Question about 2003 Lincoln Navigator
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
U must remove the entire dash assembly and then the heater core housing which is part of the air distribution box, time to do the job 10-15 hours.
Posted on Dec 01, 2008
the little orange or red ring around the air hose whare it goes in compressor, must be pushed in while pulling out on air line. a small flathead screwdriver works fine
Posted on Apr 24, 2009
I have a 2003 Nav with the exact same problem. I've found it diminishes when taken out of overdrive. Also it's intermittent but more towards bucking. Sorry to post this under solutions.
Posted on Nov 06, 2009
Deactivating/activating the autolock feature...
Before following the procedure, make sure that the ignition is OFF and all vehicle doors and the liftgate window are closed.
You must complete steps 1-5 within 30 seconds or the procedure will have to be repeated. If the procedure needs to be repeated, you must wait 30 seconds.
1. Turn the ignition key to ON.
2. Press the power door unlock control three times.
3. Turn the ignition key from ON to OFF.
4. Press the power door unlock control three times.
5. Turn the ignition back to ON. The horn will chirp.
6. Press the unlock control, then press the lock control. The horn will
chirp once if autolock was deactivated or twice (one short and one long
chirp) if autolock was activated.
7. Turn the ignition to OFF. The horn will chirp once to confirm the
procedure is complete.
Also, if your vehicle is equipped with a coded-key anti-theft system. Only the correct key will be able to start your vehicle. If your keys are lost or stolen, you must take your vehicle to a Ford/Lincoln-Mercury dealership for re-programming.
Programming additional keys If you need additional keys electronically coded for your vehicle, spares can be purchased (a maximum of 16 keys can be programmed). To program a new key, perform the following procedure:
1. With the coded key in the ignition, turn the ignition from ON to OFF.
2. Within 15 seconds of turning ignition off, insert the new coded key
into the ignition and turn it from OFF to ON or START. If successful, the
THEFT indicator light will illuminate for two seconds. Repeat procedure
for all new keys.
If key coding fails, the THEFT indicator light will flash.
Coding failure can be caused by any of the following:
² The new key was not inserted into the ignition within 15 seconds.
² 16 keys have already been programmed.
² The new key does not have an electronic code.
Other details can find in the 1998-Lincoln-Navigator-Owners-Manual
Good luck (remember comment and rated this).
Posted on Jul 20, 2010
SOURCE: how to disable or reset
YOU CANT DISABLE OR RESET THE ANTI THEFT SYSTEM. YOU NEED CODE SCAN FIX. PROBLEM WITH ANTI THEFT SYSTEM CAUSED BY KEY ITSELF WORN OUT OR FAULT IN THE ECM IMMOBILIZER READ COIL OR IN THE IGNITION SWITCH BAD.
Posted on Aug 02, 2011
Tips for a great answer:
Feb 07, 2017 | 2000 Lincoln Navigator
Aug 08, 2015 | Lincoln Cars & Trucks
Dec 16, 2014 | 2002 Lincoln Navigator
Aug 02, 2011 | 1999 Lincoln Navigator
Oct 10, 2010 | 2003 Lincoln Navigator
Mar 21, 2010 | 2003 Lincoln Navigator
Jan 02, 2010 | 2003 Lincoln Navigator
Aug 22, 2009 | 1998 Lincoln Navigator
Jul 14, 2009 | 2003 Lincoln Navigator
Aug 07, 2008 | 1999 Lincoln Navigator
1,201 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: