20 Most Recent
2003 Buick Century Questions & Answers
1 Answer
How to change the rear lights on a 2003 Buick Century.
yes you will you will have to take side trims and sill panel off get a 10 mm ready and take the bolts out the tail liaghts should come out the license lamps have screws in them and if you looka t them but you should be able to twist bulbs and pull them out / Please rate my response thank you very much
2003 Buick...
|
Answered
on Mar 06, 2019
1 Answer
2003 Buick century reset button in fuse box what is it for
Using the RESET button
- Adjust all tire pressures to the recommended kPa/psi.
- Turn ON the ignition, with the engine OFF.
- Press and hold the red RESET button located in the passenger side instrument panel fuse block.
- The LOW TIRE indicator will flash 3 times, then turn off.
- Use the scan tool in order to clear the TPM DTC.
2003 Buick...
|
Answered
on Mar 04, 2018
1 Answer
2003 Buick Century
I know there's a code where you can turn the key X number of times, or something like that ??????? No it can't , you need to take it to a qualified repair shop.
Dodge , chrysler , jeep vehicles you can turn the key on - off - on - off - on three times an they show a coded in the odometer section of the instrument cluster . GM vehicles you need to plug in a scan tool .
Your best bet , take it to a qualified repair shop.
2003 Buick...
|
Answered
on Feb 24, 2018
1 Answer
LIGHT ON PRNDL OUT ON DASH
This requires lamp replacement - and that means pulling the instrument cluster. I have done this on several cars, it has been easier than one may think. Read up or look for YouTube video for your car. Given the age and one has failed, pretty shortly all will statistically - so replace the rest. This repair takes me about 30 minutes - you may want to leave this to a shop mechanic.
2003 Buick...
|
Answered
on Feb 21, 2018
5 Answers
Buick Century 2003 service engine soon light
My service engine light was caused by a cloged passage from my EGR valve. Mine is a 3.1 with fuel injection 2003. All I needed to do was pull the two bolts over the intake plenum and remove the vacuum connection to the PCV valve. Then clean out the EGR port just below the vacuum connection in the throttle port. I would remove the rubber intake to vacuum it out. The carbon was like rock in there. Service engine light cleared on its own.
Dave
2003 Buick...
|
Answered
on Sep 09, 2017
Not finding what you are looking for?
