1998 Toyota Avalon - Page 9 - Answered Questions & Fixed issues


5a3e593.gif


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

1998 Toyota... | Answered on Mar 01, 2010 | 1,528 views


As lon as the weight is off the engine mounts you should be able to change them with no problems. please rate this and good luck

1998 Toyota... | Answered on Feb 23, 2010 | 136 views


engine mounting !!!

1998 Toyota... | Answered on Feb 23, 2010 | 49 views


Should be Headlight Bulb #9006 and will cost about $20 per bulb.


Look on the back of the headlamp remove the plug, remove the boot and you will see a clip holding in the light bulb.

Unhook the clip the bulb will come out with a little force.

Don't touch the glass on the new bulb re-install.

Hope this tip helps.

R/
David

1998 Toyota... | Answered on Feb 12, 2010 | 73 views


11 ft lbs(lower plenum) 32 ft lbs(upper plenum)

1998 Toyota... | Answered on Jan 28, 2010 | 747 views


check the lowbeam fuse

1998 Toyota... | Answered on Jan 26, 2010 | 113 views


disable alarm on 96 avalon

1998 Toyota... | Answered on Aug 26, 2016 | 4,756 views


The electric motor under the seat has worn out. Try to find you one from this web site car-part.com

1998 Toyota... | Answered on Jan 16, 2010 | 125 views


v6 's is by the frot crank shaft area & 4 cyl engines are on the blocks mid way lower area near the oil pan

1998 Toyota... | Answered on Jan 14, 2010 | 2,063 views


Why was fuel pump replaced? History? What did you test and what are the results of thoses tests.

1998 Toyota... | Answered on Dec 31, 2009 | 67 views


The key here is how large are the people being put in the rear seats and what is also in the front seats.

My weight is 330 pounds, I had a 1999 Avalon XLS and I made several trips from Southern Oregon to Seattle Washington ( about 500 miles ) and it was important that I consider the arrangement of all five folks in my car.

Obviously it will float higher with five ladies weighing 125 pounds each, but heading toward the other extreme is where you need to be cautious and calculating.

Best of luck,

Jim

ps.. I loved my Avalon, keep the faith with yours.

1998 Toyota... | Answered on Dec 21, 2009 | 63 views


when you disarm the alarm make sure you hear a beep beep sound twice before you try to start the car.

1998 Toyota... | Answered on Dec 21, 2009 | 351 views


its the only bigger round thing in the fuse box

1998 Toyota... | Answered on Dec 10, 2009 | 194 views


If the blinker and reverse lights work on the bad side maybe a new socket.

1998 Toyota... | Answered on Dec 03, 2009 | 228 views


it may be that you your brake fluid is low. the only thing that the brake light indicates is when the parking brake is engaged or when the brake fluid is low. but im about 99% sure its gonna be the brake fluid.

1998 Toyota... | Answered on Nov 18, 2009 | 1,219 views


check the oil, take in and have a computer scan done.

1998 Toyota... | Answered on Nov 17, 2009 | 180 views


You need heavy duty equipment for this. A 10 ton press or a 300 dollar hub shark tool.

1998 Toyota... | Answered on Nov 15, 2009 | 140 views


As far as going into gear you have an override switch on the console of the trans to push and get out of park. Check your brake lights. If they aren't working the brake light switch controls the shift interlock solenoid. Fis it and you can now shift.

1998 Toyota... | Answered on Nov 15, 2009 | 375 views


i know on some toyotas, you do not need to remove the door panel just the handle where the switch assembly is located...if the panel around the switches is plastic then pry GENTLY up on the plastic to dislodge it from the door handle and inspect connections there...if everything checks out fine, then check fuses...perhaps this was a problem for so long that the window motor finally blew a fuse. if so replace both fuse and motor...if fuses okay, then with a long screw driver locate any screws under the door handle, bottom of the door panel, mirror panel etc, and remove...then gently pry outwards on door panel until it is released. disconnect your harness at the window motor and hook in a test light and operate the switch..if light illuminates, replace motor..if not, then replace switch or switch panel..which ever/.

1998 Toyota... | Answered on Nov 14, 2009 | 859 views


Slippiung transmission
1. Check the resistance on the direct clutch speed sensor. 560 -680 ohms should be present.

2. Monitor the wave form pattern on the direct clutch speed sensor at the Engine Control Module (ECM) for a good wave form and no cutouts on the signal.

3. Check the fluid and the transmission condition. Check for slight slippage of the transmission.

1998 Toyota... | Answered on Nov 03, 2009 | 1,061 views

Not finding what you are looking for?
1998 Toyota Avalon Logo

586 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Toyota Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...