Question about 2005 Chevrolet Uplander

1 Answer

Throttle body sensor location 2005 uplander

Where is it located

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Chevrolet Master
  • 540 Answers

The sensor is part of the throttle body and not replaceable here is the throttle body replacement instructions as you will have to replace the entire throttle body it is a very common issue with these
THROTTLE BODY ASSEMBLY REPLACEMENT

REMOVAL PROCEDURE

  1. Remove the air cleaner intake duct.
throttle body sensor location 2005 uplander - 120434113
  1. Disconnect the electronic throttle control (ETC) electrical connector (1) from the throttle body (2).
throttle body sensor location 2005 uplander - 113356645src="/uploads/images/113356645" alt="113356645" class="h_mi" />
  1. Remove the heater pipe nut at the throttle body.
  2. Remthrottle body sensor location 2005 uplander - 113356646the heater inlet pipe.
113356646
  1. Remove the nuts and the bolts from the throttle body.
  2. Remove the throttle body assembly.
  3. Remove the throttle body gasket.
  4. Clean and inspect the throttle body gasket mating surfaces.
NOTE: Do not use solvent of any type when cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as damage to the gasket surfaces and throttle body assembly may result.

Use care in cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as sthrottle body sensor location 2005 uplander - 113356646s may damage the gasket surfaces.

INSTALLATION PROCEDURE
113356646
  1. Install a new gasket, if necessary.
  2. Install the throttle body assembly.
  3. Install the throttle body nuts and the bolts.
Nthrottle body sensor location 2005 uplander - 113356645Refer to Fastener Notice in Service Precautions.

Tighten the nuts and the bolts to 10 N.m (89 lb in) .
113356645
  1. Install the heater inlet pipe.
  2. Install the heater pipe nut to the throttle body.
Tighten the nut to 25 N.m (18 lb ft) .
120434113
  1. Connect the ETC electrical connector (1) to the throttle body (2).
  2. Install the air cleaner intake duct.

Posted on Nov 28, 2014

Ad

4 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 1010 Answers

SOURCE: locating the fuse box for a 2005 chevrolet uplander

Try this..At the driver's seat open your car door all the way then look at the dashboard end. Pry off the plastic cover...the diagram should also be at the back of the cover.

Posted on Jun 25, 2008

Anonymous

  • 1 Answer

SOURCE: location Fuel Tank Pressure Sensor on a 2005 chevy express van

lOOK UNDER THE REAR OF THE VEHICLE ABOVE THE SPARE TIRE ON A CROSSMEMBER BETWEEN THE FRAME RAILS.

Posted on Apr 24, 2009

jamie sturm

  • 252 Answers

SOURCE: Where is the crank sensor located on a 07 chevy

the crankshaft postion sensor is always located either under the harmonic balancer pully aka crankshaft pully or mounted right outside the pully if yoiu need to change it keep in mind that you will need to to own or rent a harmonic balancer pully puller and a harmonic balancer pully installer kit both you can rent both at autozone fairly cheap and get all your money back when your done
job rating from 1-10 about a 3


hope it helps if so could you please leave me a 4 thumbs up feedback thank

Posted on May 12, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need to know where the throttle positioning sensor is located on 2005 Buick Lacrosse 6 cylinder the 8th digit on vin is 7


Your vehicle has two throttle position sensors ,both are located in the throttle body ! Here is a picture of what it looks like ! You have to replace this as a unit , can't just replace the TPS .

buick throttle-zae3klf45dsfwolgzbaa2r4x-1-0.png
http://www.autopartswarehouse.com/sku/Buick/LaCrosse/Standard/Throttle_Body/2005/SIS20012.html?apwcid=bngpla&gclid=CLioj7ymi9YCFemGswodCN0C6Q&gclsrc=ds $239.29 . So you better get a second opinion .

Sep 04, 2017 | Buick Cars & Trucks

1 Answer

How do i locate and replace throttle sensor


Locate your air intake. At the opposite end from where the air enters you will find your Throttle Body. There should be two sensors attached to your throttle body. The Throttle Positioning Sensor, and the Idle Air Control Valve.
On my vehicle the TPS is located at the bottom of the throttle body. The IACV is located on the side.
Since I cannot see your particular installation you will have to be the judge as to whether to remove the throttle body or not.
I have learned that it is somewhat easier to remove the Throttle Body in order to replace either of these sensors. And there will be less frustration with dropped bolts and or tools.
Also you will get the sensors installed properly and tightly, then you reinstall a single unit. Be sure to inspect the gaskets on the Throttle Body, and the IACV, replace if damaged in any way.


May 01, 2014 | 2005 Ford Focus

1 Answer

Throttle position sensor


the throttle position sensor will be located on the throttle body. If you follow the air induction hose that comes from the air filter housing to the engine it will be there where the hose clamps down

Jan 09, 2014 | 2007 Chevrolet Chevrolet Uplander

2 Answers

Sensor location


It is at the throttle pedal.

May 16, 2013 | 2005 Ford Expedition

2 Answers

Where is the throttle position sensor located on a 2005 nissan sentra


For every car that is equipped with a throttle position sensor, it is located in the same place...on the throttle body.

Feb 20, 2011 | 2004 Nissan Sentra

1 Answer

How to Install a Mass Airflow Sensor on a 2008 uplander and where is it located


Typically newer GM models have the mass air flow sensor in line from the induction hose that goes to the throttle body from the air filter box.Many are just held in place by hose clamps requiring either a ratchet with a 5/16 socket or a standard screwdriver to loosen it.

May 12, 2010 | 2008 Chevrolet Uplander

1 Answer

WHERE IS THE IAT SENSOR ON A 2005 DODGE DURANGO LOCATED AT?


The sensor is located either in the air filter box or in the air duct coming from the box going to the throttle body. Let me know if you need anything else.

May 07, 2010 | 2005 Dodge Durango

1 Answer

Where is the throttle position sensor at on a 2005 Dodge Ram 1500 Hemi 5.7L v8?


THIS ENGINE HAS ELECTRONIC THROTTLE CONTROL..THERE ARE 2 THROTTLE POSITION SENSORS LOCATED IN THE THROTTLE BODY,COMPLETE ASSEMBLY MUST BE REPLACED IF DEFECTIVE..IT ALSO HAS SENSORS IN THROTTLE PEDAL ASSEMBLY AS WELL..WHAT TROUBLE ARE YOU HAVING?

Jul 09, 2009 | 2005 Dodge Ram 1500

1 Answer

Cnt find iat sensor on 2005 chevy cobalt ss supercharged


The IAT sensor is most of the time located along the intake tube right after Between the throttle body and MAP sensor. Just follow your air intake tube from your air filter housing to the Throttle body.
Good luck. 

Apr 09, 2009 | 2005 Chevrolet Cobalt

Not finding what you are looking for?
2005 Chevrolet Uplander Logo

537 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...