Question about Cadillac STS

Open Question

Rss c0662 service stability system comes on and the code of rss c0622

Posted by Anonymous on


6 Suggested Answers


6ya staff

  • 2 Answers


Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017



  • 20 Answers

SOURCE: service stability system

one of the four load stability sensors (one at each wheel suspention arm) has gone awry. Computer diagnostics (Advanced scan tool) will tell you which one. Suggest replace both on front or both on rear (whichever the case)

Posted on Jul 04, 2008


paul nowicki

  • 541 Answers

SOURCE: service stablization system light intermittently

it is saying you have bad stuts. you need to have it scanned to see which ones are bad.

Posted on Dec 30, 2009

Testimonial: "Thanks, solves the mystery"


  • 131 Answers

SOURCE: servicing stability system

traction control/stability control is usually part of the abs(anti-lock brake system) system without a scanner it would be almost impossible to diagnose if your not firmiliar with abs and the way it works take it to a shop

Posted on Feb 24, 2010


  • 90 Answers

SOURCE: Service stability system message appears

i believe your vehicle has air ride suspension in addition to coil springs. i would check the lines that run from the air pump to the air bags. they will black lines that are located near each strut and will go to a pump that is located somewhere iether underneath the vehicle or inside a fender.

Posted on Mar 23, 2010

Jonah Oneal

  • 14092 Answers

SOURCE: "Service stability system" message come


Posted on Mar 08, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What would make my service abs system,service brake system,service traction system,service stability system come on with the ecu/ccu malfunction code c0550

You have to realize that your wheel speed sensor is what tells all of these systems what each wheel is doing, I would think one of these would be the problem, but without putting it on a computer you can't know which one.

Jul 26, 2014 | Cars & Trucks

1 Answer

Electronic stability failure

When this message comes on: electronic stability failure contact service it means there's a trouble code stored in the computer. Get the trouble codes read and then you'll have a starting point. Impossible to guess without the codes. See this post on stability control
How does electronic stability control work Ricks Free Auto Repair Advice

Dec 22, 2017 | Saab 9 3 Cars & Trucks

1 Answer

Stability system disabled light on no power

The stability system is software programmed into the ABS - antilock brake control module also the PCM - engine computer . service engine light DTC'S - diagnostic trouble codes stored . Your best bet , take it to a qualified repair shop or the dealer . You don't have the diagnostic equipment or knowledge to tackle this type of problem .

Jul 24, 2017 | 2003 GMC Yukon Denali

1 Answer

GMC Yukon XL the "Service Stability" light is on and I was out for the evening and could not get it to go past 30 without a drain on the system. I was about a mile away from home so I sat for 15 min a

The service stability light will come on if there is a problem detected in the stability control system. There will be a code stored for this problem. The code will tell the technician working on it where the problem is. You need to get in to have this looked at soon. Waiting too long can cause additional damage to components on the system, depending on what is wrong. The traction control and the stability control system are disabled with this light on so there may be some poor handling/performance noticed with this light on. BotXXXXX XXXXXne, the code needs to be read and then a solution to the problem will be known. The best advice that I can give you.
hope it helps

Feb 14, 2018 | 2005 GMC Yukon XL

1 Answer

Service stability system code is on where do i start

Stability System actively monitors the movement of the vehicle and can adjust the movement of the vehicle in cases where it determines the car is not moving correctly, as in sliding on ice or snow.The system incorporates signals from the wheel speed sensors, yaw rate sensor, and steering wheel position sensor to determine any corrective action. Any failure of any of these components will result in a "Service Stability System" message.

Dec 31, 2011 | 2001 Oldsmobile Aurora

1 Answer

"service stability system" is in the DIC, replaced

Sorry, but I do not understand what question you are asking. Can you please be clearer.

Jan 03, 2018 | 2008 Chevrolet Uplander

1 Answer

Service ride control light comes on. \r\nlow refrigerant

You first need to retrieve the codes.This can be done by pressing the off and warmer buttons simultaneously.When all the dash lights light up let go off the buttons.The on board system will start giving you all the codes that are on all the modules.First the pcm,ipc,acp,sir,tcs,and rss.Write down the codes for the rss module.It will also give you codes for the low freon.U sually a 46 or 47.The rss module codes will be so10 to so 80.Usually a bad strut.You can not get the ride control struts anymore.Even at the dealership.There is a bulletin for replacing these struts with regular struts and reprogramming the pcm.This has to be done with a scan tool from the dealership.If this is not reprogrammed the service ride control light will stay on after the replacement of the struts.Both front and rear have to be replaced.There is also a harness that has to be replaced.The freon code is usually a leak in the system which is usually the evaporator core and the compressor shaft seal.All of these jobs are costly repairs.Hope this helps.Let me know if you have any more questions.Good luck.

Nov 06, 2010 | 1995 Cadillac Eldorado

1 Answer

Service Stability System keeps coming on dash panel.

could be a issue with the stability system,,could be a bunch of diffrent things, you need to get the trouble code to know what it is,.rec take to dealer

Oct 12, 2009 | 2003 Cadillac CTS

1 Answer


I would bet that your issue is not caused by a fuse. The fact that the "Rear Sonar OFF" lamp is on and won't turn off means that the system is in fail-safe. The system has sefl-diagnosis capabilities and has found a fault.

To enter the self-diagnosis, turn the key off. Depress and hold the rear sonar switch and while holding it in, turn the key on. You will see the lamp flash and may hear a beep from the warning chime. Release the button and push and release 5 times within 10 seconds. You should see the lamp flash and another beep. Push and release the button one time. This will display fault codes that are stored in the system. For example, if a code 12 is stored, you will see 1 flash, followed by a pause and followed by 2 flashes. If there aren't any other faults stored, this will repeat.

I have seen code 12 most frequently, being that the warning chime has failed. If this is the case with your vehicle, you won't hear the beeps that I mentioned earlier, but only see the flashing of the lamp.

If this is the case, you will need to replace the chime. It is located under the cover between the steering wheel and the windshield. There is a "hood" that faces toward the steering wheel and behind that is a cover that is held down with spring-metal clips. Get a small screwdriver or panel "popper" under this cover and gently pry it up. The chime is a small speaker directly under that cover and is bolted down with 2- 5.5 mm bolts.

Once you have repaired the fault, the system will automatically reset the self-diagnosis memory.

If you have other codes, you may have an issue with one or more of the sensors located in the rear bumper. I, however, do not know those code numbers off the top of my head.

I hope that you have found this helpful!

Nissan Scope Technician- 10+ years experience in Nissan dealership.

Oct 27, 2008 | 2005 Nissan Quest

1 Answer

Service stability system

one of the four load stability sensors (one at each wheel suspention arm) has gone awry. Computer diagnostics (Advanced scan tool) will tell you which one. Suggest replace both on front or both on rear (whichever the case)

Jul 03, 2008 | 2002 Buick LeSabre

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

323 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts


Level 3 Expert

85222 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides