Question about 2009 Kia Rio

1 Answer

My 2009 turns over but won't start

I have change the plugs and the plurge valve

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

  • Expert
  • 158 Answers

Try charging your battery or replacing it.. if the problem is not solve.. diagnose your charging system if it still charges juice to the battery.

Posted on Sep 28, 2012

Ad

1 Suggested Answer

Anonymous

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Chevy Prizm or Toyota Corolla 2000 valve cover gasket problem? Right after oil change, engine check light came on & car started smoking & losing oil. I took out all 4 spark plugs: they were in very...


The valve cover gasket isn't hard to change. Oil on the plugs indicates a more serious problem. Smoke from the exhaust would be from rings, rich mixture, worn valve guides. It may be that the engine is overfull (that would show on the stick). Oil loss from a leaking gasket would smoke under the hood and leave oil on the engine and the ground.

Mar 25, 2011 | 2000 Chevrolet Prizm

1 Answer

My 1994 Chevy Silverado 5.7 has a rough idle and a small dead miss at an idle, I changed all filters, wires, plugs, changed distributor, cap and rotor, changed ignition coil, and still same...


This misfire could be an intake valve or exhaust valve stuck open. Remove spark plug, and use a fiber optic camera to look in the chambers to look at the valves. It could be a bent valve or badly worn edge of a valve or simply a build up of carbon debris. I own a 95 Jimmy with a V6 Vortec and it has the same problem with a miss. mine is a bad valve, I hope yours is something small, but I hope it helps anyhow.
D

Jan 06, 2011 | 1992 Chevrolet K1500

1 Answer

Recently had all plugs and EGR Valve changed.


firewall

4 - 8

3 - 7

2 - 6

1 - 5

front

The spark plug firing order is 1 - 3 - 7 - 2 - 6 - 5 - 4 - 8 Make sure the coil is good.

Jul 21, 2010 | 2000 Ford Expedition

2 Answers

Changed the spark plugs and the old ones were covered in oil


i'm guessing that your car is a 4-cylinder. this is common for inline 4-cylinder engines. since the spark plug holes usually go through the valve cover, the valve cover gasket will leak and collect in the spark plug holes. to fix this you will have to replace the valve cover gasket.

Mar 23, 2010 | 2000 Saturn SW2

3 Answers

I followed the firing order installing a dist cap on a 91 camaro and still running rough What do I look for now


check plugs -plug gap-vacuum leak-fuel mix-fuel pressure-timing-pcv valve-egr valve-air filter-oil sludge build up-problem in heads[valves adjustment-burnt-weak springs if only changed wires do a complete tune-up and do a compression check

Mar 14, 2010 | 1991 Chevrolet Camaro

2 Answers

I have an oil leak in a spark plug chamber how do is fix it


depends where the oil came from.of it has leaked down from a valve cover gasket,that is not hard to fix.if it a leaking valve seal that is expensive and if the head gasket is leaking,expensive.look at the outside edge of the valve cover,and check the edge for oil.if there is alot of oil,by the time the plug is unscrewed oil can go inside.the oil would burn off,so if there is oil inside it is dripping down probably from a valve seal.take off the valve cover and inspect the seals they are probably no good.there are 2 seal sets,one is in the valve cover,and that results in oil on the outside of the plug,and the actual valve seal which results in oil in the inside of the engine.

Jul 13, 2009 | 2002 Nissan Maxima

1 Answer

Is it hard to change the spark plugs in my 2000 expedition triton v8


5.4 triton, spark plugs are under valve cover have to disconnect harnesses and make room to remove cover pull bolts from cover, unbolt coil from each plug change plug reinstall coil, then change valve cover seal and rebolt down, reconnect harneses and then u realize u have other side to do still... yes one of hardest plugs to change in any vehicle

Jul 06, 2009 | 2000 Ford Expedition

1 Answer

Oil on spark plug


no, not a blown headgasket, remove the valve cover and inspect the spark plug hole seals(tube seals in the valve cover) replace if brittle and old. also change the valve cover gasket since u have it off...adjust the valves as well

Apr 05, 2009 | 1997 Honda Accord

2 Answers

Spark plug change


Well i wouldent of thought you need to take off the valve cover AKA (rocker cover) to change spark plugs. spark plugs are usally set at a touque setting at 10 to 15 NMs (newton meters). if you do have to take off the valve cover the gasket can be re-used no O-rings needed.

Mar 06, 2009 | 1994 Nissan Altima

Not finding what you are looking for?
2009 Kia Rio Logo

Related Topics:

159 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85223 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...