Question about 2009 Chrysler Town and Country

Open Question

Rear wiper dont work on 2009 town and country mini van

Widow was icey when I turned it on then it quit.

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 1 Answer

SOURCE: 2005 Town and country, turn signal either don't

Took it to mechanic and he found that it was the control handle on the steering column was bad. He says this is a common problem on these vans.

Posted on Oct 09, 2009

Ad

Bernie Goncalves

  • 1206 Answers

SOURCE: rear windshield wiper blade doesn't hit rear

the pivot pin must be rusted to the point it does not want to move, try lubing it with wd40 or equivalent lube,at the bottom of the wiper arm just before the bolt that holds it to the car is the pivot point.that's where it has to be lubed.

Posted on Jan 18, 2010

Testimonial: " Thank you for the information. Will give it a try."

Ashley Helliwell

  • 289 Answers

SOURCE: windshield wiper turns on when car starts, then won't stop

The van is now about 13-14 years old, chances are that the switch has worn to a point that the finite metal particles are shorting it out causing it to be on all the time. Re and clean the switch contacts, you should be good to go. Please let me know how you make out. Good luck..

ash

Posted on Jan 26, 2010

Anonymous

  • 1 Answer

SOURCE: CHRYSLER town and country mini van turn signal/flasher

I have a 2005 Chrysler T&C. The turn signal would not work at all or activate incorrect side. The switch is easy to remove as described by dukecityman.

Once the switch is of, it has four screws holding it together.I took this apart to find that there was a circuit-board which was contaminated with dirt. wiped it of, put it back together, working fine.

If you take it apart use caution. there are parts on the "top" which will fall out. ( they go right back in) The circuit-board is on the "bottom" half. You really only need to take this part off. (less moving parts)

Your going to replace it anyway, whats the harm?

Posted on Jan 28, 2010

bbbman78

Drew Z

  • 681 Answers

SOURCE: need to replace a wiper motor on a 2002 chrysler

Remove the wiper arms (pop off the caps at the base) and the 15mm nut. Take out the screws that hold down the wind shield cowl lift it away to expose the washer hoses. Unplug the wiper motor (center driver's side) by pulling out the red clip on it and squeezing the tab. Remove the 13mm nut from the wiper motor idler arm and take out the 3 10mm bolts that hold it in place. Squeeze it out from under the wiper transmission, or loosen the lower bolts. You'll see them. Not a difficult job, just take your time.

Hope I've helped.

Posted on Mar 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2009 town and country mini van rear blade that wont wipe the motor works but the blade wont move.


Sounds like you need a new wiper arm. They can get stripped out where it mounts to the motor pivot. You can sometimes get by for just a bit by taking off the arm and placing a couple of strips of aluminum foil between the arm and the pivot and tightening the nut back up.

Dec 29, 2017 | Mini Cars & Trucks

1 Answer

I have a 2008 Town and country mini van rear blade that won't wipe. The motor works but the blade just hangs down the back of the van.


REMOVE THE NUT, AUTOZONE HAS A CHEAP PULLER TO REMOVE THE WIPER ARM, DOES THE SHAFT SPIN WHEN THE MOTOR IS OPERATIONAL? IF NOT REMOVE PANEL FROM THE TRUNK LID AND INSPECT THE LINKAGE WITH THE MOTOR ON,

Feb 19, 2017 | Mini Cars & Trucks

1 Answer

My wipers...lights..radio and horn went out but I can drive the car..what would cause this?


2008 Chrysler Town & Country Intermittent Electrical Failure ...

www.carcomplaints.com/Chrysler/Town_Country/.../intermittent_electric...
The 2008 Chrysler Town & Country has 25 complaints for intermittent ... The horn,lights, wind shield wipers front and back going crazy could not shut off. .... I was Driving down the road and my van went crazy possessed! ... Electrical checks reveal nothing wrong with the electrical system, and there is power to the radio.

2003 Dodge Caravan ES Electrical Problem - Discussion on Topix

www.topix.com > Dodge Grand Caravan
Aug 7, 2011 - my van was running fine, shut it off, went in for half an hour then it would not ... or the electric doors. windows do and brake lights. heater stays on hot and i can only ... My horn wipers,power windows, radio,blower front and back, headlights, do not work. ... Chrysler Readies Next-Generation Town & Country.Missing: 2004

Thread: I lost almost all of my dash lights, instruments, and ...

forum.chryslerminivan.net/.../7261-I-lost-almost-all-of-my-dash-lights-i...

Jan 17, 2008 - 10 posts - ‎6 authors
I have a 2003 Town and Country mini-van and I lost power to all my ... In addition to this my wipers, headlight controls, blinker controls, power door locks, and A/C/heat controls are out as well. The odd thing is that the power windows work, the power sideview mirrors work, the radio and ceiling lights also work.

Dec 16, 2015 | 2004 Chrysler Town and Country

1 Answer

What is causing misfiring?


Part 1 -How to Test the Coil Pack (2001-2008 Chrysler 3.3L ...

easyautodiagnostics.com > Chrysler > 3.3L, 3.8L
Apr 29, 2011 - Page 1 of 7: How to Test the Coil Pack (2001-2008 Chrysler 3.3L, 3.8L). ... ignition coil pack on your 2001-2009 Chrysler (or Dodge) 3.3L or 3.8L Town and Country, .... 3.3L or 3.8L Chrysler mini-van, are OK and not the cause of the misfirecondition. ... 2001, 2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009.

Nov 14, 2015 | 2003 Chrysler Town & Country

1 Answer

HOW DO YOU GET TO THE REAR SPARK PLUGS ON A 98 TOWN AND COUNTY VAN?


well you can reach around the top of the engine to get to the rear plugs or go underneath and get at them from the bottom. you can remove the wiper cowling to gain access more room as well.

Sep 09, 2014 | 1998 Chrysler Town & Country

1 Answer

Need to replace a wiper motor on a 2002 chrysler town and country mini van. how is this done?


Remove the wiper arms (pop off the caps at the base) and the 15mm nut. Take out the screws that hold down the wind shield cowl lift it away to expose the washer hoses. Unplug the wiper motor (center driver's side) by pulling out the red clip on it and squeezing the tab. Remove the 13mm nut from the wiper motor idler arm and take out the 3 10mm bolts that hold it in place. Squeeze it out from under the wiper transmission, or loosen the lower bolts. You'll see them. Not a difficult job, just take your time.

Hope I've helped.

Mar 06, 2010 | 2002 Chrysler Town & Country

1 Answer

2005 Town and country, turn signal either don't work or left signal activates right turn signal. Now front wipers have quit. Rear still works.


Took it to mechanic and he found that it was the control handle on the steering column was bad. He says this is a common problem on these vans.

Oct 08, 2009 | 2005 Chrysler Town & Country

Not finding what you are looking for?
2009 Chrysler Town and Country Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...