Question about 2007 GMC Yukon Denali

1 Answer

2007 GMC Yukon Denali The rear parking sensors only beep once when placed in reverse and the gauge inside goes up through the yellow bars as the vehicle is approaching the object but still no warning chime until the object is less than 1 foot away then the chime begins. Dealer says everything checks out ok.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • GMC Master
  • 55,370 Answers

"Dealer says everything checks out ok". Translation: The dealer made a superficial operational check without bothering to run the diagnostic routine that would have pinpointed the real problem.

Posted on Dec 30, 2017

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 375 Answers

SOURCE: '04 GMC Yukon Denali Check Engine Light

Did u put in fuel shortly before the light came on? I own 2 service centers & the most common situation with "Check Engine" lights are because the fuel cap wasn't re-installed or not tightened. When you refuel make sure it "clicks" when putting back on. We don't charge for a "Code Reading" but a dealer will, don't go there. Go, like the others suggested. If it is the fuel cap & you re-install it correctly, the light will go off after a short drive. Good Luck. PS-Don't panic when the "Check Engine" light comes on unless it blinks, if that happens don't drive. PSS-RE: Murray's, Auto-Zone.......If it's a "Code" (the reader will give a #) the code book will tell you the problem. PSSS-Some1 please have Troy W's Mommy & Daddy take away his keyboard. Just because you can put together a "Lego" car doesn't make you a master mechanic. You only repeated what we said except you have a "Napoleon" complex against any1 plugging something in to a vehicle. It's the same as plugging in a light @ home. In conjunction with "kinder" nine out of ten time in my experience it usually is the oxygen sensor(s) which would be about right with the year model

Posted on May 18, 2008

Ted Schore

  • 7353 Answers

SOURCE: 2006 Yukon Denali, oil pressure gauge malfunction

Most likely the oil pressure sensor is bad. Its located in the very rear of engine on top of bell housing area.

Posted on Oct 30, 2009

john h

  • 22486 Answers

SOURCE: gmc yukon has the abs & parking brake light

you have to fix the problem with ur brakes- first check the wiring ,connectors and connection clips to the abs sensors and modulator if looks ok than have truck scanned some auto stores such as auto zone / advanced auto do it for free the code will give u a start point towards fixing ur problem--visual inspection of brakes doesnt always show problem

Posted on Nov 26, 2009

Anonymous

  • 1 Answer

SOURCE: 03 Yukon Denali Traction Control/ ABS Problems

my 2000 yukon has the traction control light on and the abs light on any anwsers?

Posted on Nov 28, 2009

Carlos Solas

  • 293 Answers

SOURCE: 2007 GMC Envoy - Gas gauge showing empty and check engine light

This is a safety feature that the vehicle brings. You need to reset the E.C.U on dealership or it will keep doing it to you. It was probably caused by one single time that you did not closed the fuel cap correctly. Good luck

Posted on Dec 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 Yukon Xl Denali can the headlight switch/dimmer cause only the tail lights to not work. Dash lights, signals, brake lights when pressed work. Both sides went out. No blown fuse or broken wires.


If front park lights are working highly unlikely headlight switch is the issue. Is the vehicle equipped with a trailer towing package and wiring to the rear? I would start there. This vehicle may also have a taillight module located under the vehicle on the passenger rear attached in the wheel well area that goes bad

Apr 26, 2015 | 2007 GMC Yukon XL Denali

1 Answer

2007 Yukon Denali GMC inside door handle on driverside is loose and want on the door


Unfortunately, they seem to be making door handles cheaper now and many people are having problems with them. If it is loose, the only thing you can do is unscrew and pry off the inner door panel and once inside the door, tighten up the connections. Try looking at this informative YouTube.com video: https://www.youtube.com/watch?v=pesX5dZeGwo

I hope that helps! :)

Apr 05, 2015 | 2007 GMC Yukon Denali

1 Answer

Where is the starter located on the 2007 YUKON DENALI


passenger side rear of engine

If you need further help, I’m available over the phone at https://www.6ya.com/expert/mike_9693b5ad75773352

Jul 09, 2014 | 2007 GMC Yukon Denali

1 Answer

2007 Yukon Denali...have removed the brackets but we are not able to lift out the battery to change. What else is holdong the battery down?


look at the bottom ridge of the battery case, there is usually a small plastic clamp/ bar with a 10-13 mm bolt holding the battery in place with a hold down clip/ bar on the other side of the battery.

Apr 17, 2011 | 2007 GMC Yukon Denali

2 Answers

2006 Yukon Denali, oil pressure gauge malfunction


Most likely the oil pressure sensor is bad. Its located in the very rear of engine on top of bell housing area.

Oct 30, 2009 | 2006 GMC Yukon Denali

1 Answer

2007 GMC YUKON denali, rear brakes have an air


Here's a link to a thorough article on the subject which should help you...

http://www.aa1car.com/library/abs_bleeding.htm

Oct 13, 2009 | 2007 GMC Yukon XL Denali

1 Answer

Can't get rear parking brake off 04 Yukon Denali XL


You are going to have to pry it over the axle on one side of the park brake shoe assembly with either a pry bar or screwdriver. then just pop the new one back over the axle in the same way. Hope this helps

Aug 05, 2009 | 2006 GMC Yukon Denali

1 Answer

Gauges get stuck in 2005 Denali


It's the step motors inside the cluster that control the gauges . From 2003 to 2006 GM had bad step motors . You need a new cluster or you can buy a kit off ebay or amazon
How to repair GM Instrument Cluster Speedometer Gauge Stepper

Jul 17, 2017 | 2005 GMC Yukon Denali

1 Answer

The service park assist light comes on my yukon denali


what is the process on how to reset the rear park assist light that comes on the instrument cluster on the dash?

Mar 24, 2009 | 2007 GMC Yukon Denali

Not finding what you are looking for?
2007 GMC Yukon Denali Logo

Related Topics:

217 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...