Question about 1993 Chevrolet S-10

1 Answer

1993 chevorlet s10 truck 2.8 5sp. small starter wires,from harness to solenoid.need to know witch wires go where.is the wires differant sizes? mine have been spliced.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Chevrolet Master
  • 373 Answers

Wires to the solenoid are generally smaller yes. Typically from ignition switch to solenoid is purple.

Posted on Jul 26, 2016

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 2 Answers

SOURCE: Chevrolet Blazer S10 1993

i recomend getting a book from the auto parts store. it will have all the electrical diagrams. it costs less than $20.00 and will be a good investment. i have a book for all my cars and have never had to go to a shop.

Posted on Jul 09, 2008

Anonymous

  • 86 Answers

SOURCE: need factory wiring codes

2003 Chevrolet Silverado 1500 Car Radio Wiring Diagram
Car Radio Battery Constant 12v+ Wire: Orange
Car Radio Accessory Switched 12v+ Wire: The radio harness does not provide a switched power source. Run a wire to the fusebox for switched power.
Car Radio Ground Wire: Black/White
Car Radio Illumination Wire: Gray
Car Stereo Dimmer Wire: Brown
Car Stereo Antenna Trigger Wire: Pink
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: Under the center console.
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Tan
Left Front Speaker Negative Wire (-): Gray
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Dark Green
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue
If that dosnt match with your vehicle try this tip, 1st always find your speaker wires first,Since this is the most tedious part, its better to get those out of the way, 2nd thing Disconnect the battery of the vehicle so you don't blow fuses for the head unit, 3rd, strip back all of the wires that are available to you. Its better to grab the all together and cut them all an equal length to make it neat. 4th
Once you have all your wires stripped back - Grab any single wire. Hold it against a terminal on the battery and one by one go through and tap every other wire against the other terminal of the battery until you hear a "pop". When you hear a speaker popping, you have correctly identified the wires that run directly to it. If on the first attempt at popping a speaker you don't find one, pick up another wire and repeat the process. They will eventually come, and the more you identify, the fewer wires you have to mess with, You will need these Items,You'll need some wire strippers, a digital multimeter, electrical tape,9 volt battery

Posted on Oct 18, 2008

Anonymous

  • 22 Answers

SOURCE: need a wiring diagram for 1994 s10 blazer 4.3 vortex

that's simple --got a printer
well free create a free log on autozone.com
next let your fingers do the walking --point and click --better than a HAynes or Chilton ---will be vehicle and engine specific --another note woth making --if the vacuum diagram ever peals off in the engine bay/fan shroud --you can get that off the site too --I'd suggest downloading and saving or print it and keep it in the glove box ---at some point you WILL need it
there are up to 4-5 diagrams available for the blazer ---print them all if need be then compare a few color coded wires and BAM --you found the right one ---easy peasy
all free
if this helps write a review--free advice and I am RIGHT
that's where I go for that stuff and seemingly only there --I don't buy their product RARELY either --I use rockauto.com
HAWK

Posted on Apr 06, 2009

emissionwiz

Marvin

  • 85216 Answers

SOURCE: puttin new speakers i dont know what color the stock speaker wires are

2002 Chevrolet S10 Pickup Car Stereo Radio Wiring Diagram
Car Radio Constant 12v+ Wire: Orange
Car Radio Switched 12v+ Wire: Dark Green
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Gray
Car Stereo Dimmer Wire: Violet/White
Car Stereo Antenna Trigger: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Front Speakers Size: N/A
Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Tan
Left Front Speaker Negative Wire (-): Gray
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Dark Green
Rear Speakers Size: N/A
Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue
-->

Posted on Apr 16, 2009

Anonymous

  • 1 Answer

SOURCE: 4 wire ac delco alternator harness dont know whats what.

http://www.delcoremy.com/pdfs/service_manuals/legacy/1G-290.pdf

Posted on Apr 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

SCHEMATIC STARTER FOR 1993 CHEVY SILVERADO PICKUP


The small wire from the ignition switch goes to the small post on the starter solenoid. The large wire from the battery goes to the large post on the starter solenoid.

Jun 30, 2015 | Cars & Trucks

1 Answer

How do I know if I miss wire my starter


Oh, it will let you know, and maybe in a not too nice way. So be sure!
How many wires do you have for your starter? Most have only two- a big battery cable end and a small wire for the solenoid mounted on the starter.
The big wire should be obvious where it goes on a stud and is tightened down with a nut. Only the big wire goes there, no others with it. Now on the solenoid on the starter there shouyld be a small stud or two with some very small nuts on them. The one with two nuts is the one the small solenoid wire hooks over and is tightened down with the outer small nut. GM used to have a standard color, purple, for the small solenoid wire. If you happen to have another small wire, put them together on the same stud.
If your starter is a little different, or still unsure, have somebody check it before you hook up the battery and try it. You may also have different connectors than rings that slip over studs.

