Question about 2013 Buick - LaCrosse

1 Answer

How to program a 2013 buick Lacrosse key rob I have one key fob but want to get another so I have two for the car

My fob has remote start five bottons

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Buick Master
  • 906 Answers

This can be done at the dealer.

Posted on Dec 19, 2014

Ad

3 Suggested Answers

honeymokey

honeymokey

  • 3113 Answers

SOURCE: just programed a new fob remote to my 1998 buick

Try another key if you have two.

Posted on Jun 15, 2009

Ad
Molson02536

Harvey N Tawatao

  • 3854 Answers

SOURCE: programing instructions for buick 2006 lacrossekeyless remote fob

Transmitter ProgrammingImportant: All transmitters which are to be recognized by the remote control door lock receiver (RCDLR) must be programmed in a single programming sequence. If the system is placed in program mode it will erase all previously programmed transmitters upon the receipt of the programming signal from the first transmitter. Up to 4 transmitters can be programmed. Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. This prevents the programming of the transmitters to the incorrect vehicle.

  1. Install a scan tool.
  2. Use the scan tool in order to access programming: Vehicle Control System/Computer Integrating System/Module Setup/BCM/Program Key Fobs.
  3. Press the START soft key on the scan tool. Important: The scan tool must stay connected until all of the transmitters are programmed.
  4. Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of 5-10 seconds, the scan tool will indicate that the transmitter is programmed.
  5. Repeat the previous step in order to program up to 4 transmitters.
  6. Remove the scan tool.
  7. Operate the transmitter functions in order to verify correct system operation.
Good luck

Posted on Dec 13, 2009

saailer

David Burbee

  • 1871 Answers

SOURCE: does my 2005 buick lacrosse have remote start

Hello! There is a Service Parts Identification sticker located either in the glove box or near the spare tire with a list of three alphanumeric codes...If the sticker has "AP3" that means your Buick has remote start...

Guru...saailer

I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

Posted on Apr 30, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2004 Town and country van had to be jump started and now key fob won't lock or unlock doors.Took key fob to locksmith he said key fob was working, van was not reading signal and he didn't know what


The fob may need to be reprommed to the car. Do the following:

Grab your working remote. Push the LOCK button five times, allowing exactly two seconds to pass between each press of the LOCK button. Insert the ignition key and turn it to RUN. Push and hold UNLOCK on the working remote for 6 seconds. Push and hold PANIC for one second while continuing to hold UNLOCK. Release both buttons at the same time.
Push any button on the remote to program it. Then push any button on the remote that was already programmed. It has to be reprogrammed. The remote is now programmed to the vehicle. Turn the key to OFF.

Oct 28, 2014 | Cars & Trucks

1 Answer

Does the remote key for push button start have anything to do with it not starting


If the remote is damaged the car might not start. If battery in remote is dead it also might not start. However, there should be a key fob slot somewhere inside the car ( usually around the driver side knee area or inside center console ). I never worked on a 2013 Accord so I don't know the exact location, but your Service Manual should show you exactly where it is located. From my experience with Nissan dead key fob has to be in slot for car to start. Lexus/Toyota you have to tap push button START/STOP couple times with the remote fob for it to start.

Sep 22, 2014 | 2013 Honda Accord

1 Answer

How to reprogram a key fob for a 2006 ford 500


You are in luck! You can program a 2006 Ford Five Hundred key fob yourself and don't need to go to a dealer or professional. The steps are pretty easy, it's the timing of the steps that you have to pay attention to. You most likely will not get the programming correct on the first try, keep at it, you will get it.

Here are the key fob programming instructions for a 2006 Ford Five Hundred:
*** THERE ARE 2 POSSIBLE PROGRAMMING PROCEDURES. ***Procedure #1Note: Obtain all remote transmitters for this vehicle.
Note: Do not depress the brake pedal during procedure.
  1. Turn ignition from OFF to RUN 8 times within 10 seconds, with the 8th time ending in RUN. Door locks will cycle to confirm programming mode. (Off is the position where you can remove your key, RUN is the position just shy of starting your car.)
  2. Within 20 seconds press any button on the first keyless remote to be programmed. Door locks will cycle to confirm programming. If you only have one remote then skip to step 4.
  3. Within 20 seconds, press any button on the second keyless remote. Door locks will cycle again to confirm programming. Repeat step 3. For all other remotes.
  4. Turn ignition to OFF. Locks will again cycle to indicate end of programming mode.

    Procedure #2Note: Obtain all remote transmitters for this vehicle.1Fasten seat belts and close all doors.
  5. Turn ignition from OFF to RUN 4 times within 6 seconds, with the 4th time ending in RUN. (Off is the position where you can remove your key, RUN is the position just shy of starting your car.)
  6. Turn ignition to OFF. Acoustic signal will sound and system warning lamp will illuminate to confirm programming mode.
  7. Within 10 seconds, press and hold any button on the first keyless remote. Wait for acoustic sound and warning lamp to flash (confirming programming) then release button on remote. Wait 2 seconds but within 10 seconds repeat step 4. For all other remotes. If you only have one remote then continue to step 5.
  8. Turn ignition to Crank or wait 10 seconds to end programming mode.
Make sure you have a spare key fob too. You can save a bunch of money ordering a spare key fob online at:
https://www.keylessentryremotefob.com/Ford-Five-Hundred-Remotes-and-Keys-s/5167.htm

