Question about BMW Cars & Trucks

1 Answer

Where's the Crankshaft sensor located on 2005 BMW 745I

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • BMW Expert
  • 231 Answers

The sensor is located under the car on the passenger side of the transmission near the bottom of the bell housing. It is held in with a single bolt.

Posted on Sep 14, 2017

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
pal03246

Phil Lovisek

  • 726 Answers

SOURCE: crankshaft poistion sensor location for

Its right next to the passenger side drive shaft, where it goes into the transmission. Right above the drive shaft. It s black with green slider inside of the connector and it has 3 wires coming out of it.

Posted on Jul 24, 2008

Anonymous

  • 37 Answers

SOURCE: crankshaft position sensor location

Hello. One way to check if it is working is when you try to start the car does the needle move on you tac? If not then your crank sensor is more then likely the problem. It is located on the backside of the engine under the intake manifold. If is in about the center of the block. There will be a 10mm bolt holding the sensor in. If you decide to change it yourself (not to terrible of a job) unplug the sensor, remove the bolt and spin it back and forth slightly while pulling it out. It may be stoburn and you might have to work at it for a little bit (not a done of room) but it will come. When it's out the sensor will be shaped kind of like an L. I have changed a few of these over time and they can be a little stoburn. To install just reverse the process.

Posted on Mar 26, 2009

SOURCE: My mechanic is having trouble locating the

hi,
i have attached the image, showing the position of crankshaft position sensor.hope its helpful for you. Please rate my solution as helpful.have a great day.c9acd5a.jpg

Posted on Feb 21, 2010

Alex

  • 524 Answers

SOURCE: 2005 chry sebring crankshaft sensor location

The crank sensor is located behind the harmonic balancer or also known as the main drive pulley for your belts. You need to remove your belt and then remove this pulley to locate the crankshaft sensor

Posted on Jun 20, 2010

Testimonial: "thank you"

copycat513

  • 155 Answers

SOURCE: Where is the crankshaft position

should be a mark or line on the crankshaft pulley.It may be full of crude

Posted on Feb 26, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The location of a 2002 745i bmw li crankshaft position sensor


Necessary preliminary tasks:
  • Read out fault memory of DME control unit; if necessary, work through test schedules
  • Switch off ignition
  • If necessary, remove underbody protection.
Installation location:
On transmission housing at bottom right.


25772792-jq13pypi3egybe0aho3o0ljx-4-0.jpg
Unlock plug (1) and remove.

Release screw.

Withdraw pulse generator (2) from transmission housing.

Installation:
Replace screw.

Jul 05, 2015 | BMW Cars & Trucks

1 Answer

Where is the ac blower location in a 2005 bmw 745i


Should be midway or on the passenger side underneath the dashboard

Feb 03, 2015 | BMW Cars & Trucks

1 Answer

What are signs and symptons of thining brake pads on 2005 bmw 745i


fluid level drop and eventually a high pitch squeal when applying the brakes.

Sep 03, 2012 | 2005 BMW 745i

1 Answer

2002 BMW 745i code p0370 and it won't start


This is a generic code which says " Timing Reference High Resolution Signal A Malfunction ". This sounds like an electronic problem from where the computer gets a signal form sensors ( in this case probably a camshaft or crankshaft sensor ) to determine top dead center cylinder #1, in order for the computer to determine the correct timing. Since the computer is not sensing correct timing ( be it electronic or maybe your timing belt has skipped a tooth or more?) this would be the reason for your car not starting.

Jun 19, 2010 | 2002 BMW 7 Series

1 Answer

BMW 745i airbag light. Told to replacing airbag clockspring


Hello , check the airbag contact sensor behing the grill assembley . They are located to the left and right of the grill almost to the headlight assemblies. Check the wires to them for corrosion and damage. Check the fuse as well. There should be an air bag testing wire or fuse in the fuse panel. DO NOT UNPLUG THE AIR BAG SENSORS OR HIT THEM !!

Aug 22, 2009 | BMW 750 Cars & Trucks

1 Answer

Crankshaft sensor


go on ebay and purchase a repair manual disk it will have an electrical locator schematic on it

Jul 01, 2009 | 2005 BMW 3 Series

1 Answer

Where is the crankshaft sensor on a e46 318i


the crankshaft sensor is located under the starter motor, you will have to remove the air intake manifold to gain access to replace the sensor, if you are not sure how to carry out this repair it would be better to get a local garage to do it, regards mark

Jun 11, 2009 | 2005 BMW 3 Series

1 Answer

Mechanics at my local garage cannot locate crankshaft sensor


the crankshaft sensor will be located under the starter motor and the air intake manifold will have to be removed to gain access to this

Jan 01, 2009 | 2002 BMW 3 Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

128 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Doberman

Level 2 Expert

261 Answers

auntyjack

Level 2 Expert

104 Answers

Roy Cunningham

Level 1 Expert

35 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...