Question about 2001 Oldsmobile Intrigue

Open Question

Where is the coolant air charge temperature sensor located on a 2000 ols intrigue 3.5 liter

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Carlos Rojas

  • 119 Answers

SOURCE: 99 oldsmobile intrigue

The ambient temperature sensor going bad causes this exact problem. I've replaced many of them because when they show outside temp as being below 60 degrees, the A/C control module will shut the compressor off.

Posted on Aug 08, 2008

Ad

Jonathan Dawson

  • 50 Answers

SOURCE: crank position sensor location

you will need to remove the starter to gain acess to the ckp sensor. once you remove the starter look on the engine block and you will see the sensor. The only problem with doing this repair yourself is that you will not be able to preform the crankshaft position variation learn procedure with out a factory scan tool. The vehicle may crank an run, but the timing advance curves will be wrong so the vehicle will probably cut off every time you remove your foot from the gas pedal. Hope this info helps!

I’m happy to assist further over the phone at https://www.6ya.com/expert/jonathan_3a3c556b4b17d1d2

Posted on Aug 18, 2008

jagjeffery

Jeffery Lewis

  • 329 Answers

SOURCE: Would like to know where cabin air filter is located?

your cabin air filter is located under the windshield wiper cover on the passenger side of car open your hood to see the access panel

Posted on May 29, 2009

Anonymous

  • 1 Answer

SOURCE: Can anyone tell me where the fusebox is for the 2000 Oldsmobile Intrigue.

fastboyz is correct. There are two fuse panels. One in the engine area near the battery as he describes. The other one is on the passenger side at the end of the dash board. You have to open the passenger door. If you look at the dash board you will see a panel box cover built-in to the dash. The cover fits the contour shape of the dash. Pull on the cover and that will expose the fuses.

Posted on Sep 01, 2009

duane_wong

Duane Wong

  • 6826 Answers

SOURCE: How do you replace coolant temperature sensor on

Removal & Installation To Remove:
ECT sensor 3.5L engine 93174g14.gif

  1. Disconnect the battery ground cable.
  2. Drain the coolant below the level of the engine coolant temperature (ECT) sensor.
  3. Disconnect the ECT sensor electrical connector.
  4. Carefully remove the ECT sensor.
To Install:
WARNING
Damage to the coolant sensor will affect the operation of the fuel control system.
  1. Coat the ECT sensor threads with thread sealer.
  2. Install the ECT sensor. Tighten the sensor to 15 ft lb (20 Nm) on 3.5L engines and 22 ft lb (30 Nm) on 3.8L engines.
  3. Install the ECT sensor electrical connector.
  4. Connect the battery ground cable.
  5. Refill the cooling system using the recommended procedure.
prev.gif next.gif

Posted on Aug 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location of engine coolant temperature temperature sensor


Most parts stores have a part location chart in their system and can probably help you. On most vehicles this sensor in near where the top radiator hose goes into engine. There are 2 temp sensors--hte one with one wire usually supplies the dash gauge or lamp, the one with two wires is for the ECU.

Mar 03, 2016 | 2000 Ford Escort

1 Answer

Where is the engine temp sensor located in a 94 dodge spirit. 2.5 liter car


It doesn't show an 'engine temperature sensor' for that year, make and model
What you do have is a Coolant Temperature Sensor (there are actually one of each on other makes and models - an engine temperature sensor and a coolant {radiator fluid} sensor). Just doesn't appear to be a separate engine temp sensor for the 94 2.5. The coolant temperature sensor is the sensor that will make your temp gauge in the car move. It's location is - Under hood, center, front engine area, near distributor, mounted in driver side of cylinder head. I've attached a pic of the sensor for you.

You also have an intake air temperature sensor and an ambient air temperature sensor that tells the computer the temp in the vehicle's cabin. I can shoot you that info if your question wasn't answered above.



Good Luck & All The Best, Justin Lee

25990321-2mxge42kl42e5tx0bsno1lhz-3-0.jpg

Dec 02, 2015 | Dodge Cars & Trucks

1 Answer

Where is the temperature coolant sensor located on a 2000 oldsmobile intrigue


3.5 liter v-6 located in coolant water manifold on drivers side of engine on rear cylinder head area.

Nov 09, 2013 | Cars & Trucks

1 Answer

Location of engine coolant temperature sensor


Automobiles: 2000 Ford Escort ZX2 4-cylinder 2.0L MFI DOHC

NOTE
The "left" side of the engine is the driver's side.

