Question about Cars & Trucks

1 Answer

I need help asap 2003 Expedition code p0171 and code p0712 i have and idea of the 1st code but whats the secound code i really need help i dont want to take it to a shop where there going to charge me alot of $$$$ wich i dont have just cuz im a girl and dont have a clue of cars Please HELP!!!!

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 22,485 Answers

P0700 Transmission Control System

P0701 Transmission Control System Range/Performance

P0702 Transmission Control System -Electrical

P0703 Torque Converter/Brake Switch B Circuit

P0704 Clutch Pedal Position Switch -Circuit Malfunction

P0705 Transmission Range Sensor/Switch Circuit Malfunction (PRNDL Input)

P0706 Transmission Range Sensor/Switch Circuit Range/Performance

P0707 Transmission Range Sensor/Switch Circuit Low Input

P0708 Transmission Range Sensor/Switch Circuit High Input

P0709 Transmission Range Sensor/Switch Circuit intermittent

P0710 Transmission Fluid Temperature Sensor Circuit

P0711 Transmission Fluid Temperature Sensor Circuit Range/Performance

P0712 Transmission Fluid Temperature Sensor Circuit Low Input

P0713 Transmission Fluid Temperature Sensor Circuit High Input

P0714 Transmission Fluid Temperature Sensor Circuit Intermittent

P0715 Input/Turbine Speed Sensor Circuit

P0716 input/Turbine Speed Sensor Circuit Range/Performance

P0717 Input/Turbine Speed Sensor Circuit No Signal

P0718 Input/Turbine Speed Sensor Circuit Intermittent

P0719 Torque Converter/Brake Switch B Circuit Low

P0720 Output Shaft Speed Sensor Circuit

P0721 Output Shaft Speed Sensor Circuit Range/Performance

P0722 Output Shaft Speed Sensor Circuit No Signal

P0723 Output Shaft Speed Sensor Circuit Intermittent

P0724 Torque Converter/Brake Switch B Circuit High

P0725 Engine RPM Input Circuit

P0726 Engine RPM Input Circuit Range/Performance

P0727 Engine RPM Input Circuit No Signal

P0728 Engine RPM Input Circuit Intermittent

P0729 Gear 6 Incorrect Ratio

P0730 Incorrect Gear Ratio

P0731 Gear 1 Incorrect Ratio

P0732 Gear 2 Incorrect Ratio

P0733 Gear 3 Incorrect Ratio

P0734 Gear 4 Incorrect Ratio

P0735 Gear 5 Incorrect Ratio

P0736 Reverse Incorrect Ratio

P0737 TCM Engine Speed Output Circuit

P0738 TCM Engine Speed Output Circuit Low

P0739 TCM Engine Speed Output Circuit High

P0740 Torque Converter Clutch Solenoid Circuit

P0741 Torque Converter Clutch Solenoid Circuit Performance or Stuck Off

P0742 Torque Converter Clutch Solenoid Circuit Stuck On
P0743 Torque Converter Clutch Solenoid Circuit Electrical
Now i dont know a lot about automatics especially modern ones with all this fancy electronics thats used nowdays but i think its a fault with the temperature sensor for the gearbox.But where its located and what it looks like i have no idea it could even be mounted inside the gearbox .Sorry not a very good answer from a mechanic but?? very few of our europeon cars come with auto transmission .Evan when i do know whats wrong i cannot buy the parts for the gearbox as only re-con boxes supplied by the dealer so best advice is to try a specialist in auto box repairs only .PS some of my best students when i used to teach mechanics many moons ago were the girls so no excuses like iam only a girl please

Posted on Apr 22, 2013


5 Suggested Answers


6ya staff

  • 2 Answers


Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017



  • 1 Answer

SOURCE: 1995 Honda Accord Stereo

I found the dealership that my car was originally bought from and called them. They pulled up the code and gave it to me. If you have anything with dealers name it will help. Or maybe honda dealership and give them the vin number so they can pull it up.

