Question about Cars & Trucks
Should be a canister with a silver lid on top of motor, un screw cap and the filter is inside
Posted on Nov 08, 2013
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Your dip stick tube is your fill tube for your transmission . Make sure your transmission oil is at opperating temp before servicing some instructions are written on the dip stick , Use a small funnel , Add a little at a time (cup). Use the proper fluid , check regularly
Posted on May 18, 2008
Since you replaced the distributor, are you sure it's properly timed? Hook up timing light and try to crank. It should show you where your timing mark is. It will also verify that you are getting spark.
You need to start a systematic check. Is it electrical, mechanical, fuel related? Need to do more checking and maybe we can get that puppy going.
Posted on Feb 26, 2009
SOURCE: locate and change fuel filter
fuel filter is is in the center of engine at the back by firewall round canister type with screw top. unscrew replace, fill with fuel. 40 -50 $
Posted on Jun 04, 2009
ITS A SPIN ON FILTER, YOU NEED TO DISCONNECT THE WATER SENSOR ON THE BOTTOM OF THE FILTER, THEN USING A STRAP FILTER WRENCH LOOSEN THE FILTER AND SPIN IT OFF.
CHECK THE FILTER HOUSING TO BE SURE THE INNER FILTER SEAL ISN'T ON THE HOUSING AND CAME OFF WITH THE FILTER.
REMOVE THE WATER LEVEL SENSOR AND DISCARD THE SEAL.
INSTALL THE WATER LEVEL SENSOR ON THE NEW FILTER. USING A LITTLE GREASE ON THE INNER FILTER SEAL AND ON THE OUTER O-RING TO HOLD IT IN PLACE, SPIN ON THE NEW FILTER.
OPEN THE VENT ON THE UPPER SIDE OF THE FILTER HOUSING. PUSH DOWN ON THE HAND PUMP QUICKLY UNTIL THE FUEL IS COMING OUT OF THE VENT. CLOSE THE VENT AND PUMP THE FILTER PUMP UNTIL IT FEELS SOLID. AT THIS POINT START THE ENGINE. IF IT STALLS PUMP IT UP AGAIN AND RESTART THE ENGINE. IF YOU HAVE AN ASSISTANT THEY CAN PUMP THE FILTER PUMP WHILE THE ENGINE IS RUNNING AND QUIT WHEN YOU FEEL THE ENGINE IS NOT GOING TO STALL. ABOUT 10 TO 15 SECONDS USUALLY WORKS.
CHECK FOR LEAKS.
BEFORE STARTING THE ENGINE USE BRAKE WASH TO REMOVE THE FUEL SPILLED DURING THE FILTER REPLACEMENT. ALLOW IT TO DRY BEFORE STARTING THE ENGINE.
RATE ME PLEASE.
Posted on Jul 07, 2009
Tips for a great answer:
Jan 18, 2013 | GMC Cars & Trucks
Feb 06, 2012 | GMC Savana Cars & Trucks
Aug 08, 2011 | 1999 Chevrolet Express
May 07, 2011 | GMC Vandura Cars & Trucks
Sep 14, 2010 | 1993 GMC G2500
Dec 05, 2009 | 1983 Cadillac Fleetwood
Nov 12, 2009 | 1996 GMC Savana
Apr 09, 2009 | 1983 GMC C2500
May 18, 2008 | 1989 GMC Dura
63 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: