Question about 1999 GMC Yukon

1 Answer

I have a 99 GMC Yukon with 53,000 mi. I got in it to start it and it starts, but when I apply brake to put in drive motor cuts out and doesn't want to restart. Can u help me...

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 66 Answers

Sounds like tranmission may be causing a stall, better get it checked by automatic transmission specialist

Posted on Sep 28, 2014

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 43 Answers

SOURCE: 2002 GMC Yukon a grinding sound and feel just

If its not the brakes then it could be a wheel bearing. Jack it up and spin the wheel. Listen for noise. If it has lots of miles or possibly been driven in high water at some point the bearing could need to be replaced. You should get it fixed and don't wait too long.

Posted on Jul 03, 2009

Molson02536

Harvey N Tawatao

  • 3854 Answers

SOURCE: 2003 GMC Yukon - fuel pump

Check your ECM fuse. There should be 2 fuses for your ECM. It's the ECM that controls the function of the fuel pump. Good luck friend and it's also common for the wire harness from the frame to the fuel pump to go bad due to corrosion from the bad weather we get in the winter and rainy spring and fall. 

Posted on Sep 04, 2009

Anonymous

  • 255 Answers

SOURCE: GMC Yukon - ABS light and parking brake light come on while drivi

try to pull up on your parking brake pedal with your hand when light comes on. if this makes it go out u will need to adjust the parking brake switch under the pedal. or replace pedal spring that holds it up.

Posted on Oct 02, 2009

Ted Schore

  • 7353 Answers

SOURCE: car keeps stalling when brakes applied, then starts but turns off

I dont know why, but one time my truck was low on trans fluid and after I topped it off, it didnt stall anymore when put into gear. as fro the odometer i dont know, it may have to go out completely before any diagnosis can be done.

Posted on Oct 13, 2009

Testimonial: "I will do that, but the other day we realized it only does it when one of us changes the steering wheel position...somehow the wires may be pinching?"

john h

  • 22486 Answers

SOURCE: gmc yukon has the abs & parking brake light

you have to fix the problem with ur brakes- first check the wiring ,connectors and connection clips to the abs sensors and modulator if looks ok than have truck scanned some auto stores such as auto zone / advanced auto do it for free the code will give u a start point towards fixing ur problem--visual inspection of brakes doesnt always show problem

Posted on Nov 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need to know what transmission is in my 99 gmc Yukon. Or how to find out


Shop for need to know what trans... on Google


Refurbished 1999 Gmc Yukon Transmission ...
$1,199.75
JCWhitney.com Refurbished 2003 Gmc Yukon Xl 1500 ...
$1,529.73
JCWhitney.com Refurbished 2002 Gmc Yukon Transmission ...
$1,199.75
JCWhitney.com Search Results

    I need to find out what transmission is in a 1999 gmc sierra ...

    www.cargurus.com > Questions > GMC > Sierra 1500

    CarGurusApr 7, 2013 - I need to find out what transmission is in a 1999 gmc sierra 1500 pick up 4x4 extended cab. ... Good luck. if the transmission is bad and you KNOW that for a fact, just go ahead and pull it ... My trans went out yesterday and I found one and wantto make sure it fits before I buy it. ... Used GMC Yukon Denali".

    Is The Transmission In A 1999 Gmc Yukon And ... - CarGurus

    www.cargurus.com > Questions > GMC > Yukon Denali

    CarGurusAug 15, 2014 - Is the transmission in a 1999 gmc yukon and a 2000 Yukon Denali the same. ... Does anyone know where I can get a fairly cheap used motor from in or ...Need a good fairly cheap motor for my 99 Gmc Yukon Denali 5.7L V8.

Jan 26, 2016 | GMC Cars & Trucks

1 Answer

How do I change the fuel pump relay on a 2000 gmc jimmy


This might apply .. but it for a 1999 Jimmy:
Electronic Fuel Pump Computer Problem6 Cyl Four Wheel Drive


Your symptoms could also be do to other issues ... not just the fuel pump relay. Read the embedded link within the 2carpros response.

Good luck with your troubleshooting

Jan 17, 2018 | 1999 GMC Jimmy

1 Answer

2003 gmc yukon acts like its not getting fuel. I have replaced the fuel filter but still have the same problem. If you spray starter fluid in it, it will start up and run, sometimes rough and sometimes...


A fuel filter won't fix anything

Just like replacing a blown fuse does nothing

You need to diagnose the problem first

It may act any number of ways to you

Have you confirmed fuel pressure on a gauge
or looking at scan tool software?

Does the pump come on when it doesn't start
& what does the gauge say when you cycle the key?

Do you have a check light on dash or stored codes
you can only see on professional scan tool?

Do you even know how long the spark plugs are
in the motor or looked at fuel trim,or module voltage,
or O2 sensor data?

Right now it sounds as though you have no knowledge about
vehicles & haven't actually done anything

What does work & how do you know that

You have to test the entire truck,then work on the faults
you find

Jun 11, 2012 | 2003 GMC Yukon

1 Answer

When driving at slow speed especially, a very loud squeel comes from the front end of my 2003 youkon xl denali. the sound goes away when the brakes are applied.


Check the brake pads. There is a metal tab on the pads called an indicator. When the pads get low the indicators will start to rub and make an annoying screech to let you know it's time to replace the pads. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Jan 20, 2012 | 2003 GMC Yukon Denali

1 Answer

My 1999 gmc yukon denali won't shift out of park


Check the brake switch. The brake switch releases the locking pin for the shifter when you apply the brake. Common problem with GM. Turn the key on, apply the brake on and off and listen to see if you hear a click in the steering collumn. Do this a few times to make sure you can hear it. If you can't then the switch is bad.

Jul 13, 2011 | GMC Yukon Denali Cars & Trucks

1 Answer

I have a 99 yukon gmc and it will start clicking when i put it in r to d


The most common cause of this is worn out drive-line universal joints.

Jul 01, 2011 | GMC Yukon Cars & Trucks

1 Answer

2001 gmc yukon xl was jerking, cut off. will not start.


it sounds like the fuel pump might have died, or blew fuse or relay see if it gets fuel at the motor

Feb 12, 2010 | 2002 GMC Yukon XL

3 Answers

Gmc yukon has the abs & parking brake light


you have to fix the problem with ur brakes- first check the wiring ,connectors and connection clips to the abs sensors and modulator if looks ok than have truck scanned some auto stores such as auto zone / advanced auto do it for free the code will give u a start point towards fixing ur problem--visual inspection of brakes doesnt always show problem

Nov 26, 2009 | 2001 GMC Yukon Denali

Not finding what you are looking for?
1999 GMC Yukon Logo

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...