spliced.

Wires to the solenoid are generally smaller yes. Typically from ignition switch to solenoid is purple.

1993 Chevrolet... | Answered on Jul 26, 2016 | 73 views

1 Answer

Extended cab Tahoe truck, 4.3l. Why is brake light on I/P dimly lit?

Possible brake fluid level warning sensor problem in the master cylinder. Disconnect the wiring harness from the sensor in the master cylinder. If the light goes out, suspect the sensor. If the light continues to illuminate dimly, suspect a short to power in the harness on that circuit. Further diagnostics will be required to locate the problem

1993 Chevrolet... | Answered on Jan 13, 2016 | 233 views

1 Answer

Does the oil gauge and temperature gauge have a fuse on a 93 Chevy S10

do not think so .

1993 Chevrolet... | Answered on May 21, 2015 | 64 views

2 Answers

I have a 1993 Chevy s10 extended cab 4x4 pickup

child proof lock ...check owners manual..?

1993 Chevrolet... | Answered on May 02, 2015 | 128 views

1 Answer

How do you replace rear main oil seal on '93 Chevy S-10 pickup?

Remove trans, remove flywheel, remove and replace seal.

1993 Chevrolet... | Answered on Apr 15, 2015 | 121 views

1 Answer

Still won't crank,battery & alternator shows 12.66 amps. Is there another fuse box that could kill power?

Yes there called fuseable lines .Resistence wire like a fuse .
Olny is on large AMP drawing CKTS starters alts soleiods most times are part of the positive battery cable connection but can be replaced in sections of new wire after testing for resistance . Keep in mind use resistance wire to replace the link or you could do lots of damage if it shorts again its their for a reason.

1993 Chevrolet... | Answered on Apr 11, 2015 | 59 views

1 Answer

At speeds above 30 mph the engine feels like it is missing and on occasion it will kill the engine

if it feels like its missing, maybe an ignition wire breakdown under a load...cylinder balance test visual inspection try first...

1993 Chevrolet... | Answered on Apr 09, 2015 | 40 views

1 Answer

Under hood fuses

Have aclose look around the battery for another wire. Most cars have 1 large and up to 2 smaller wires connected to the positive terminal. 1 may have not been reconnected.

1993 Chevrolet... | Answered on Apr 11, 2015 | 80 views

1 Answer

Won't crank,new battery,good alternator no power to dash board fuses

Check fusible links off battery, and main fuse in power dist center

1993 Chevrolet... | Answered on Apr 09, 2015 | 38 views

1 Answer

Were is a ecm fuse locaed on a1993 s10 chevdolet truck

Service engine light may be wanting you to simply change the oil and reset the code.
You don't need to locate the ECM (what would you do if you found it???)

1993 Chevrolet... | Answered on Feb 13, 2015 | 144 views

1 Answer

1993 chev S-10 starter relay location if there is one?

There is no starter relay on the S-10 Blazer for that year. The only impediment to starting between the ignition switch and the starter is the clutch safety switch on manual transmission models.

1993 Chevrolet... | Answered on Jan 02, 2015 | 139 views

1 Answer

Is there a reset button on fuel on a chevy 93 s 10

No there is not. Probably needs a new fuel pump and strainer, they are in the tank. If that's the case don't forget to replace your fuel filter as well.

1993 Chevrolet... | Answered on Dec 13, 2014 | 40 views