Nov 26, 2012 | 2000 Oldsmobile Silhouette

1 Answer

Starter solenoid on 1993 Ford E350 nwith 7.5 liter v8. Solenoid went bad, new auto parts store replacement, doesn't work right. When I turn the key to first click, the starter engages and the solenoid...


It sounds like the small tickler wires may be reversed to the Solenoid.

If no success, call Itasca and ask if there were any changes for this Solenoid. There are several types of Solenoid with the grounding being the major internal difference. Most likely your wires are switched.

May 25, 2010 | Ford E-350 Cars & Trucks

1 Answer

Need a wiring diagram/picture for the start solenoid on a 1996 Chevrolet Cavalier 2.2L automatic. There are 2 fusible links, the positive battery cable and two other wires. 4 wirese come out of the harness...


There should be one wire with a small eyelet connector on it, this is the starter field wire from the ignition switch and it should be connected to the small terminal on the starter solenoid marked "S" (this wire is usually purple, but it can also be red or pink)

All of the other wires to the starter including any fusible links, will have a larger eyelet connector on them, and they will all connect together with the battery cable, to the large upper terminal on the starter solenoid, sometimes marked "BAT".

May 03, 2010 | 1996 Chevrolet Cavalier

1 Answer

I need to replace my starter on my 1993 honda civic... Help?


  1. Disconnect the negative battery terminal and the starter motor cable at the positive terminal.
  2. Remove the engine wire harness from the harness clip on the starter motor
  3. Disconnect the cable from the B terminal on the solenoid, and the BLK/WHT wire from the S terminal.
  4. Remove the starter motor by loosening the two attaching bolts.
  5. To install, reverse the removal procedures: re-position the starter in place, replace bolts, tighten the starter-to-engine bolts to 32 ft. lbs. (45 Nm).
  6. Make sure that all wires are securely connected.

Mar 20, 2010 | 1993 Honda Civic 4 Door

1 Answer

Just how hard is it to replace the starter on a 94 Suburban 5.6L diesel myself? Looks fairly easy.


Obtain new or rebuilt unit. Might also replace the solenoid while you have the starter removed but this will have to be your desicion.
Disconnect the negative battery cable from the battery to prevent 'welding' while under the vehicle.
You may need to ellevate the vehicle and properly support the vehicle while working under it. Your need will be determined by 4x4 vs 2x4 and your physical size and need for work 'room'.
The starter is located on the passenger side of the engine near the exhaust manifold. It is cylindrical in shape(About the size of a small coffee can if it a 'old' style, about the size of a pint can of beer if the 'new' style). There are two bolts(Mine were 14mm heads yours may vary) holding the starter to the engine block. These will need to be removed and the starter supported. Then the wires to the solenoid can be removed. There are generally Two wires to the solenoid. These will require a 5/16" and a 9/16" socket or wrench but yours may be different.
Reverse the proceedure to install the new unit.

Jul 06, 2009 | 1994 Chevrolet Suburban

4 Answers

My 91 jeep won't start...


The Starter relay is bad.

May 05, 2009 | 1991 Jeep Wrangler

2 Answers

I just put a transmission from a 1994 chevy 1500 onto my 1993 chevy 1500. it fit perfectly but the wiring harness is different. is there an adapter for this application? if so, and i install it will i need...


what color is the inside of the trans connector on the trans itself? I believe the 93/94s were a tan yellowish color. 1995 and up are different and won't work - electronics are different

If they have exactly the same amount of solenoids, you could switch the harnesses.... but it sounds like you have a 95 or newer trans which would have one more solenoid

Apr 11, 2009 | 1993 Chevrolet C1500

2 Answers

1993 Ford Explorer battery was stolen and they cut all the cables


which wires ? the ones connected to the battery? or the wiring harness? if it's the battery cables then the large wire is the positive side normally red and the negative side is black and is half the size of the positive wire. The battery will have a + and a - on it so you know that the positive wire is + the larger wire and the smaller is black.

Mar 28, 2009 | 1993 Ford Explorer Limited

1 Answer

1993 nissan altima starts sometimes other times it does not crank over battery is good also installed new ignition switch


Could be the starter. Also how are your batter connections? Nice and tight and clean?? If so than check the single wire going into the starter. Not the battery cable, but the small wire that goes into the solenoid. Unplug that wire and put volt meter into the connector on the harness side and check for 12V, while you turn the ignition to "START" position. If 12V is present, suspect the starter.

Mar 01, 2009 | 2002 Nissan Altima

Not finding what you are looking for?
1993 Chevrolet S-10 Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...