Question about Hyundai Cars & Trucks
Code p0700 is TCM problem
code p 0722 is output shaft speed sensor--no signal===causes --wiring--OSS sensor --TCM ---ECM
possible that your problems are wiring and connections and /or transmission control module (TCM)
Posted on Apr 03, 2018
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
replace the input speed sensor to transmission and the wiring pigtail all are available at your chrysler dealer take your vehicle registration in to the parts counter so they have your vin # to get the right part and it is the front of trans by fluid linres to radiator.
Posted on Mar 08, 2009
Im having the same problem with my 02 Santa Fe. How do i go about fixing this problem? And is it costly? Please help
Posted on Jan 31, 2010
SOURCE: where is the output speed
The problem is either vehicle speed sensor or wiring harness going to sensor. In some case the ECM is defective.
Ensure that you have already replaced the VSS with good ones.
If you have not replaced them yet, then the sensor can be tested reading the waveform. This is done connecting both VSS input and output wires to a machine. The one below is a good VSS wave at 37 mph:
If the waveform is incorrect, the sensors must be replaced, as the ECM returns P0722 when VSS output is incorrect, or when there is no output.
A second test can be done reading the sensor impedance and voltage. Connect a multi-meter to the sensor. Set first on Ohms reading (impedance). A good sensor will read 560-680 Ohms at 20C (68F).
Set multimeter on Volts. Touch rapidly the sensor with a magnet and pull magnet away. The sensor will emit a weak voltage pulse. If that does not happen, then the sensor is broken. Ensure that multimeter is on high volt scale.Voltage will be quite low:
The VSS are located on the wheel shaft. Here a picture:
The VSS is connected to the ECM.
If you have already replaced the sensors you need to check the wiring harness to the ECM.
The wiring harness is tested checking that each wire going to the ECM has continuity. This is done reading impedance between each connector in the sensor , and the respective connector in the ECM. Impedance must be zero or a very low value. If it reads infinity, then the wire is broken.
A second test is done reading impedance between the two different wires at ECM connector. Impedance must be the same as at VSS contacts on sensor. If impedance is zero, then there is a short. Ensure that you choose a proper Ohms scale while doing the test.
If you have already replaced the VSS, repair or replace the wiring harness. The ECM failure returning this code is very uncommon. At most you may have a defective ECM connector.
Posted on Apr 19, 2011
The input and output speed sensors are located on top of the transmission, the output speed sensor is on the rear just under the brake master cylinder, the input speed sensor in in the center under the shift cable.
Posted on May 07, 2012
Tips for a great answer:
Jun 24, 2011 | 2001 Hyundai Elantra
Feb 17, 2011 | 2000 Hyundai Elantra
Feb 12, 2010 | 2006 Hyundai Accent
Feb 09, 2010 | 2000 Hyundai Sonata
Mar 25, 2009 | Hyundai Motor 1999 Elantra
Nov 23, 2008 | 2001 Hyundai Elantra
Jul 18, 2008 | 2001 Hyundai Sonata
450 people viewed this question
Usually answered in minutes!