Posted on Sep 18, 2008


Jeff Barton

  • 520 Answers

SOURCE: i have a 2003 saab 9-3 2.0t and my engine light

This indicates a malfunction within the engine control computer which operates and monitors many functions of the engine,transmission and emmision control devices.At this point you should have diagnostics ran to where a technician will interface your vehicle with a diagnostic computer and retrieve trouble data set by your computer as these codes are stored.Sometimes these are fairly non-detrimental trouble codes which may only take a reset for instance fuel emmision codes set as a result of a lose gas cap.

Posted on Jul 17, 2009


  • 1 Answer

SOURCE: passenger window will not go up i think its

I have the same problem on my 2003 Expedition. Front passenger window will work on dpwn position but not up. The breaker fuse is good (other windows work). I replaced the motor on passenger side and tested the switch. Both are good. Turns out, I did not need to replace the motor. I did find that I have 11.7 volts to roll it down, but only about 10 volts to roll up. I haven't figured out why I have a volage drop. Can you help?

Posted on Oct 04, 2009

SOURCE: I have a 1996 Chevrolet Tahoe wont go into 3rd gear

The only way to repair it will be to remove the transmission and tear it down to see what broke. I have the same transmission in one of my vehicles (4L60E) and had the exact problem, 1st and 2nd, no 3rd gear. It turned out the 3-4 clutch pack was burnt up and had to be replaced. The labor involved with removing and disassembling the transmission is so great that it makes sense to rebuild the transmission, not just replace what is broken. So i would say it's time for a transmission rebuild or purchasing a crate transmission from someone like jasper.

Posted on Mar 07, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Po171 2003 ford transit

p0171 is the code for system too lean bank 1. possible causes intake/exhaust leak--air system maf/vaf sensor-fuel pressure--manifold regulator/ pump--injectors Ho2s Check for leaking rubber hoses. Have a fuel pressure test done and replace the sensor.

Mar 06, 2013 | 2003 Ford Expedition

1 Answer

Obd code p0171

P0171 System too Lean (Bank 1)

Oct 30, 2012 | Lexus Cars & Trucks

1 Answer

Whats p0171 code on a 2003 expedition

The link below will give you a full description of the problem. It's usually traced to either a vacuum leak or a bad MAF sensor.


Jan 06, 2012 | 2003 Ford Expedition

1 Answer

What would cause a p0300 code what do i need to do to fix

2003 alero misfires, chgd plugs and fuel regulator, codes are p0171 and p0300. Any ideas

Aug 13, 2010 | 2003 Oldsmobile Alero

1 Answer

2003 Ford Expd. running rough @ idle -

There could be many issues. These codes read your engine is running too lean. Check : all your vacuum hoses for leaks, PCV valve and hose, MAF sensor. This may require an experienced technician to figure this out. Hopefully I help'd!!

Apr 05, 2010 | 2003 Ford Expedition

2 Answers

My 2003 expedition giving code po171 have cleaned maf sensor in the air box didn't work what should i try next

P0171 is a lean fuel condition bank 1. Could be a bad O2 sensor on that side of the engine.

Could be a plugged fuel filter. How long since it was replaced? Close to or beyond the recommended interval?

Other possibilities...
Failing fuel pressure regulator.
Failing fuel pump.
Failing or plugged fuel injector.

Jan 05, 2010 | 2003 Ford Expedition

1 Answer

I have a 2003 ford expedition,

if you have the 3.8 engine you might have a vacuum leak at the intake where the plastic intake meets the lower intake,there are rubber gaskets that fail when they get older from oil getting into intake.This will set that po171 also p0172 -3 &4,hope this helps as you may be wasting time and money to try and fix it with just the o2sensor .The maf on the ex is where the cone air filter is look for the wiring harness that goes into air filter housing,its inside there fun to remove dont brake it

Oct 05, 2009 | 2004 Ford Freestar

2 Answers


This is either a vacuum line or clogged EGR valve. This is the first thing to fix. Other problem is intake manifold.Cleaning will usually fix it, but change the gaskets and change isolator bolts.

Sep 26, 2009 | 1998 Ford Expedition

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

700 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

22486 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides