Question about Cars & Trucks

1 Answer

I would like to have a complete visual fuel line hose from fuel tank to engine for a Plymounth Chrysler Grand Voyager 2wd SE , Also a diagram of complete electrical & wiring system for a 2000 Plymouth Grand Voyager SE

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 5,370 Answers

For accurate wiring diagram for fuel pump and fuel pump assembly hose diagrams,click the link and follow the details:---
http://www.schematicsdiagram.com/2013/09/plymouth-chrysler-grand-voyager-fuel.html
--------
this will help thanks.

Posted on Sep 30, 2013

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
motor1258

Mike Butler

  • 6674 Answers

SOURCE: I have a 87 plymouth voyager Le with a 3.0 engine ( not sure if its stock or not )

You should have a fuel pump relay you can check on firewall or fender with other relays in the area. Check part #'s, on relays,sometimes they will swap for testing if same number.

Posted on Feb 25, 2009

Randy Ohler

  • 14585 Answers

SOURCE: need wireing digran for 1996

When the ECM is replaced you need to have it reprogrammed. It may run the engine for a bit but there are t many variables to keep it going. Some auto parts stores are doing this now. call around. Much cheaper than a dealer. If you had it reprogrammed then you need to check the codes. This will give a direction to go.
Randy

Posted on Jun 09, 2011

brandon

  • 24 Answers

SOURCE: need iring diagram for 2002 plymouth grand voyager fuel system

u can chase all the wiring you want but you will have to come to the reality its need a mew fuel pump module wich is just under 400$

Posted on Sep 26, 2012

skychief2001

Stephen

  • 21873 Answers

SOURCE: wiring diagram for 2000 plymouth grand voyager

Some of the diagrams you can get from places like autozone online, or research the particular component online. Things like body components may require you to buy a shop manual.

Posted on Sep 26, 2012

sulavaca

Jamie Alton

  • 1007 Answers

SOURCE: MY PLYMOUTH GRAND VOYAGER 'S HEADLIGHT'S AND DASH LIGHTS WORK, BUT THE ENGINE WON'T TURN OVER. THERE IS NO SPARK COMING FROM THE ELECTRICAL WIRES.

When you say no spark, are you talking about the spark plugs, or just the general wiring?

If the engine won't turn over, then it isn't moving, and if it isn't moving then you need to check the following in this order:

1) Does the battery have power i.e. around 12.4 volts or over?No? Charge, test or replace battery.

2) Do the car's head lights dim considerably if turned on when attempting to crank? Yes? Possible lack of battery charge or faulty battery.

3) Assuming the battery is fine, can you turn the dash warning lights on and off with the key? No? Faulty ignition switch.

4) Is there a click sound when you turn the key, but no starter motor spin? Check starter motor connections or replace starter motor.


If none of the above prove to be of help, then please report.

Posted on Nov 01, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 Plymouth Grand Voyager having issues starting


i would think that you need to look for a leak, there are rubber hoses attached to your steel lines under your van and in the engine compartment, as well as your fuel pump. start your van with the parking brake applied, and tires blocked, then you can trace your fuel lines out, just remember if you dont see a wet spot that doesnt mean theres no leak, your looking for dry rotted hose. what could be causeing a starting delay could be that its sucking air, and if your fuel pump is under the hood, then the fuel line going from the fuel tank to the front is a suction hose, if you have a fuel pump in the fuel tank the that line is a pressure hose. hope this helps

Aug 11, 2012 | 2000 Plymouth Grand Voyager

1 Answer

How do you remove a fuel pump on a 97 plymouth grand voyager


    • 1 Make sure the engine is completely cool. Relieve the pressure in the fuel system. Disconnect the negative battery cable. Elevate the vehicle and support the fuel tank with a jack.
    • 2 Disconnect the fuel line from the front of the tank. Remove the ground strap, the inboard side fuel tank straps and the front T-strap fastener, then lower the tank approximately six inches.
    • 3 Take the fuel lines from the fuel pump module. Plug the fuel lines with golf tees to prevent the spillage of gasoline. Remove the fuel filter.
    • 4 Install the new fuel filter. Set the bolts in place and torque them to 40 inch/pounds. Tighten the main tank straps to 40 foot/pounds and the T-strap to 250 inch lbs.
    • 5 Reconnect the fuel lines in the reverse order of their removal. Lower the vehicle. Connect the negative battery cable.
    • 6 Start the engine and let it run for several minutes. Inspect the fuel lines for any leaks.


Read more: How to Replace a Fuel Filter in a Plymouth Voyager ' eHow.com http://www.ehow.com/how_4519932_replace-fuel-filter-plymouth-voyager.html#ixzz1WBXAZ7d3