The Engine Coolant Temperature (ECT) sensor is a thermistor (a device which changes resistance or voltage as temperature changes). The sensor detects the temperature of engine coolant and provides a corresponding signal to the PCM (Powertrain Control Module - aka "the car's computer").

The ECT sensor is mounted in the following locations (small Ford engines):

1.8L engines: in the cylinder head
1.9L engines: threaded into the heater hose inlet pipe
2.0L engines: at the left rear of the engine

2.0L Zetec Engine

(1) Partially drain the engine cooling system using a clean container. If coolant is in good condition, retain for reuse.
(2) Disconnect the battery ground cable.
(3) Disconnect the electrical wiring connector from the engine coolant temperature (ECT) sensor.
(4) Remove the retaining clip and the ECT sensor.


12_5_2011_5_38_05_pm.jpg

Fig. 1 Escort ZX2 ECT sensor - The retaining clip is removed (at the solid arrow). Withdraw ECT sensor by gently wiggling/pulling in the direction of the dashed arrow.

To install:

NOTE
Coat the ECT sensor O-ring with clean coolant prior to installation.

(1) Replace the retaining clip and the ECT sensor.
(2) Connect the electrical wiring connector from the Engine Coolant Temperature (ECT) sensor.
(3) Connect the battery ground cable.
(4) Refill the engine cooling system. An inexpensive plastic "Radiator Funnel" will help with this task.

Dec 05, 2011 | 2000 Ford Escort

1 Answer

Trying to locate coolant temperature sensor in 06 mazda 3


The coolant temperature sensor (ECT) is located on the coolant tube near the air filter housing, I have included a few diagrams to assist in helping you to locate this sensor. These diagrams are for the 3.0L engine.


asetech74_20.gif

asetech74_21.gif

Here is the location if this is the 2.3L engine


asetech74_22.gif

asetech74_23.gif

Sep 18, 2011 | 2006 Mazda 3

1 Answer

I need a diagram of the exhaust system on a Mazda 626


0996b43f80203328.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Component Location Chart-2000 MPV

1 PCM 2 Mass air flow (MAF)/intake air temperature (IAT) sensor 3 Throttle position (TP) sensor 4 Fuel tank pressure sensor 5 Engine coolant temperature (ECT) sensor 6 Crankshaft position (CKP) sensor 7 Camshaft position (CMP) sensor 8 Knock sensor 9 Heated oxygen sensor (HO2S) (front, LH) 10 Heated oxygen sensor (HO2S) (front, RH) 11 Heated oxygen sensor (HO2S) (rear, LH) 12 Heated oxygen sensor (HO2S) (rear, RH) 13 EGR boost sensor 14 Power steering pressure (PSP) switch 15 Main relay


0996b43f8020330c.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Component Location Chart-2001 MPV

1 PCM 2 Mass air flow (MAF)/Intake air temperature (IAT) sensor 3 Throttle position (TP) sensor 4 Engine coolant temperature (ECT) sensor 5 Crankshaft position (CKP) sensor 6 Camshaft position (CMP) sensor 7 Knock sensor 8 Heated oxygen sensor (HO2S) (front, LH) 9 Heated oxygen sensor (HO2S) (front, RH) 10 Heated oxygen sensor (HO2S) (rear, LH)* 11 Heated oxygen sensor (HO2S) (rear, RH)* 12 EGR boost sensor


0996b43f8020330f.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Component Location Chart- 2002-06 MPV

May 22, 2010 | 2004 Mazda MPV

1 Answer

Location of temp sensor on 2000 blazer


The ambient temperature sensor for the mirror display or outside temerature, is located between the grill and air conditioning condenser. The coolant temperature sensor is located in the left (drivers) side cylinder head.

Mar 03, 2010 | 2000 Chevrolet Blazer

1 Answer

I need to find the engine temperature sensor it makes operate the radiator fan''


2.0 Liter engine
Coolant Temperature Sensor/Switch (For Computer) Notes Engine Coolant Temperature Sensor 57445556
2.4 Liter engine
Coolant Temperature Sensor/Switch (For Computer) Notes 42377178
2.5 Liter Engine
Fig. 1 Engine Coolant Temperature Sensor 42402512

Dec 11, 2009 | 1996 Dodge Stratus

2 Answers

Where is the crankshaft position sensor located on a 2000 intrigu


Should be located around 11:00 on front of engine at crank pully.

Oct 28, 2009 | 2000 Oldsmobile Intrigue

Not finding what you are looking for?
2001 Oldsmobile Intrigue Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

Jonah Oneal

Level 3 Expert

14092 Answers

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...