20 Most Recent
1993 Ford Probe Questions & Answers
1 Answer
How do I remove 93 ford probe intake manifold
2.0 or 2.5?
here is 2.0
if you need more just let me know
- Disconnect battery ground cable, then isolate cable end with electrical tape or equivalent.
- Remove air intake system and fuel line mounting bracket.
- Disconnect throttle cable.
- Disconnect coolant line from idle air bypass air valve.
- Disconnect coolant and vacuum lines from throttle body. Mark vacuum lines for installation reference.
- Disconnect throttle position sensor connector.
- On models with automatic transaxle, disconnect idle switch connector.
- Disconnect brake booster vacuum line from back lefthand side of intake manifold.
- Disconnect EGR temperature sensor connector, if equipped.
- Disconnect speed control vacuum line from back righthand side of intake manifold.
- Disconnect EGR solenoid connectors.
- Remove PCV valve from cylinder head cover.
- Raise and support vehicle.
- Remove intake manifold support bracket, then the EGR pipe from intake manifold.
- Lower vehicle and remove intake manifold attaching bolts and nuts.
- Remove intake manifold and discard gasket.
Intake Manifold Tightening Sequence
- Reverse procedure to install. Torque bolts and nuts in sequence to 14-19 ft lb.
My name is Tim and I work for a company called AutoEcu1 We specialize in many different controllers such as abs ebcm ecu ecm tcu tcm climate controllers dash clusters speedometers and so much more. If you need further assistance on this or any other vehicle please post here or call us at 800 921 9060 good luck!
Regards,
-Tim
1993 Ford Probe
|
Answered
on Jan 09, 2015
1 Answer
Replace the heater core in a 93 ford probe
You may google it, or you can pick up a haynes or chilton manual for cheap. Alldata and mitchell are great sources, but cost money. Check your local library or college, they may have alldata or mitchell subscribed and free to use. Our library does. Those programs are the same that repair facilities and dealerships use (I also use those).
1993 Ford Probe
|
Answered
on Nov 28, 2014
2 Answers
I have a 95 ford probe gt 5 speed, when i connetc
maybe a bad horn relay.
Section 18-01: Wiring and Circuit Protection
1996 Probe Workshop Manual
REMOVAL AND INSTALLATION
Relays
The following illustrations show the locations of the various relays on the vehicle.
The Location of the Starter Relay, Main Relay, Circuit (Fuel Pump) Relay, Turn Signal Lamp Relay, Horn Relay, Daytime Running Lamp (DRL) Relay (Canada Only), A/C Relay, Headlamp Relay, and Fog Lamp Relay
1993 Ford Probe
|
Answered
on Apr 25, 2014
Not finding what you are looking for?
