Question about 2000 Buick Century
Backing plate ??? For the brakes ?
This video is for trail blazer , envoy ! All vehicles are pretty much the same , need speical tools !
1AAuto com PART 1 Replace Rusted Rear Brake Backing Plates Trailblazer...
Posted on Dec 16, 2017
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: buick century 2000 wipers
I found the following description on the web, this covers a bunch of the questions I was going to ask...
I own a 2000 Silo and wondered the same thing and do see some GM vans with this problem.
When I bought mine I also bought the Haynes Repair manual (1997 thru 2001 all models GM) #38036 to learn how to fix this and a LOT of other components in/on the van.
For $20 it's worth it.
To answer your question: If the wipers stop at the position they're in when the switch is turned off (Fail to park), disconnect the multi-function switch electrical connector. (This is located under the dash next to the firewall and steering column)
If the wipers now park, replace the multi-function switch. If the wipers still do NOT park, check the wiring from the wiper motor to the switch for a short circuit. If the circuits are good, replace the wiper motor.
Note: There are other adjustments needed for proper operation than just bolting and new motor on.
You can have a look at this manual at any automotive parts supply store.
Posted on Dec 06, 2008
The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.
Posted on Jan 04, 2009
yes you will you will have to take side trims and sill panel off get a 10 mm ready and take the bolts out the tail liaghts should come out the license lamps have screws in them and if you looka t them but you should be able to twist bulbs and pull them out / Please rate my response thank you very much
Posted on Jan 30, 2009
Tips for a great answer:
Jan 29, 2016 | 2000 Buick Century
Sep 18, 2015 | 2000 Buick Century
Feb 22, 2015 | Buick Cars & Trucks
Nov 09, 2012 | 2000 Buick Century
Jan 21, 2010 | 2000 Buick Century
Jan 11, 2010 | 2000 Buick Century
Sep 26, 2009 | 1999 Buick Century
Jul 01, 2009 | 2000 Buick Century
Apr 04, 2009 | 2000 Buick Century
Jan 02, 2009 | 2003 Buick Century
87 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: