Question about 2007 Cadillac STS V Sedan

Open Question

How do I remove the seat control panel on my 2007 Cadillac sts

Remove seat panel

Posted by Anonymous on

Ad

6 Suggested Answers

Anonymous

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 10 Answers

SOURCE: how do you set the

My car (Acura 3.5RL) has memory seats. What I do is set the seats and side view mirrors up the way I like, then press the driver #1 button and hold it until I hear a beep.

Posted on Jan 16, 2009

Ad

Anonymous

  • 1 Answer

SOURCE: car wont start

The start button has an accessory position, that is active when you depress it in a downward manner. You will see a small lamp indicate the "ON" condition. To turn it off, just press it upward, the lamp will go off.

Posted on Feb 19, 2009

Anonymous

  • 12 Answers

SOURCE: How to remove drivers door panel from 1997 Cadillac Deville.

try to look at stress point on door by handle normally two screws and under neath panel to screws also disconnect side panel for side mirror door of using panel popper

Posted on May 23, 2009

ZJLimited

ZJ Limited

  • 17970 Answers

SOURCE: Where can I read, for free, how to remove the

GM Cadillac Deville_Fleetwood_ELD_Seville 1990-1998

Door Panels - REMOVAL & INSTALLATION

FRONT DOOR

7b8295a.jpg

Fig. Front door panel-1990-91 Deville and Fleetwood

f86aba7.jpg

Fig. Front door panel-1992-98 Deville and Fleetwood

ea63dcb.jpg

Fig. Carefully pry up the power window switchplate and . . .

5e6e08a.jpg

Fig. . . . gently remove it from the door panel

42aebbe.jpg

Fig. Remove the door pull strap retaining screw covers by gently prying them off

342330d.jpg

Fig. Remove the door pull strap retaining screws

b4ba006.jpg

Fig. Gently pull the inside door handle panel down and . . .

6a6b4b0.jpg

Fig. . . . release the rod from the handle

435710f.jpg

Fig. Carefully lift up the door panel to release the . . .

aa0d077.jpg

Fig. . . . retaining pegs on the door panel

9275228.jpg

Fig. Do not pull the panel too far away from the door, as some components still have wiring harness connected

a232e57.jpg

Fig. Detach any necessary wiring connectors and remove the door panel from the vehicle

  1. Disconnect the negative battery cable.
  2. Insert a flat-bladed tool between the door panel and the rear edge of the power window switch plate to disengage the retainer from the panel.
  3. Slide the power window switch plate forward, then label and detach the wiring connectors.
  4. Remove the power door lock switch plate retaining screw. Remove the switch plate and detach the wiring connector.
  5. Remove the pull handle retaining screws.
  6. Using a thin-bladed tool, carefully pry the courtesy lamp lenses off. Remove the courtesy lamp bulb.
  7. Pinch the courtesy lamp retainers and pull out the lamp socket holder. Detach the courtesy lamp wiring connector.
  8. Remove the door panel retaining screws.
  9. Using tool J-2459B or equivalent, disengage the door panel fasteners from the holes in the door. Detach any remaining wiring connectors and remove the door panel.
To install:
  1. Position the door panel close to the door and attach the wiring connectors.
  2. Align the door panel fasteners with the holes in the door. Push in on the door panel to install it to the door.
  3. Install the door panel and pull handle retaining screws.
  4. Install the courtesy lamps and switch plates.
  5. Connect the negative battery cable.

I really hope help you with this (remember rated it) Good luck.

Posted on Oct 12, 2009

Testimonial: "finallly someone shows me HOW! Thanx. Great detail. Love it."

Anonymous

  • 117 Answers

SOURCE: how do you remove the door panel on a 2005 cadillac sts

2 screws located under trim panel at pull handle where u close door another screw at handle (door open) under trim cover. then plastic retainers hold panel to sheet metal. slide flat bladed preferebly plastic tool between trim and door and pry out words at retainer

Posted on Nov 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I remove the Back Seat Back from my 2001 Cadillac STS


Remove the seat cushion and the seat back is bolted on each side.

May 13, 2016 | 2001 Cadillac Sts

2 Answers

Trunk fuse 2006 sts


The fuse is located under the rear seat in the fuse box.Trunk/valet fuse.

Feb 04, 2015 | 2006 Cadillac STS

1 Answer

95 Cadillac STS fuse location for the ride control


educated guess.. but i think the fuse panel in the trunk against back of rear seat

May 15, 2013 | Cars & Trucks

1 Answer

My driver seat wont move on my 2006 cadillac sts


power seat motor is probably bad it is a 2006 we are talking about cadillac isnt that good lol i wish car companies made parts that lasted forever but they dont maybe in the future......

Mar 20, 2013 | 2006 Cadillac STS

1 Answer

The driver power seat on my 2005 Cadillac STS have stopped working. I have changed the fuses and relay switch and it's still not working what could it be?


If non of the power controls for that seat are working, then I would check the plug under the seat and make sure it hasn`t come loose. Hope this helps

Please take a moment to rate my answer............Thanks

Dec 01, 2010 | 2005 Cadillac STS

2 Answers

How to set memory on seats


adjust seat and steering to comfortable position press set and 1 on drivers door,position will be put into memory. put seat and steering into position that it is easy to get out of car, press exit 1 and the exit position will be in memory. do same procedure for driver2.

Apr 10, 2009 | 2006 Cadillac STS

1 Answer

1998 cadillac seville STS


on my 1998 Deville its located in the trunk. the panel thats is butted up to the back of the rear seat. look for some black nuts around the top of rim of the trunk, they are about 1'' long, these have to be removed first... good luck.....

Mac.........

Mar 09, 2009 | 1998 Cadillac Seville

1 Answer

How do you set the driver 1 seat position in a cadillac sts?


My car (Acura 3.5RL) has memory seats. What I do is set the seats and side view mirrors up the way I like, then press the driver #1 button and hold it until I hear a beep.

Dec 28, 2008 | 2007 Cadillac STS V Sedan

Not finding what you are looking for?
2007 Cadillac STS V Sedan Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...