Question about Cars & Trucks

1 Answer

I have gas venting issue that will not allow me to put gas in the tank on a 2005 Alavanche.

I have changed out the chacoal box, vent val sensor and also the other one on the engine.

Posted by on

  • Steve P
    Steve P Dec 07, 2019

    Sounds like a venting issue...check the filler neck(where the pump nozzle goes in) for obstruction.. If you disconnect the vent hose from the vent hose extension..the extension might be blocked...

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 90 Answers

Possibility bad purge vale assembly

Posted on Dec 08, 2019

  • David Skandaliaris
    David Skandaliaris Dec 08, 2019

    Possibility bad purge vale assembly

×

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Geo Tracker runs rough at idle replaced 02 sensor,plugs rotor,cap and wires I started it and it ran OK for a couple of seconds and went right back to running too rich is this because of the air val


95 , 16valve ? engines, says so on top of engine valve cover.
all that is last.
key on, CEL glows? if not fix that first
key on, does CEL go out, running, ? if not pull the ECU DTC codes
using a paper clip.
http://www.fixkick.com/Blink.html
The MAF is the air valve. Mass Air Flow sensor.
type MAF in the search box, vast ways to test it , cheap and easy.
ever do the 60k tuneup,
you skipped , filters, and new timing belt.
if the belt slips , spark timing goes way off, did it?
and compression drops from 170 to 100; classic symptoms....
the order is.: 1,2,3
1: good engine, "compression"
2: good spark, is the timing still at spec. as the under hood sticker shows>
3: fueling.

Feb 18, 2013 | 1995 Geo Tracker

1 Answer

Spark plugs on a 2010 Chevy Equinox?


unscrew the clamp from the air box of the mas air flow sensor and engine on hose. remove the oil fill cap . also pull out the little vent line by the engine clamp them take thecover off and the cover under it you should see the sparck plugs

Jan 04, 2013 | 2010 Chevrolet Equinox

1 Answer

Do i need to change my val cover gasket and do u think that will solve myproblem of my oil leaking so bad i am not sure i think that is my problem the val covergasket needs to be changedchanged


Wipe the cover and the area below it clean with some rags. Then run the car awhile and check if the clean area has new oil that leaked out. Usually oil leaking from the top of the engine is the valve cover.

Nov 11, 2012 | Cars & Trucks

1 Answer

2000 bmw 528i misfiring on cly 1,3, 5


Change the spark plug wires,

Nov 02, 2012 | Cars & Trucks

1 Answer

Gas smell coming from vents in 2002 nissan Sentra


i have a similar problem. my check engine light came on i place the computer on it and received two codes. one was for emission and the other for a vent system. there are two small sensors behind the driver side rear wheel. it is covered by a plastic and there is also a black box. between the wheel and the black box. these are the bad sensors we must replace. sensors are about $ 150.00 black box is $ 350 or so. while replacing the sensor be carefull if you damage the dreads on the black box housing you will spend the $350 for a new box. good luck

Sep 04, 2012 | 2002 Nissan Sentra

1 Answer

Free engine diagram bmw 2000 528 i


I have misfire on cyl 1,3 and 5 , already change plug and coil and cam sensor and val cover gasket, and stal have a misfire

Jun 30, 2012 | 2000 BMW 528i

1 Answer

The tire sensor comes on frequently showing low tire pressure. These are expensive tires. What's the problem


make sure tire pressure is above 35 psi. if it continues to come on your tire pressure sensor are bad or val stems your sensor is on the inside of tire connected to val stem. they are expensive.

Sep 04, 2011 | 2003 Lexus SC 430

1 Answer

My 2003 dodge caravan se has a small rubber pipe hanging down underneath the drivers side of the car when i looked at it it ran from above the fuel tank to a small box under the engine but its not the main...


that black box is the chacoal canister and the hose is from the evaporative sistem ...... when the car is on or the engine runing the extra gasoline cameback to the tank and make pressure on it if the hose is off or broken from the charcoal canister the . check engine light have to be on check the tip of the hose if dont fit tight or is loose will fail the smog test good luck

Jan 02, 2011 | 2003 Dodge Caravan

1 Answer

1987 318 2wd pickup carburator keeps plugging up on back side with black charcoil


anything that looks like chacoal is ussualy a sign of the engine burning oil

Nov 14, 2009 | Dodge Ram Cars & Trucks

1 Answer

NEED SERIOUS HELP


there is a inline val.. that works off of vaccum this val is close and you will not get heat when it is close it is on the inline the pin that work it usely breaks

Feb 23, 2009 | 1997 Ford Explorer AWD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

john h

Level 3 Expert

22486 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...