2001 Buick Century headlight alarm goes off like I left the headlights on, but the auto lights don't come on. I manually turn the headlights on the console lights go off, and no taillights.

6ya staff

• 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Instant Repair Help over the Phone

6ya.com

Save Time & Money by instantly connecting to...

Posted on Jan 02, 2017

Marvin

• 85216 Answers

SOURCE: headlight issue

This may be either a defective DRL module or a headlight ground fault.

Posted on Oct 20, 2008

SOURCE: headlights won't come on

both headlight bulbs need changing/ check the fuse first under the dash and in the engine compartmentplease rate my response thank you very much

Posted on Jan 31, 2009

Morne Olivier

• 257 Answers

SOURCE: 1994 buick century headlights not working

Go through all your fuses, Dim lights run on a separate fuse.

Posted on May 07, 2009

Marvin

• 85216 Answers

SOURCE: 99 buick century headlights

u changed the multifunction switch or the main head light switch?

Posted on Sep 09, 2009

SOURCE: 1998 buick century only high beams and turn

The Buick Century is equipped with a multi-switch. This switch is an all in one switch that controls your cruise control, windshield wipers and turn signals in one switch. This switch also controls dimming and brightening of your headlights. The dimmer switch is simple to replace, and all you need is a phillips head screwdriver to complete the task.

1. Removing the Steering Column Shroud
   • Removing the dimmer switch starts at the steering column. To plan this task out, access the steering column by removing the screws holding the steering column shroud in place. This will expose the turn signal lever. Remove the lever by twisting it forward, and pulling it out of the switch.
     
   Removing the Dimmer Switch
   • The switch is held on by two screws and a wiring harness. The wiring harness can be removed by prying up on the locking tabs and pulling the connector out of the socket. The two screws can be removed with a phillips head screwdriver. The switch will slide out. To install a dimmer switch, be sure to repeat these steps in reverse order.
     

Posted on Oct 09, 2011