Aug 27, 2011 | 1997 Plymouth Voyager

1 Answer

1999 grand voyager le how do i replace fuel filter


Hello,

To replace the fuel filter of Your 1999 grand voyager, please follow the steps below, You will be in need of these instruments, Line wrench set, 3/8-inch ratchet and socket set, Replacement fuel filter kit.
  1. Park the 1999 Grand Voyager in a ventilated area and engage the emergency brake,
  2. Walk to the back of the 1999 Plymouth Grand Voyager and completely unscrew the gas cap from the fill neck on the gas tank. Taking the cap off will remove the pressure in the fuel filter.
  3. Jack the back of the 1999 Grand Voyager up and put the jack stands under the rear jack points. Slowly release the jack so that the van is sitting evenly and securely on the jack stands.
  4. Slide under the passenger-side rear of the van behind the tire. Locate the fuel filter that is mounted to the upper part of the gas tank. This type of fuel filter has three fuel lines coming out of it.
  5. Position the drip pan under the gas tank in the general vicinity of the fuel filter. Using a clean rag, compress the fuel lines on the ends. The fuel lines are held to the fuel filter by a plastic clip. Compressing the end of the fuel line will unlock the fuel line from the clip. Pull out on the fuel lines. Do this to all three of the fuel lines.
  6. Remove the bolt from the fuel filter bracket with the 3/8-inch drive ratchet and a 3/8-inch drive socket. Then, pull the fuel filter out of the bracket and put it into the drip pan.
  7. Position the new fuel filter into the bracket. Screw the mounting bolt in and tighten it down tight with the ratchet and socket.
  8. Push all three fuel lines onto the appropriate fuel filter ports. Hook the fuel lines to the same fuel filter ports that they were hooked to on the old filter.
  9. Pull the drip pan out from under the van. Screw the gas cap back onto the fill neck of the gas tank until it clicks. Then, turn the ignition key on and off five different times. Crank the engine on the fifth turn of the ignition. Inspect the new fuel filter for leaks while the engine is running. Then, turn the engine off.
  10. 1999 Grand Voyager back up and pull the jack stands out from under the van. Lower the van back to the ground and slide the jack out.
Hope this helped. Thank You for using FixYa!!!

Jan 17, 2011 | Chrysler Voyager Cars & Trucks

1 Answer

I have a 2000 grand voyager se. when the ignition key is turned to the on position(no starter engaged) the 20a ign fuse blows. If i remove the fuel pump relay and the associated fuel pump fuse the ignition...


Put the fuses back in,and unplug the fuel pump from the tank,and turn the key on,if it does not blow the fuse,then the pump is the problem.Rate this if it is helpful,thank you.

Jun 12, 2010 | 2000 Chrysler Grand Voyager

1 Answer

Where is the fuel filter located on a 1996 Plymouth Grand Voyager 3.0 Engine


For 1996 Plymouth Truck Grand Voyager 2WD 3.0L MFI 6cyl the Fuel Filter is located under vehicle, driver side, below seating area, front of fuel tank, mounted on chassis in fuel line.

Hope help with this (remember rated this).

May 11, 2010 | Cars & Trucks

2 Answers

Where is the fuel filter located on a 2000 chrysler grand voyager 3.3 liter v6


Commonly the fuel filter is in the tank and is good for 100k miles. You can call your local part store for a fuel filter listing but they will probably tell you that there isn't one.

Apr 17, 2010 | 2000 Chrysler Grand Voyager

1 Answer

I am unable to locate the fuel filter on my car


Look under vehicle along frame rail -- follow fuel line from tank it might even be a black case in the engine bay

Jan 30, 2010 | 2004 Chrysler Voyager

1 Answer

Where is the fuel filter located on 1999 plymouth Grand voyager?


The Fuel Filter should be located above the Fuel Tank on the right side of the Van. You do not have to completely remove the tank, but lower the right side of the tank only.
Of Course: No Smoking or Heat Sources.
Have a Fire Extinguisher on the "ready" (within reach with the pin pulled, and nozzle pointed).
Use goggles to protect gas splash. Do in a well ventilated area.
Raise and support the rear of the Van.
Disconnect the negative side of the Battery.
Remove the Fuel Cap to relieve any pressure in the system.
Use a hydraulic jack with a flat and balanced piece of wood to support the tank while slightly lowering and raising the fuel tank.
Loosen, BUT DO NOT REMOVE the Front Strap Bolt and then the Right Side Bolts. These should be 13mm and 15mm bolts. Lower the hydraulic jack slightly to gain clear access to the fuel filter and hoses fittngs.
The fuel filter is attached to a brace with a 10-mm bolt. Disconnect the fuel hose located near the front right of the tank first.
Disconnect the two filter to pump hose lines. Take note of how these hoses are attached, you don't wnat to reverse these.
Reinstalling is reverse order of above.
Let me know if this helped; or if you have additional information or questions. Feel free to contact me at FixYa.com!


Jan 04, 2010 | 1999 Plymouth Grand Voyager

1 Answer

Changing fuel pump on chrysler 2000 grand voyager


you have to drop the gas tank out from under the vehicle. You must first drain as much gas out of the tank as you can. Then support the tank with a jack. Preferably with a large plate. Then remove the retaining straps. If you can remove any of the fuel lines and fill nozzle before lowering please do. If you cannot, lower the tank until access to wiring harness and fuel line disconnects can be made. With a special fuel line tool remove lines and harness and anything else that may hinder the removal on the tank. Once the tank is out from under the vehicle remove as much dust and debris as you can fom the top of the unit. Remove the retaining ring using a hammer and a punch, or screwdriver. Once the retaining ring has been removed carefully remove the fuel pump assembly from the tank. be careful not to damage the float. replace pump in the reverse order above.

Jul 30, 2009 | 2000 Chrysler Grand Voyager

1 Answer

Wheres the thermostat on a 2000 chrysler voyager se?


follow the upper radiator hose to the engine and you will find it.

hope this helped
please remember to rate me.

If you need further help, reach me via phone at https://www.6ya.com/expert/mark_445a24324be9eb03

Mar 06, 2009 | 2000 Chrysler Grand Voyager

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

471 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

22486 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...