Question about 2004 BMW 745Li
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
are you sure you need the crankshaft position sensor changed. it is at the back of the engine i believe, but.....
check for a wet ecu first... read the note on e36...
the ecu compartment is under the windshield on the passenger side on E36
you gain acess to it under the hood....
this compartment gets wet, the ecu lays on a flat surface in that
the bottom side of the circuit board gets wet and starts corrosion.
remove the ecu, take the bottom plate off, clean the bottom of the circuit
board with alcohol and a soft tooth brush.
you should be able to see the signs of corrosion or conductive build up.
this gunk bridges solder points doing all sort s of wierd things to your
car, including false sensor readings from asc/abs controllers and other
all the way to engine failure and worst case burnt and shorted wiring
I'm on my 3rd ecu, took me and the repair boys a few years to figure this
BTW: i would get that ecu mounted above that flat surface, use some sort
of standoff to raise it so that it is not laying in the wet.
Posted on Feb 07, 2010
Tips for a great answer:
Aug 15, 2017 | BMW Cars & Trucks
Jun 24, 2017 | BMW 745i Cars & Trucks
Jul 05, 2015 | BMW Cars & Trucks
Jul 29, 2011 | BMW L7 Cars & Trucks
Nov 15, 2009 | 2004 BMW 7 Series
Oct 27, 2009 | 2004 BMW 7 Series
Aug 22, 2009 | BMW 750 Cars & Trucks
999 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: