Question about 2005 Kia Sportage

Open Question

Hi, trying to find wiring diagram for 2005 Kia Sportage v-6, automatic...Mass air Flow color codes. The boot was taped up but wires were loose and very easily pulled out. Didn't see the order.

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 kia sportage 4x4 never seen anything like it. changed plugs both coils and both plug wires all bad and still starting rough press on idle feels like not getting enough gas high idle sensor off.


-Not always the plugs and the coil case this. This can be cause by bad injector. Dirty mass air flow sensor.
-First Clean mass air flow sensor. If it's still do the same thing
then check the resistance of every injector. If it's not within its specification then replace it.

Good Luck

Mai

Jan 25, 2017 | Kia Cars & Trucks

1 Answer

2008 kia sportage v-6 it has multiplemisfire codes all on the same bank 1,3,5 any ideas?


needs to go to kia for diag wiring or pcm/ecm may be root of problem you can ck for bad bround wires and loose connectors but little else with out kia scan tools

Jul 29, 2012 | 2008 Kia Sportage LX

1 Answer

Misses sometimes, no power, transmition is hard when changing gears and slow advance hooked up there machine and it said mass air flow sensor will this make the transmition act up?


yes . because transmission shift points are mainly acheived through proper functioning engine and its components. if the engine light came on due to mass air flow sensor you may want to check the air intake tube for splits that will allow the engine to **** air in that the computer does not relate to the air flow sensor. the kia dealer get about $110.00 dollars for the tube but a good roll a black tape can do wonders on those splits.

Jul 13, 2011 | 1999 Kia Sportage

1 Answer

How to change plugs on 02 kia sportage


  • 1

    Keep a regular schedule for inspecting the spark plugs on your 2002 Kia Sportage. According to the official 2002 Kia Sportage owner's manual, spark plugs and ignition wires should be inspected every two years or 48,000 miles, whichever comes first.

  • 2

    Let your 2002 Kia Sportage sit for a few hours before opening the engine compartment. You want to make sure that the engine is cool before you begin working on it.

  • 3

    Pop open the hood of your Sportage and locate the ignition wires, which will be attached to the top of your engine. The 2002 Kia Sportage has a four-cylinder engine, meaning there are four spark plugs each attached to an ignition wire. The ignition wires run from the engine to the fuse box, which is located in the left side of the engine compartment.

  • 4

    Inspect the ignition wires of your 2002 Kia Sportage. These wires will need to be replaced if they appear worn.

  • 5

    Disconnect the ignition wire to your spark plugs. Grab the rubber boot located near the base of the wire and pull upward instead of yanking on the wire. Remove only one wire at a time, or mark the wires with a colored Sharpie marker before disconnecting all of them. Improperly reconnecting the ignition wires can seriously affect the performance of your Kia Sportage.

  • 6

    Attach the spark plug socket to your socket wrench. Use the socket wrench to remove the spark plug from the top of the engine's cylinder.

  • 7

    Inspect the spark plug. There will be some soot, but if the spark plug is completely covered in soot, it needs to be replaced.

  • 8

    Position your replacement spark plug in place and secure it with the spark plug socket on your socket wrench. Be careful not to overtighten the spark plug after it has been snuggly fitted.

  • 9

    Position the rubber boot of the proper ignition wire in place above the spark plug and insert it with your hands. Close the hood of your 2002 Kia Sportage

  • Mar 16, 2011 | 2002 Kia Sportage

    1 Answer

    2002 kia sportage loss of power, back firing,


    See that air intake pipe is not loose and the pipe has got no leaks. Make sure that the wires to the mass airflow meter that is inline with the air intake pipe is secure.

    Feb 25, 2011 | 2002 Kia Sportage

    2 Answers

    What causes dtc p0170 for a 05 kia sportage


    code po170 fuel system too rich or too lean bank 1. this is 5 possible causes 1. air leaks present in the exhaust manifold or exhaust pipes.2.air being drawn in from leaks in engine gaskets or other seals. 3.incorrect fuel pressure or one or more fuel injectors has failed. 4.front ho2s element is contaminated or has failed. 5.a fuel control sensor is out of calibration- baro sensor - ect sensor - iat sensor.

    Nov 24, 2009 | 2005 Kia Sportage

    3 Answers

    Where can i get wiring diagram for 2004 kia sorento


    i want to attach reversing sensors to my kia sportage 2005

    Nov 12, 2009 | 2007 Kia Sorento LX 4x4

    2 Answers

    Cannot find AIT sensor on 2005 Kia Sportage


    well if you mean iat it is part of the masflow air sensor system witch is on the air intake system may be in witch is hooked to the air cleaner box should round tube with wires going to it any way the code you posted is not right hope this helps

    Sep 24, 2009 | Kia Sportage LX Cars & Trucks

    Not finding what you are looking for?
    2005 Kia Sportage Logo

    Related Topics:

    134 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Kia Experts

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22485 Answers

    Marvin
    Marvin

    Level 3 Expert

    85222 Answers

    Jonah Oneal

    Level 3 Expert

    14092 Answers

    Are you a Kia Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...