Question about 2000 Daewoo Nubira

Open Question

Key remote dose not working

Hi the center system is working but key remote dose not working how can i reactive again or how can resolve this problem thanks Amr

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How do I reset the alarm on a 2005 hyundai Santa 2.4l


Not sure about yours, but many will reset by: turn key to "on" and wait 15 minutes or so; shut off, then try to start.

Apr 15, 2016 | Hyundai Cars & Trucks

1 Answer

Key


i would get the OBD codes read by a mechanic as this should pinpoint the sensor/switch that is causing the problem

May 06, 2014 | 2003 Audi TT

1 Answer

2001 pontiac grand prix trunk release dose not work remote or inside car no power at release in trunk.


Sounds as though the motor may have quit working, check your fuse or the relay in the underhood power center. The key still works correct? Do you hear any noise when you try the remote switches? If you do the rods may have come loose or the holders may have broken.

Feb 16, 2011 | 2001 Pontiac Aztek

2 Answers

Must use the key to open the door. Once it has been unlocked, the remote will work to lock and unlock the doors. After a short period of time the remotes will not work again and must use the key again to...


Hi and welcome to FixYa!

Looks like that you have a faulty door lock actuator that's why it's not responding with the remote. If the actuator is faulty it tends to trip, sometimes will open sometimes won't. Using the key will surely lift the locks upward and by then the actuator can work again.

Have the door lock actuator replaced and you'll be good.

Hope this helps and thank you for using FixYa! Have a good one!

Jan 26, 2011 | Chevrolet Avalanche Cars & Trucks

2 Answers

How to deactivate car alarm?


I have not a car but my father has a car and i knew that m father went to the car and was stayed yto there until alarm was stoped crying

May 01, 2017 | 1998 Ford F150 Regular Cab

1 Answer

The remte control key is not responding with the car


Hi abdumi0f,

Firstly, open your glove box and make sure Valet Mode is not enabled, if it is not, follow these steps.

Step 1: Open drivers door and leave open.
Step 2: Lock and unlock the driver’s door using the power door lock switch on the door.
Step 3: Insert key into the ignition.
Step 4: Turn key to on position and return to off position. (IMPORTANT - use ON position NOT ACC position). Do this 3 times within 10 seconds. Leave key in the ignition.
Step 5: Open and close the driver’s door 3 times. (Door should be left open after this step).
Step 6: ECU should respond by locking and unlocking the doors.
Step 7: Press any button on remote #1 twice. ECU responds by locking and unlocking the car doors.
Step 8: Press any button on remote #2 (etc.) twice. Each time the ECU will respond by locking & unlocking the doors.
Step 9: Remove the key from the ignition and the ECU will respond a final time with a series of door locks and unlocks. You're done!

Hope this helps,

Lazaruselite

Feb 24, 2009 | 2007 Mercedes-Benz E320 BLUETEC Sedan

1 Answer

Remot control key is not communicating with car at all.


It is possible that the receiving unit on the vehicle is not operating properly. Whether that means a broken wire, bad circuitry in the receiver, or other problems it could the case, BUT more often than not, the key/remote was exposed to some kind of magnetic or high power field, effectively remdering the unit useless. Strong magnets, electromagnetic fields or even staying to long on a department store demagnetizer could lead to these problems. Go to the dealer and be prepared to take the hit, a replacement coded key can run several hundred dollars, but unless you swapped the battery and happened to get a bad new battery, than the dealer is the only solution, I hope this brief explaination shed a little light for you in the future.

Feb 24, 2009 | 1999 Mercedes-Benz E-Class

1 Answer

My security remote dose not work


Hello, It seems as is if you have a remote that will not lock the doors all the time. There can be a couple of reasons that it wont work at times.1 it may have a weak battery,2 there may be some kind of residue inside the key fob itself such as tea,coke,water, or even sweat. This will short the fob out at times.Thank you

Feb 22, 2009 | 2005 Buick LaCrosse

Not finding what you are looking for?
2000 Daewoo Nubira Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daewoo Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Marvin
Marvin

Level 3 Expert

85223 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

459 Answers

Are you a Daewoo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...