20 Most Recent
2006 Toyota Corolla Questions & Answers
1 Answer
The open door warning light indicator does not go off .
There is a problem with the door switch the door is not pushing the switch in completely. Here is what you do close all the doors, then you open them one at a time with all the other still closed. start with the drivers door. open and look for the pin with that the door touches when you close its on the bottom close to the back of the driver's seat it has a black rubber covering it. Press with your thumb in and see if light goes out. Check all other doors in the same way you will see which door switch is not being pressed in completely when door closes. If you find it a quick fix is to pad the area on the door that makes contact with the switch to push it in, for example you can use one of those round sticky cushions that you use on the metal chair legs to prevent them from scratching your wood floor. However if you can solve the problem in this way you may have to take it to electrical mechanic or I will be able to provide more help. contact me and leave me a feedback. Good LUCK
2006 Toyota...
|
Answered
on Apr 23, 2019
1 Answer
Driving at 70 mpr at 2300hrs my 2006 corolla
Check all the fuses located in the lower panel of the dash board on the passenger side with a test light 12V or multimeter. Ground one end of the tester to good known ground and the tip to each side of every fuse one by one. If the tester light glows that particular fuse under test is OK. If not, that fuse is burnt. Replace it with the same rating of new fuse and you are good to go.
2006 Toyota...
|
Answered
on Feb 09, 2018
1 Answer
I have a 2009 toyota
Sure I will tell you how to get away from those annoying beeps I know what you're talking about it's very easy what you want to do is get on YouTube and type in Toyota Camry how to disable the beeps on my keyless entry and once you do that you can just press it and your doors will lock without the annoying beat you can also check with the dealer and they will teach you for free how to do that I hope my answer has helped
2006 Toyota...
|
Answered
on Feb 06, 2018
1 Answer
Idle speed
Sounds like possible Idle Speed Control (ISC) issue. Start by having computer codes read by dealer or other facility.
2006 Toyota...
|
Answered
on Jan 09, 2018
1 Answer
2006 corolla- check engine light comes on. i
Open hood ensure new battery is disconnected.
Open main fuse panel cover under hood and remove horn relay (so you don't have to listen to the horn).
Use the key to lock the drivers door.
Connect the positive battery terminal.
Connect the negative battery terminal (security system will now activate, hazards lights will flash and horn would be going off if the relay was not removed).
Use the key to unlock the drivers door.
Get in, close drivers door.
Use the key to start the engine.
Security system will deactivate.
Get out of vehicle, reinstall horn relay, replace fuse panel cover, close hood.
2006 Toyota...
|
Answered
on Jan 05, 2018
1 Answer
2006 Corolla. Codes P2716, PO121,
check the cable adjustment for codes p 0121 before spending money on position sensors
the pressure (TFP) will fix the transmission problem
P0607 is the control module
however before getting a replacement ECM check for wires and connections
check for moisture and/or dirty pins in the connections
I would go for good replacement parts from a wreckers/junk yard rather than new parts to save money or have an accredited service shop check the components first
2006 Toyota...
|
Answered
on Oct 18, 2017
Not finding what you are looking for?
