Question about Mitsubishi Cars & Trucks

1 Answer

I have a 1995 Mitsubishi 3000 SL, that the alarms keeps going off and when I try to use the key on any of the doors to disarm it, the key doesn't go left or right, it is stuck and doesn't allo

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Mitsubishi Master
  • 471 Answers

I would take it back to the place where the alarm was installed or a dealer that installs that brand of alarm for proper diagnosis.

Posted on Apr 10, 2017

Ad

5 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
alicantecoli

Colin Stickland

  • 22485 Answers

SOURCE: new battery, can't reset alarm

remove the alarm,their might be a passive switch on the alarm to turn it off with a special key,if you dont have the key break the lock so you can turn it off or try to open case of alarm and look at wires and then dertimine which ones to join or break,every alarm inside is different so you will have to work it out.

Posted on Nov 28, 2008

kevin bulsara

  • 234 Answers

SOURCE: How do I disarm a 1995 Mitsubishi Galant alarm

to re set i think u remove wires from battwey put live wires to negative for about a minute the then replace

Posted on Aug 06, 2009

roniecon

Ronny Bennett Sr.

  • 6927 Answers

SOURCE: how do you re-link the key fob to the car after

Try this,,turn the key on ,wait 10 minutes,then turn the key off,then right back on,do this three times,a total of 30 minutes,this should reset the key fob,if this is the problem.

Posted on Apr 17, 2010

cansmo

Reynaldo Andico

  • 2431 Answers

SOURCE: i replaced my remote battery

If you need to be that close to the car to start , you still have a bad to low battery.,You notice that you had to get close to it.If you are sure absolutly have a new battery enter the car put key in regular position leave key in for 2 minutes cylce it off there see if it will start back in it normal range.

Posted on Apr 26, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Alarm system on outtr 4door 1995 jeep grand cherokee will not disarm we have tried locking and unlocking but that doesn't work, what else can we do


Hi Eileen, Sounds to me as if the unit has lost its coding. that will mean getting it re-coded. Contact your service shop and explain the problem to them. There very well may be a way of resetting the system by a series of on off twists of the key. Regards John

Nov 16, 2012 | Cars & Trucks

1 Answer

Disabling alarm system on 2000 mitsubishi mirage


this is a long shot, put the key in the driver door, turn to unlock then try to start the car, some systems disarm when the key is used to unlock the car.

Jul 05, 2012 | 2000 Mitsubishi Mirage

3 Answers

How to permanently disarm alarm on 1995 Jeep Grand Cherokee Laredo


#1 solution for this is to " BUY A GM PRODUCT" & save your money on costly repairs of these chrysler & JEEP (amc) vehicles!

Apr 25, 2012 | 1995 Jeep Grand Cherokee

2 Answers

I have a 2003 hyundai sonata and i dont have the remote for the stock alarm. My alarm keeps going off and my car wont start. I bought a new battery and even tried the key in the door still no luck.....


The 2003 Sonata is equipped with a 'starter KILL' burglar alarm system with disables the starting system (using a N/C 'contacts' configuration instead of a N/O contacts configuration). N/C=Normally closed, and N/O=Normally open contacts. When the alarm goes off with a MY Sonata, the only way to DISARM it is with the key fob (remote) originally programmed for it (unless you purchase a new remote & have it programmed for the vehicle at an authorized Hyundai Service Department). NOTE: So long as the keyless entry & burglar alarm system is functioning/operating normally, the alarm will keep going off and the STARTER KILL function will still prevent you from starting the vehicle. One option is left without purchasing a new remote and having it programmed.
1. When the alarm goes off, get into the vehicle and insert the ignition key into the ignition.
2. Turn the key to the 'RUN' position (NOT the ACC position) and wait for the alarm to STOP (usually about 3 to 5 minutes).
3. The engine should then start using the ignition key.

If this procedure doesn't work, the problem will need further diagnosis by a qualified/certified Hyundai Service Technician.

Hope this helps

Aug 27, 2011 | 2003 Hyundai Sonata

2 Answers

HELP please!! My daughter has a 96 sebring convertible and today she put her key in the door to unlock it and the alarm started going off. It wont stop, have disconnected the positive and negative battery...


Just a quick note once you hook the battery back up try locking it and unlocking it from the drivers door, if that fails you might try the passenger door. I know on some chrysler products you have to lock and lock again to arm and unlock to disarm. I hope this helps.
Thanks,
Joey

Sep 05, 2010 | 1998 Chrysler Sebring

2 Answers

How can i disarm the factory security alarm.i have tried the key locks. i have no remote with the car. i didnt know it had an alarm when i bought it . 1995 chrysler cirrus


Here is what I do on my 95 Cirrus I also do not have a keyless remote (well I do but is broke) and after frustation after frustation trying to disarm the factory alarm I find out that by unlocking the passenger front door with the ignition key from the outside will disarm it you may have to try few times before it's disarmed you need to make sure that the blinking red light stops blinking and all of the locks on all 4 door are up or unlocked, this is what I been doing for 3 years now and that's how I disarm the alarm on my car, I hope this helps.

May 15, 2010 | 1995 Chrysler Cirrus

1 Answer

Car will not crank


go under driver side of dash find after market box may have alarm name on it probably just stuffed upped under dash unhook wires tape as nec there is two heavy wires yellow or white may bee cut nec to re solder & tape car should crank & start

Aug 30, 2009 | 1995 Buick Riviera

1 Answer

How do I disarm a 1995 Mitsubishi Galant alarm


to re set i think u remove wires from battwey put live wires to negative for about a minute the then replace

Aug 06, 2009 | 1999 Mitsubishi Galant

3 Answers

1999 JEEP GRAND CHEROKEE LAREDO


i have a 95 jeep grand cherokee lerado from time to time my alarm goes off i dont have a remote 4 my alarm but i found out that if you put the key in the driver door and unlock it. it will reset the alarm!!!!!

Nov 19, 2008 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...