20 Most Recent 1986 Chevrolet Celebrity Questions & Answers

Start by getting a multimeter with a current coil clamp. Put around one battery cable and measure current leaking out.

Even after two years, you could have a bad battery

1986 Chevrolet... | Answered on Mar 02, 2018

replace the master cylinder
flush out the system

1986 Chevrolet... | Answered on Sep 24, 2017

What your doing when you touch the test light to that 3rd wire is actually closing the circuit and powering the fan, like the temperature controlled switch should be doing once the engine warms. That sending unit would be screwed into the cooling system where the water can touch it and most likely is in the radiator lower tank or bottom of radiator side tank. Find that sensor and test the wires for power when engine is hot and fan should be on. You could put a toggle switch on it to activate the fan until you get the proper sending unit/sensor.

1986 Chevrolet... | Answered on Jul 11, 2017

Why would you want to by-pass anything to start your car?

1986 Chevrolet... | Answered on Apr 26, 2015

If your talking about the hearts lines that come off the master cylinder you won't find it you have to make it yourself. You have to buy a line from any parts store and cut and bend it to your needs. I always reuse the end connectors if they're in good condition to get a good seal sometimes the replacement ends don't seal properly and leak. Good luck

1986 Chevrolet... | Answered on Apr 16, 2015

Easier from under the car

1986 Chevrolet... | Answered on May 08, 2014

ignition will trigger if signal from crank sensor, with hei spark plug tester ,read to coil wire and spark plugs wire if spark , depends wich engine
if c3i coil and module the module could be the problems you can check it before replace
hope it helps

1986 Chevrolet... | Answered on Mar 30, 2014

That Clicking is the Battery causing it not to Start. You need to Replace that Battery or at Least put a Charger on it for a Couple of hours to see if you can Salvage it for a While.

1986 Chevrolet... | Answered on Jan 11, 2014

Most common indicators are. Wheel alignment ( not enough Castor adjustment) worn tie rod end/s Incorrect size tyres ( you have to have the rim sizes the same on both sides ) even though you noticed a difference Loose steering box / rack or worn rack mount rubbers Probably the noise under the floor as the rack is bashed up and down from the wobble. What you describe is castor wobble and some makers recommend 0 castor when in fact the setting should be 1/2 to 1 1/2 degree positive.

1986 Chevrolet... | Answered on Jun 05, 2013

What is your question ?

1986 Chevrolet... | Answered on Jan 08, 2013

Click here to see how to remove.Here's some new ones.

1986 Chevrolet... | Answered on Dec 22, 2012

Not finding what you are looking for?
Cars & Trucks Logo

92 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Celebrity Chevrolet

  • Celebrity Chevrolet

Most Popular Question

purchase metric brake lines 1986 chevy

  • Cars & Trucks