Apr 12, 2014 | 2006 Ford Five Hundred

1 Answer

Car wont start turn key nothing happens


1. Try locking and unlocking of the doors five times with the remote to reset the immobilizer.

2. Key in ON position push Open button on key fob.

Jan 29, 2014 | Saab 93 Cars & Trucks

1 Answer

Saab 9-3 1999 Car wont start turn key nothing happens


1. Try locking and unlocking of the doors five times with the remote to reset the immobilizer.

2. Key in ON position push Open button on key fob.

Jan 29, 2014 | 1999 Saab 9-3

1 Answer

Remote will not unlock doors can not unlock from inside


- Sit in the car with all the doors shut and windows up with your key fobs (all your fobs need to be done at the same time)
- With one of your keys turn the ignition on then off and remove the key
- Press and hold the unlock botton and then press the lock button 3 times.
- Release all buttons and the locks will bounce up and down.
- Repeat this with the other key/keys (press and hold unlock and press lock 3 times, locks will bounce)

Note: Only switch your ignition on once, doing so again while programming will reset the process and you will have to start again.

Jan 15, 2013 | 2003 BMW 5 Series

1 Answer

Need to remove the starter motor


Gather all of the fob remote car starters for your car, unless you only have one. Insert your key into the ignition turn it to the "On" position --- right before actually starting the car, the lights should turn on. Press and hold the "Lock" button on your fob remote car starter for one second. Turn your key to the "Off" position --- the car lights should turn off. Do this within five seconds of turning the key to the "On" position and don't remove the key once you've turned it to the "Off"...
-----------------------------------------Car Diagnostic software

Nov 14, 2012 | 2002 Mazda Tribute

1 Answer

2003 kia sorento keyless entry not working


If both remotes light up and don't work even right next to the car, the car and remotes may need to be paired again. I found where someone mentioned disconnecting the car batter for more than one minute but less than five and seeing if it works again. If not, you may have to get it checked at a dealer. Most of these fobs are only programable with special tools at the dealer. I've purchased nissan oem fobs new on ebay, but still had to pay the local dealer to get them to work.

Apr 17, 2017 | 2003 Kia Sorento

1 Answer

Program new key fob for a ford fivehundred


You are in luck, a 2005 Ford Five Hundred Key Fob Remote is self programmable. Now these procedures can be a bit frustrating at times, so be patient, it's all about timing. If you get it programmed on the first try you are among a very few talented programming individuals! Also, if you need an affordable key fob replacement for your Ford Five Hundred, buy it here:
https://www.keylessentryremotefob.com/Ford-Five-Hundred-Remotes-and-Keys-s/5167.htm

Here are the programming instructions:

FORD REMOTE - THIS PROCEDURE RESETS ALL REMOTES FOR THE VEHICLE. ALL FUNCTIONING REMOTES WILL HAVE TO BE REPROGRAMMED DURING THE PROCEDURE There are a few different procedures that will program your remotes depending on what vehicle that you have. You can find your exact procedure in your owners manual. If you do not have your owners manual you can try any of the procedures below until you find the one that works for your vehicles
Make sure that you don't press the brake pedal at any time during or before the procedure.
Procedure A:
1.Close all doors, then open drivers door and press the Unlock button on driver's door while it is open, insert key into ignition.
2.Turn ignition from OFF to RUN 8 times within 8 seconds, with the 8th time ending in RUN. Door locks will cycle to confirm programming mode. (if the door locks do not cycle, then it was done incorrectly. You must start over by removing key and beginning from step 1)
(Off is the position where you can remove your key, RUN is the position just shy of starting your car.)
3.Within 10 seconds press any button on the first keyless remote to be programmed. Door locks will cycle to confirm programming. If you only have one remote then skip to step 5.
4.Within 10 seconds, press any button on the second keyless remote. Door locks will cycle again to confirm programming. Repeat step 4. for all other remotes.
5.Turn ignition to OFF. Locks will again cycle to indicate end of programming mode.
*If this does not work try the procedure with the door closed.
Procedure B:
1. Fasten seatbelt and close all doors
2. Turn the ignition from OFF to RUN 4 times within 3 seconds.
3. Turn the ignition OFF. The system will chime to confirm programming mode.
4. Within 10 seconds, press and hold any button on first keyless remote. The system will chime once to confirm programming.
5. Within 10 seconds, press and hold any button on second keyless remote. System will chime once to confirm programming.
6. Turn ignition to RUN to exit programming mode.
Please note: All steps should be performed in fairly rapid succession. If you never get the initial chime or door lock cycle, that means the vehicle has never entered programming mode. You should remove key from ignition, open and close the door and start over.


4001-ford-image-1-44ys2bzxdezw1orb312ruqfb-2-0.jpg oucd-4b-image-1-44ys2bzxdezw1orb312ruqfb-2-2.jpg

Mar 27, 2012 | 2005 Ford Five Hundred

2 Answers

Broken key fob


bought second hand fob now being reprogramed

Apr 12, 2009 | 1997 Honda Accord

Not finding what you are looking for?
2013 Buick - LaCrosse Logo

299 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...