Question about 2005 Chrysler PT Cruiser

Open Question

Brake line routing for 05 pt cruiser

Diagram of brake line routing for 05 pt cruiser turbo

Posted by on

Ad

5 Suggested Answers

Anonymous

  • 1 Answer

SOURCE: PT Cruiser Brake Light

The bulb in the rear light has burned out and to replace it follow these instructions: 1) go to your owner's manual to find out the part number. You can find and purchase the replacement bulb at Target, any auto parts store and even at Walmart for under $4.00; 2) pop open the trunk door; 3) get a phillips screw driver and unscrew the 2 screws holding the rear brake light fixture to your car body; 4) as soon as you turn over the fixture you'll see where to pull out the burned out bulb and replace it with the new one(s). Good luck!

Posted on Oct 15, 2008

Ad
rockitman187

Randy Hough

  • 2559 Answers

SOURCE: 2004 chrysler pt cruiser starter motor removal

You may sneak it out with small fingers with out pulling out the starter.

If starter removal is required,Just unhook the battery cables,Remove the 2 bolts holding the starter on.


Please rate this a fixya

Posted on Feb 08, 2009

Ad

chryslerguy

  • 323 Answers

SOURCE: Replacing 2004 PT Cruiser Starter

He can do it. Tell him to just be patient (everything is a tight fit in a PT) and remember to disconnect the battery first. No special tools are required. He may have to move a bracket or two for access. It lives on the left side (front) of the motor and easiest to get to from underneath.

Posted on May 21, 2009

Anonymous

  • 10 Answers

SOURCE: Horn Solution

The horn is located in the front fenderwell on the passenger side behind the inner fender. You can't see it until the inner fender is taken out of the way.

Posted on Jul 09, 2009

Ted Schore

  • 7353 Answers

SOURCE: I need a schematic diagram for the radiator fan on

I dont have a diagram, but these have 2 speeds and they are a common problem. the fan will need to be replaced (complete unit)

Posted on Oct 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need a diagram of pt cruiser 2004 serpantine belt routing


you can get a Chilton book for your car it is in there or search it on line the dealer will print it for free I guess you lost the one that came with the car the diagram is usually on the fan shroud when you open the hood

Aug 27, 2014 | 2004 Chrysler PT Cruiser

1 Answer

Pt cruiser shakes at acceperation


Have the CV Joints checked for excessive play.

Jul 15, 2017 | 2002 Chrysler PT Cruiser

1 Answer

Replacing 2004 PT Cruiser Turbo battery


there is a metal bar holding the battery on my 05 pt cruiser, how doi remove it

Jan 20, 2012 | 2004 Chrysler PT Cruiser

1 Answer

05 pt cruiser turbo.oil is getting into intake manifold.smoke is coming out of exhaust.installed new turbo.still doing the same thing


It is getting into your exhaust manifold-the return line is either restricted or blocked, or the oil seal inside the turbo housing is either leaking or blown, usually due to excessive crankcase pressure.Try disconnecting the oil feed and return lines first, clean them out, and try it again-if it is still there, the turbo will have to come out and it will have to be gone over for blown seals.

Aug 17, 2011 | 2005 Chrysler PT Cruiser

1 Answer

2003 PT Cruiser


Crank sensor controls fuel not sprark. Check the cam sensor, this sensor is usually on the head of the engine. Check for this sensor on the top left or right sides of the engine (it depends if turbo/none turbo). Another issue that may cause no spark is failed ignition coil. The ignition coil is on top of the engine, with 4 wires routing to the spark plugs. Hopefully this helps!!

May 07, 2010 | 2003 Chrysler PT Cruiser

1 Answer

ECM CODE P2047 05 PT CRUZER 2.4 TURBO


This code p2047: P2047 Reductant Injector Circuit/Open
First thing to check are the plugs. If plugs are dirty, this would be the most common source of your problem. If the plugs are good, then it could be either a bad fuel injector or bad ground.

Oct 18, 2009 | 2005 Chrysler PT Cruiser

1 Answer

I need a schematic diagram for the radiator fan on a 2.4 liter 2006 PT Cruiser Turbo


I dont have a diagram, but these have 2 speeds and they are a common problem. the fan will need to be replaced (complete unit)

Oct 03, 2009 | 2006 Chrysler PT Cruiser

1 Answer

How do i replace the liquid line and drier on a 2004 pt cruiser 2.4L turbo engine.


first you must recover the freon from the system then change the line always installing new orings, evacuate the system "which means to put it into a vacuum to remove all the air and moisture out of the system" then recharge and enjoy....on your turbo pt it calls for .3 for the job ...anyone should be able to do it in like 30-40 min. proved you have the right tools...recovery machine and so on.....

Sep 19, 2009 | 2004 Chrysler PT Cruiser

1 Answer

05 pt cruiser touring turbo code po 302


you have a carbon build up problem try running lucas gas treatment in the car with a full tank of mid grade gas if this does not cure it leave another post and I will give you then next step to fix it, or you can go to http://www.alldatadiy.com and buy a subscription and read all of the recalls and coustmer trouble problems to help locate the problem.

Jun 17, 2009 | 2006 Chrysler PT Cruiser

Not finding what you are looking for?
2005 Chrysler PT Cruiser Logo

Related Topics:

43 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...