Question about Cars & Trucks
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
try getting a new shift solenoid for it. i had the same problem on my 2002 chrysler town and country and my plymouth breeze which is also a dodge product. it is very simple to do and doesnt take all that long. the part will probably run you about 150 to 200 dollars but it should fix your problem.
Posted on Apr 04, 2009
The code is about the switch that monitors the hydraulic pressure for operating the low/reverse clutch of the transmission. That clutch is called into play for all forward gears as well as reverse, so it seems reasonable if that clutch were not working that the car wouldn't move in any gear. I would begin by making sure that there is sufficient trans fluid by inspecting its dipstick. If needed only use ATF +4 but don't overfill it. Also, just on a chance, take a look underneath to see if you see any motion of either the left or right half axles (or one moving, but one not) which would be another reason for no motion due to a drive shaft disconnection or some such anomaly. Other than that, your problem could be with the Low/Reverse solenoid switch in the solenoid pack portion of the transmission (the box on the driver's side of the trans) being stuck. That can be repaired without removing and rebuilding the transmission so let us hope that may be the cause. I would have the car towed to a good independent trans shop that has a reputation for knowing how to service the Chrysler electronic transmission
Posted on Sep 18, 2009
I have a 2005 Chrysler T&C. The turn signal would not work at all or activate incorrect side. The switch is easy to remove as described by dukecityman.
Once the switch is of, it has four screws holding it together.I took this apart to find that there was a circuit-board which was contaminated with dirt. wiped it of, put it back together, working fine.
If you take it apart use caution. there are parts on the "top" which will fall out. ( they go right back in) The circuit-board is on the "bottom" half. You really only need to take this part off. (less moving parts)
Your going to replace it anyway, whats the harm?
Posted on Jan 28, 2010
Tips for a great answer:
Nov 03, 2016 | 2007 Chrysler Town and Country
Dec 07, 2015 | 2006 Chrysler Town and Country
Apr 11, 2014 | 1999 Chrysler Town & Country
Oct 29, 2011 | 1996 Chrysler Town & Country
Feb 16, 2010 | 2001 Chrysler Town & Country
Dec 18, 2009 | 1996 Chrysler Town & Country
Dec 06, 2008 | 1996 Chrysler Town & Country
104 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: