20 Most Recent 1996 Dodge Avenger Questions & Answers


My personal suggestion would be to go for these repair catalogs. I know this website www.reliable-store com
that i used to buy them from, and they have pdf online it was very good manual. Go ahead, I bet.

1996 Dodge... | Answered on Mar 06, 2018


remove and clean or replace the iac.

1996 Dodge... | Answered on Jul 12, 2017


Does it close flush to the body but not latch or does it not close flush?

1996 Dodge... | Answered on Jul 31, 2016


If they are automatic windows flick the window switch diwn , up and and hold it up for about 10-15 seconds. I don't think it takes that long and you might only have to go up and down once but that way will make sure you got it.

1996 Dodge... | Answered on Oct 21, 2015


Engine Oil not the trans right?
Should be 4.5 qts Capacity
The manual calls for 5w-30 but you can use 10w-30 if you have high miles and issues with oil leaking. Of course once you fill it, check your oil dipstick to make sure you have enough.

1996 Dodge... | Answered on Sep 03, 2015


You will have to remove the assembly that the socket is attached to

1996 Dodge... | Answered on Jan 24, 2015


I had buy a Dodge ram with water in transmission, i had to flush it 3 time before it run good (with a mix of 1/2 fuel o?l and 1/2 transmission) because water make steam and body valve froze in winter and cannot shift any speed

Put it on jack stand and run speeds for 15 minutes .I put a drain plug at the transmission pan.(i tack weld 1/4 flat bar drill and tap ,a plug with a head

1996 Dodge... | Answered on Dec 06, 2014


Cirrus, Stratus, Sebring Convertible and Breeze CAUTION
The Supplemental Inflatable Restraint (SIR) system must be disarmed before working around the steering column. Failure to do so may cause accidental deployment of the air bags, resulting in unnecessary SIR system repairs and/or personal injury.
  1. Disarm the air bag system, as described in Scetion 6.
  2. Remove the upper steering column shroud.
  3. Pull down the lower steering column shroud enough to access the lock cylinder retaining tab.
  4. Turn the ignition key to the RUN position.
  5. Insert a small prying tool into the tab access hole and depress the tab. Fig. 1: Depress the retaining tab and remove the lock cylinder 90908g36.gif

  6. Pull the ignition lock cylinder from the steering column. To install:
  7. With the ignition key in the lock cylinder, turn the key to the RUN position. Depress the lock cylinder retaining tab. Fig. 2: The shaft at the end of the ignition lock cylinder lines up to the socket at the end of the lock cylinder housing 90908g37.gif

  8. The shaft at the end of the ignition lock cylinder lines up to the socket at the end of the lock cylinder housing. The socket must be in the RUN position for the socket and lock cylinder to line up.
  9. Line up the lock cylinder to the grooves in the lock cylinder housing. Insert the ignition lock cylinder into the housing until the retaining tab sticks through the opening in the housing.
  10. Lightly pull on the ignition lock to make sure it has engaged the retaining tab.
  11. Turn the key to the OFF position. Remove the ignition key.
  12. Install the steering column covers.
  13. Arm the air bag system, as described in Section 6.
Sebring Coupe and Avenger NOTE: For information on removing/installing the Ignition Lock Cylinder, refer to the Ignition Switch removal and installation procedure, earlier in this section. prev.gif next.gif

1996 Dodge... | Answered on Oct 31, 2014


1996 Dodge Avenger Car Radio Stereo Audio Wiring Diagram
Car Radio Battery Constant 12v+ Wire: Pink/White
Car Radio Accessory Switched 12v+ Wire: Red/White
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Orange/Brown
Car Stereo Dimmer Wire: Black/Green
Car Stereo Antenna Trigger: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Green
Left Front Speaker Negative Wire (-): Brown/Red
Right Front Speaker Positive Wire (+): Violet
Right Front Speaker Negative Wire (-): Blue/Red
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown/Yellow
Left Rear Speaker Negative Wire (-): Brown/Blue
Right Rear Speaker Positive Wire (+): Blue/White
Right Rear Speaker Negative Wire (-): Blue/Orange




1996 Dodge Avenger with Infinity Audio Car Radio Stereo Wiring Diagram
Car Radio Battery Constant 12v+ Wire: Red
Car Radio Accessory Switched 12v+ Wire: Blue
Car Radio Ground Wire: Chassis
Car Radio Illumination Wire: Green/Orange
Car Stereo Dimmer Wire: Green/Yellow
Car Stereo Antenna Trigger: N/A
Car Stereo Amp Trigger Wire: White/Black
Car Stereo Amplifier Location: Mounted under the rear deck. Some models have a black plastic trim covering the factory amplifier.
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): White/Blue
Left Front Speaker Negative Wire (-): Black/Blue
Right Front Speaker Positive Wire (+): White/Red
Right Front Speaker Negative Wire (-): Black/Red
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Yellow/Blue
Left Rear Speaker Negative Wire (-): Gray/Blue
Right Rear Speaker Positive Wire (+): Yellow/Red
Right Rear Speaker Negative Wire (-): Gray/Red

pls rate




google_protectAndRun("ads_core.google_render_ad", google_handleError, google_render_ad);

1996 Dodge... | Answered on Aug 07, 2014


these cars have speed sensors on the side of the transmission that tell the transmission when to shift...check these ...you may have 1 or two...have them replaced....this also may have set off a check engine light....good luck

1996 Dodge... | Answered on Jun 05, 2014


I would be going to the source of a possible problem and that is the battery. If the battery posts and terminals are dirty ( should be shiny clean) or loose then intermittent connections will cause your problems . If there is a broken bridge in the battery it will give the same indication ( have a load test done on the battery to eliminate it from the possible problems). Run the fault codes and if there is a problem in the ECM /TCM or wiring there will be a code to indicate that.

1996 Dodge... | Answered on May 28, 2014


Check/clean AIS< IAC motor. AIS= automatic idle speed.
IAC= Idle Air Control . Same part, different names.

1996 Dodge... | Answered on Mar 12, 2014


buy one of them ready made wiring plugs for this model ,one should have come with the new radio

1996 Dodge... | Answered on Dec 20, 2013


Check the fuse for the injectors, some vehicles have the injectors and coil running on the same circut, at the same time check the fuse for the ignition.

1996 Dodge... | Answered on Dec 04, 2013


You have a fuel issue problem. Either a fuse, a relay or a failed fuel pump.

1996 Dodge... | Answered on Nov 04, 2013

Not finding what you are looking for?
1996 Dodge Avenger Logo

266 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Dodge Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Avenger Dodge

  • Avenger Dodge

Most Popular Question

transmission slipping

  • Cars & Trucks
Loading...