20 Most Recent 1997 Chevrolet Camaro Questions & Answers


WHAT ENGINE DO YOU HAVE IN YOUR CAR?

1997 Chevrolet... | Answered on Jan 21, 2019


Anti-theft system problem . You changed the ignition lock cylinder an key ?????
The PASS-Key II® system is designed to prevent the engine from starting if the proper resistance is not sensed from the ignition key. Of the 15 key codes or resistance values available, only one will work with each BCM. Once the key code is programmed into the BCM, the resistance value is stored in a non-volatile memory.
Did your old key have a resistor pellet on the side ?

1997 Chevrolet... | Answered on Mar 02, 2018


Indeed yes Rob McConnell,

1997 does have the resistor (VATS) key...
(a POPULAR topic = problematic system
9in my opinion)).

Obviously you know... YES... trying the
"spare" key could help... or the dirt on the
contacts just inside the keyway needs to
be disturbed JUST enough to allow for a
decent contact...

Always look at the key that it is dry and clean.

If you have a crisp new dollar bill... and can
fold the corner into a point...

GENTLY Insert that into the keyway sufficiently
to wipe the interior of those contacts...

If your "CHIP" key has any contact left...
that should be enough to get the security light
out of your way...

Carnac the Magnificent

1997 Chevrolet... | Answered on Feb 08, 2018


It has second gear start. To activate and provide extra traction when pulling out of snow and muddy ground. z28 have positive traction rears.

1997 Chevrolet... | Answered on Jan 07, 2018


Factory service information has a diagnostic procedure for thing's to check . Hooking up a factory scan tool (tech2) would be the first step ,Checking for DTC'S - diagnostic trouble code's
DTC P1661 Malfunction Indicator Lamp (MIL) Control Circuit
A voltage is supplied directly to the malfunction indicator lamp (MIL). The powertrain control module (PCM) controls the lamp by grounding the control circuit via an internal switch called a driver. The primary function of the driver is to supply the ground for the component being controlled. Each driver has a fault line which is monitored by the PCM. When the PCM is commanding a component ON, the voltage of the control circuit should be near 0 volts. When the PCM is commanding the control circuit to a component OFF, the voltage potential of the circuit should be near battery voltage. If the fault detection circuit senses a voltage other than what is expected, the fault line status will change causing the DTC to set.
Perform the Powertrain On-Board Diagnostic System Check first, when the following conditions are present:
• When the MIL does not turn ON when the the ignition switch is turned to the RUN position

Malfunction Indicator Lamp (MIL) Inoperative
Circuit Description
There should be a steady MIL with the ignition ON and the engine not running. Ignition feed voltage is supplied directly to the MIL bulb. The Powertrain Control Module (PCM) turns the MIL ON by grounding the MIL control circuit. No MIL with the key ON, engine not running and DTC P1641 set suggests an open in the MIL control circuit.

The diagnostic procedure for this is 17 step's . , the basic thing's checking B+ voltage at the connector for the IPC , checking the control circuit at the PCM connector , using the scan tool to check for bidirectional control of the MIL lamp . Checking wiring circuit for the control circuit . Disconnect the PCM connector that has control side wire for the MIL an ground it an see if the light lights . If it does ,replace the PCM . Check for open wire . ETC........
Check the MIL control circuit for an open.
If the MIL control circuit is open, repair as necessary. Refer to Wiring Repairs .

Finding wire diagrams would be a big help to you .

1997 Chevrolet... | Answered on Nov 10, 2017


Wow, you replaced the injector and computer? The two least likely and most expensive parts first? A compression and leakdown test should have come right after plugs, wires and ign coil.

1997 Chevrolet... | Answered on Jul 19, 2017


code p 1870 refers to transmission component slipping
the transmission may need clutch and band adjustment or a pump pressure test check as it may not be producing enough pressure to keep components in place

1997 Chevrolet... | Answered on Jul 13, 2017


Take it back two the garage you have the work done it's still under warranty

I’m happy to help further over the phone at https://www.6ya.com/expert/john_d44605e901cfe245

1997 Chevrolet... | Answered on May 02, 2017


50 miles reduction in the conditions mentioned means that your economy is about right
there is a small hose back from the tank to under the cap to release air trapped when filling
koses can get loose , crack or break
tank sender units gaskets can break down
look around the tank area for the leak /smell
a damp patch in the dust is a good give away

1997 Chevrolet... | Answered on Apr 29, 2017


A flashing check engine light indicates active engine misfire. There should be codes set for these conditions. It could be low fuel pressure, but if you have not replaced the spark plugs and wires, I would look there. Failed ignition coils or ignition module can be culprits. Also plugged exhaust (catalytic converters) could be to blame as well. To test the catalytic converters, remove the oxygen sensors between the engine and converters and go for a drive. You can also unbolt the converters and run open exhaust. It will be loud, but if performance improves and normalizes, your exhaust is plugged and you will need to replace the converters.

1997 Chevrolet... | Answered on Mar 07, 2017


You need to add a can of B&G 44K fuel additive with a tank 91 octane . This additive is the best on the market and is only available at dealerships. It will condition your fuel pump and injectors. Your problem sounds fuel related so try this first. Next cheapest will be the throttle position sensor (TPS) and the next cheapest will be Manifold absolute pressure (MAP) . Stay on 91 octane, good luck

1997 Chevrolet... | Answered on Feb 28, 2017


The fuel pump relay is mounted behind the driver-side kick panel/dead pedal (driver-side left foot rest). Do you know where this is ?

1997 Chevrolet... | Answered on Feb 24, 2017


sounds to me you have a gounding problem with the lights in the back. ck the bulbs to see if they are in good shape no rust and such. than ck the wiring in the back and see if you find where they are getting the for the light at

1997 Chevrolet... | Answered on Dec 17, 2016


What is liter size of engine. There is a difference between the 3.8L and 5.7L engines.

1997 Chevrolet... | Answered on Sep 17, 2016


Check for spark. Ignition modules can do this, as can bad coil.

1997 Chevrolet... | Answered on Aug 15, 2016

Not finding what you are looking for?
1997 Chevrolet Camaro Logo

456 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Camaro Chevrolet

  • Camaro Chevrolet

Most Popular Question

1997 camaro rs v6 fuel pump relay

  • Cars & Trucks
Loading...