Question about 2001 Oldsmobile Aurora
I noticed when I went thru a carwash and water started coming from the over head light panel and sunroof control panel. It is not the same issue as the others have asked about. When the sunroof is completely closed, it slips down in the front. Does something need to be tighten or replaced?
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
1. Remove the two visible screws on the hinge side of the door panel 2.
Remove the two (or three) visible screws on the latch side of the door
panel. 3. Remove the screw in the plastic door pull recess. 4. Remove
the door pull recess by extending the door pull (like you are opening
the door), lifting the end of the recess that the screw was removed
from and pulling the recess forward toward the door hinges. 5. Lift the
plastic cap off the screw head in the 'cup' located at the rear of the
power window control panel on the door and remove the screw. 6. Lift
the power window control panel out of the door panel ( it puts up a
fight) and disconect the two power plugs on the bottom of the assembly.
7. Using a stiff putty knife or a similar tool pry the bottom of the
door panel from the door, it is secured by several plastic push in
thingies. 8. Disconect the light bulb from the lower left hand corner
of the door panel by twisting it a half turn and pulling straight out.
9. At this point the panel should be connected to the door at the top
of the panel only. 10. There is probably a better technique but I
lifted and pryed and twisted the door panel until the fasteners from
Hell that connect the top of the panel to the door decided to release
the panel (all the while making sure I was gentle enough not to damage
the panel or the fasteners). 11. I didn't need to remove the mirror but
I did notice a screw head leading to the mirror assembly that was
exposed after the panel was removed. 12. While you have the panel
removed you might want to lubricate as many mechanisms as you can while
you have them exposed.
You can follow these instructions witch are for the front door as they are pretty much the same to undo let me know if you need further assistance ok
Posted on Aug 17, 2009
SOURCE: 1995 olds aurora won't start
If you havent fixed this already im sure you have found tapping on the starter is virtually impossable on an aurora.If the starter clicks but wont turn over the solinoid on the starter is bad.In an emergency you can grab the center boss of the top fan belt fully with a pair of channel locks and rotate the engine slightly. sometimes this puts the flywheel so the bendix will engage and start the engine ultimately you need to replace the starter or solinoid
Posted on Jan 09, 2010
Tips for a great answer:
Nov 23, 2016 | Cars & Trucks
Feb 14, 2015 | 1995 Oldsmobile Aurora
Sep 13, 2012 | 2007 Jeep Commander Rocky Mountain
Jan 17, 2012 | 2001 Oldsmobile Aurora
Feb 06, 2011 | 2001 Oldsmobile Aurora
Jun 16, 2010 | 1999 Oldsmobile Aurora
Aug 21, 2009 | 2001 Oldsmobile Aurora
Apr 12, 2009 | Oldsmobile Bravada Cars & Trucks
Sep 27, 2017 | 2001 Oldsmobile Aurora
47 people viewed this question
Usually answered in minutes!