Question about Ford Ranger

1 Answer

Have a 95 ford ranger the buzzer wont stop even after the key is removed have unpluged bottom of module it stops but then my wipers wont work

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Ford Master
  • 5,478 Answers

Pull out the key and tumbler and adjust the ground tab on bottom of the switch.

Posted on Oct 02, 2018

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Mark Egan

  • 1214 Answers

SOURCE: Light warning buzzer constantly on

Have you checked that the headlight switch is in the right position? Are the headlights or parking lights still on when the key is removed?

If so, then rotate the lamp switch to the correct position and the buzzer will go off. Headlights and parking lights are not controlled through the key circuits.

Posted on Jan 29, 2009

Anonymous

  • 81 Answers

SOURCE: I have a 2003 ford ranger p/u. The wipers stopped

The multi-function switch is a known problem. Hard to say if it will fix all of the problems. Check the fuses too.

Posted on Mar 26, 2009

Pops65Pony

Tom Shanks

  • 138 Answers

SOURCE: 1996 ford ranger odometer / trip stopped working

Since your speedometers work, the problem is in the gearing to the trip and mileage odometers. Simple problem, major pain to fix but, remove instrument cluster - you'll have to remove speedo cable to get it out. Use the old Mark I eyeball to check for broken parts. Might even have to drop steering column - disconnect air bag first!

Posted on May 02, 2009

Anonymous

  • 284 Answers

SOURCE: 2001 Ford Ranger Extra Cab windshield wipers don't

WOW that is strange. Get your self a test light or a cheap multimeter. Take the + wire off at the wiper motor and check if you have voltage / power. If you do then the problem is with the wiper motor if you don't it is the wiring or the switch. I know, not a complete solution but it cuts your problem in half :)

Good Luck

Posted on Aug 15, 2009

Adamcole1213

  • 30 Answers

SOURCE: 2000 Ford Ranger XLT Automatic trans. 4X4 3.0L

Check your operator's manual. Make sure any and all fuses that have anything to do with the affected items are not blown and are working properly. If you can; check for loose fuse connections or wires. Hope this helps. God bless!

Posted on Dec 09, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Windshield wipers not working correctly on ford f150


Not sure what year your truck is but on later models there is a wiper module. On my '96 I had to replace the wiper module that was located under dash on passenger side

Oct 27, 2017 | 1988 Ford F 150

1 Answer

Windsheild washer and wipers wont go off.


I assume you mean the harness for the switch, because if the wiring harness for the motor is unplugged it should not have a way to get power.
There is a wiper relay and a front electronic module, either one could be faulty and causing the motor to have power with the switch off.

Sep 22, 2012 | 1999 Ford Windstar

2 Answers

Windshield wipers on 1986 Ford Ranger stopped working


unplug the wire at the wiper motor and then turn the key on and then turn the wiper switch on and test the wires at the plug with a 12 volt tester . if u dont have any thing then ur wiper switch is bad , if u have juice at the plug then it sounds like its the motor.

Jul 13, 2012 | 1986 Ford Ranger 2WD

1 Answer

1998 ford ranger one windshield wiper just stopped working...


check the nut at the base of the wiper arm. There is probably a plastic cover that needs to be removed to see it. Tighten the nut and you should be good to go.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Feb 03, 2012 | 1998 Ford Ranger

2 Answers

My 1995 ford ranger pick up speedometer, radio, break lights, wipers and turn signals dont work


On the ford ranger wiper motor not working, this is how u fix it. I am a licenced autobody mechanic for mercedes and my son bought a ford ranger and of course the wipers were not working-neither did the dome light and door chime.I told my son too replace all fuses ,switch and motor. And still nothing.Remove radio there is a pcm in behind- ours was unpluged. When we plugged it in the door bell would not shut off and the dome light stayed on. In stead of unplugging the pcm remove the light if wd40 does not work on the door latches. And to stop the door bell ringing remove the plastic cover around the ignition and their is a single wire with a blue connector just remove the wire it is the wire closest to the key and tape up the end and problem solved guarenteed . my email is frameman127@yahoo.ca I will walk u through it .

Jul 24, 2010 | 1995 Ford Ranger Supercab

2 Answers

The ignition bell wont stop ringing


You need to unplug the door harness one at a time to locate which door is causing the problem. Once the door is located, you can replace the switch which is located on the lock mechanism.

Sep 29, 2009 | 1994 Ford Ranger Supercab

1 Answer

Changed the heater core in 2002 ford ranger, now the winshield wipers wont work, bought new switch and still wont work? what is it????also the interior lights wont work. all fuses are ok.


Why did you buy a switch? Did the original one meter out bad? Never replace any part till you understand how it works and how to test it. Work the wipers and the lighting issues as two separate problems. The wiper motor or relay etc may have failed around the same time as the heater core. Two separate things Unplug the wiper motor and turn the key on. Meter out the connector in different switch modes. Need a schematic of the circuit. Lights-- Problem is after the fuses and they are the start of most circuits. so you know you have an open circuit like a connector under the dash you disturbed unknowingly during the heat core deal or a loose ground wire.

Sep 26, 2009 | 2006 Ford Ranger

1 Answer

1992 ford ranger wiper wont work wiper pump not working fuse ok?


check wire continuity with multimeter, have had switch go out on ranger as well.

Apr 05, 2009 | 1992 Ford Ranger

1 Answer

I have a 2003 ford ranger p/u. The wipers stopped


The multi-function switch is a known problem. Hard to say if it will fix all of the problems. Check the fuses too.

Mar 26, 2009 | 2002 Ford Ranger Regular Cab

1 Answer

Not working


It sounds like it might be a problem with general electronic module, it is located behind the radio on the left side.

Jan 12, 2009 | 2002 Ford Ranger Regular Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...