Question about 2001 Ford Windstar
2001 ford windstar won't start. theft light on. New Battery
Theft light should be flashing when system is armed. It should reset itself. If on steady, you have a probelem. Try your other key first. This inof should help you. Report back if you still need help.
Anti-Theft —Passive The passive anti-theft system (PATS) contains the following components:
Principles of Operation
The PATS uses a specially encoded ignition key. Each encoded ignition key contains a permanently installed electronic device called a transponder. Each transponder contains a unique electronic identification code out of over 18 billion, billion combinations.
The passive anti-theft system (PATS), also known as SecuriLock ®, uses radio frequency identification technology to deter a driveaway theft. This system is known as Securilock® in North America, Safeguard® in the U.K., and PATS in Continental Europe. Passive means that it does not require any activity from the user.
The SecuriLock® System (PATS) is not compatible with aftermarket remote start systems, which allow the vehicle to be started from outside the vehicle. These systems may reduce the vehicle security level, and also may cause no-start issues. If equipped the remote start system must be removed before investigation of PATS-related, no-start issues.
Each encoded ignition key must be programmed into the vehicle's powertrain electronic control (PCM) before it can be used to start the engine. There are special diagnostic repair procedures described in this section that must be carried out if a new encoded ignition key is necessary.
This system contains a new feature named Unlimited Key Mode. This feature allows a customer to program more than eight keys to the vehicle if they request it. Each vehicle in Unlimited Key Mode is set up with a special Unlimited Transponder Security Key. This allows all the customer vehicles to share the same keys, but no other keys from outside can be used to operate the vehicles. For an individual customer, any randomly selected Security Key is acceptable. Refer to Unlimited Key Mode Programming in Key Programming Switch State Control in this section.
The PATS transceiver module communicates with the encoded ignition key. The module is located behind the steering column shroud and contains an antenna connected to a small electronics module. During each vehicle start sequence, the transceiver module reads the encoded ignition key identification code and sends data to the PCM.
The control functions are contained in the PCM. This module carries out all of the PATS functions, such as receiving the identification code from the encoded ignition key and controlling the engine enable. The PCM initiates the key interrogation sequence when the vehicle ignition switch is turned to RUN or START.
All elements of the PATS must be functional before the engine is allowed to start. If any of the components are not working correctly, the vehicle will not start.
The PATS uses a visual theft indicator. The indicator will prove out for three seconds when the ignition switch is turned to RUN or START under normal operation. If there is a PATS concern, this indicator will either flash rapidly or glow steadily when the ignition switch is turned to RUN or START. The PATS system also flashes the theft indicator every two seconds at ignition OFF to act as a visual deterrent.
The following will activate the PATS and will disable the vehicle from starting:
Visual Inspection Chart Mechanical Electrical
Posted on May 27, 2009
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Hi, first you disconnect the battery. then you need to take the belt off by the back pulley. But you don't need to take it all the way off. Just so you get the alternator belt off. I just replaced the one on my 1997. Then you have three bolts, and one small nut to remove . Then put all back together the way you took them off.
Posted on Aug 02, 2010
This means that your key is not being recogonized.Ethier the chip in the key is bad or the patts transciever at the lock cylinder. Do you have a spare key? If not you will have to get 2 new keyss cut and programmed.
Posted on Feb 16, 2009
you will have to take your vehicle to the nearest dealer the theft system is the issue most likley you will have to replace the ignition switch but you will have to get it properly diagnost do yourself a favor and save u time and money
Posted on Nov 27, 2009
Testimonial: "Well this is one place to start from.Hope it works.Thanks for your support and help."
It's going to have to be looked at. But you can try unlocking a different door with the key. Hold it to the left (unlock position) for 2 or three seconds. Should shut off the alarm and allow you to start it.
Posted on Feb 27, 2010
Tips for a great answer:
Jan 26, 2016 | Ford Cars & Trucks
Jan 27, 2015 | 2001 Ford Windstar
Jan 19, 2015 | 2001 Ford Windstar
Aug 14, 2012 | 2001 Ford Windstar
Jun 18, 2011 | 1999 Ford Windstar
May 02, 2011 | 1999 Ford Windstar
Jan 17, 2011 | 2001 Ford Windstar
Jun 20, 2009 | 2001 Ford Windstar
May 27, 2009 | 2001 Ford Windstar
Feb 15, 2009 | 2000 Ford Windstar
11,253 people viewed this question
Usually answered in minutes!