20 Most Recent 2001 Ford Windstar - Page 7 Questions & Answers


C codes are ABS/brake system. but yours isn't a code. Your brakes will still stop you, just don't have the anti lock part.

2001 Ford... | Answered on Jul 12, 2015


Usually a quarter of a tank. So according to your tank size and the mileage you get it would vary .

2001 Ford... | Answered on Jun 15, 2015


could be anything,water in tranny fluid,water in power steering fluid,water in oil,water in alternator,water in wiring,why drive through water???

2001 Ford... | Answered on Jun 11, 2015


You need to STOP DRIVING THE VEHICL AND GET THE ENGINE CHECKED. If any water has entered the engine you will destroy it by using it, this could be very costly indeed if you ignore the warning. Engines work by comressing fuel/air misture, water cannot be compressed, it will destroy the innards of your engine
SEE A GOOD MECHANIC ASAP WITHOUT DRIVING THE VEHICL


Good Luck

2001 Ford... | Answered on Jun 11, 2015


Is the check engine light on? I really need more info on your veh. Eng. size, etc. You might have a look at the cold air intake tube, It could have a crack in it or be loose where it mounts to throttle body or air cleaner( could be drawing cold air in where it's not suppose to)If you can get me more details we can get to the bottom of your troubles, Hope this helps, Randy 6/2/15 Hi Shannon, Ok you had it checked and they said it was a sensor, If you can get me that code# we may be able to get to the bottom of your problem. Also just a little advise, I have been a mechanic for 40 years when it comes to Drivability Problems(check engine light) Please don't take your vehicle to AutoZone or any other "PARTS" store that calms to be able to diagnose your check engine light, Remember what they do, they sell parts....95% of the time the check engine light comes on is because of a emission related problem, meaning fuel related, ignition related, timing related. And some of these can be extremely costly to your engine, RE: Catastrophic engine failure. 1 injector or even a coil on plug going bad can destroy your engine, The auto parts store don't have the knowledge or tech. training to diagnose Drivability problems. They will read codes with a code reader not a scanner and then give you a piece of paper on how to repair it. Drivability techs spend yrs of training and money to diagnose these problems in todays cars. Just a little piece of mind take it to an expert.

I’m happy to assist further over the phone at https://www.6ya.com/expert/randall_d932ef6e01588b0f

2001 Ford... | Answered on Jun 02, 2015


This is a special nut because it's deformed to retain torque. It's also a one-time use nut. I beleive it is 170-203 ft. lbs, good-day !

2001 Ford... | Answered on Jun 02, 2015


buy one either online or at an autoparts store

2001 Ford... | Answered on May 29, 2015


who fitted it, needs to be done by a proper mechanic or you could lose a wheel whilst driving. After it was fitted the retaining nut should have ben tightened fully home so that it could not have been tightened any more, then the nut should have ben undone/loosened slightly and torqued to the appropriate value. Then a split pin, if there is provision for one, should be fitted.
If you do not have proper tools take it to a mechanic to do the remedial work, it could be hazardous to yourself and family and also other road users.
Good Luck

2001 Ford... | Answered on May 29, 2015


How do you know the hose came off? These hoses don't normally become disconnected

2001 Ford... | Answered on May 22, 2015


Go ovr ur work again..some wire or ground. Switch maybe tu. U can always take bulb out

2001 Ford... | Answered on May 22, 2015


What codes did you get ? If there where codes any codes ! You need to have the problem fixed ,that's how you reset the anti-theft system !

2001 Ford... | Answered on May 20, 2015


the light sensor,take it to a ford dealer

2001 Ford... | Answered on May 11, 2015


Seeing how these components are all controlled by the ( FEM ) Front electronic module I would start with checking power an grounds to this module. Or better still take it to a ASE certified repair facility where they have the diagnostic tools to check the electronics !

2001 Ford... | Answered on May 08, 2015


There is a problem detected within the security system by the security module. Try locking and unlocking the door with the key fob to reset the system. Sometimes locking and unlocking the drivers door using the key will reset the system as well. If still no luck, try the spare key to see if the security system accepts it

2001 Ford... | Answered on May 02, 2015


The codes are on the internet

Lots of vehicle info there

Type:OBD PO171

Codes have nothing to do with replacing any parts

Only parts that are tested & fail- get replaced- if they are
the problem with the system fault

2001 Ford... | Answered on May 01, 2015


OK, if there is no fluid coming out of the nozzle when you hit the button for it, then it's because the pump motor is burnt out, or the wiring to it is discontinuous.

Look for the pump motor in or around the reservoir for the windshield wiper fluid, where you add i; below it.

2001 Ford... | Answered on Apr 21, 2015

Not finding what you are looking for?
2001 Ford Windstar Logo

2,719 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1998 Ford Windstar
1998 Ford Windstar

1,797 Questions

2000 Ford Windstar
2000 Ford Windstar

1,464 Questions

1999 Ford Windstar
1999 Ford Windstar

1,185 Questions

2003 Ford Windstar
2003 Ford Windstar

996 Questions

1996 Ford Windstar
1996 Ford Windstar

582 Questions

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Windstar Ford

  • Windstar Ford

Most Popular Question

rest 2001 ford windstar after having

  • Cars & Trucks
Loading...