20 Most Recent 1999 Chevrolet Tahoe - Page 4 Questions & Answers


no It will not cause a no start, it will cause a ses light.

1999 Chevrolet... | Answered on Mar 07, 2015


Just a thought...if you just replaced a booster, you may have forgotten the brake switch or not connected it completely.

1999 Chevrolet... | Answered on Mar 06, 2015


try to artificially enrichen it while cranking to see if it starts...if it does, look for fuel issue

1999 Chevrolet... | Answered on Feb 03, 2015


you must put this back in same exact place it will through a code,dont remove old distributer untill you set crank to tdc and mark the dist where it pulls out.that way you can make sure to put back same spot,if throughs a check engine light you will have to do it again.

1999 Chevrolet... | Answered on Feb 03, 2015


96 to 99.. Vortec,,,, or any 350 short block,,, use you vortec heads

1999 Chevrolet... | Answered on Feb 02, 2015


I believe in 97 they started the vortec 350 and they ran until 2001 not real sure but any salvage yard will know what years will fit. there are also different engine codes I think they are W and Z that will make alot of difference in the computer.

1999 Chevrolet... | Answered on Feb 02, 2015


USUALLY, the red is the hot wire.

1999 Chevrolet... | Answered on Jan 21, 2015


check oil pressure sending unit

1999 Chevrolet... | Answered on Jan 04, 2015


It is not that easy. There are a lot of things that can keep a modern vehicle from starting. Check the neutral switch, the crank sensor, the fuel pump, the fuses, the temp sensor etc. You should see if you can get a scan tool to check the codes. That would narrow down the list of possibilities.

1999 Chevrolet... | Answered on Jan 01, 2015


Loretta,, Occasionally, a spark plug is "bad" right out of the box. But a single new plug and install it in the #1 cylinder. Also, on a 15 year old vehicle, it is likely that the spark plug wire wa damaged removing it in order to replace the plug. Good Luck.

1999 Chevrolet... | Answered on Dec 28, 2014


Have you replaced the heater core? If not, most likely the reason the previous owner bypassed the heater core was because it leaked. I will be happy to send you photos of how the hoses attach but I will need your email address.

1999 Chevrolet... | Answered on Dec 22, 2014


Have you checked fuel pressure ?

1999 Chevrolet... | Answered on Dec 22, 2014


no it will not cause a misfire it just will not start

1999 Chevrolet... | Answered on Dec 12, 2014


And I hope you replaced the filter too, :)

Off hand I would ask if any trouble codes popped up like multi-Misfire
or engine code's of P0300- P0308, "no spake at plugs or a misfire at plugs.?" You might need a ignition control modular, "MIGHT" for some reason there's usually not a code for the ICM but you would get misfires since you lose spark to the plugs..

if your ignition control modular is inside the distributor cap and you decide to have it checked auto part stores can check it out of the truck, BUT I would add a new on IF your getting codes of P0300-308 since they run hot, and if you do replace it get the heat sink grease for the bottom of it to help keep it cool, They get Really hot..

Just my thought.

1999 Chevrolet... | Answered on Dec 09, 2014

Not finding what you are looking for?
1999 Chevrolet Tahoe Logo

1,419 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Tahoe Chevrolet

  • Tahoe Chevrolet

Most Popular Question

1999 tyahoe hood latch cable doesnt work

  • Cars & Trucks
Loading...