Question about 2000 Ford Expedition

1 Answer

Egr 99 ford expedtion egr problems?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,615 Answers

If its a low flow code replace the DPFE sensor. If you do a resistance check of it it will prabably be out of specs. Also make sure the two hoses are hooked up and arnt cracked. Also blow thru each one to make sure the tubes going into the exhaust arnt clogged. Also make sure the grn hose going to the egr valve is plugged in. Also apply vacuum to the egr valve to make sure it holds vacuum. If it doesnt then the vlave is bad.

Posted on Sep 22, 2009

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the egr valve on a 99 Ford expedition


The EGR valve is in a very difficult spot to work on. If the EGR is bad it will set off the check engine light and make the vehicle run rough or stall at idle. It really doesn't make it run rough while driving or accelerating. What are the conditions when the car runs rough?

Mar 01, 2014 | 1999 Ford Expedition

2 Answers

Rough idle problem


could be a vacuum leak at a hose or gasket. with the engine running spray a little carb spray at the intake manifold area. if the idle picks up you are close to the vacuum leak. dont spray on the exhaust manifold area, be careful

Oct 24, 2013 | Cars & Trucks

1 Answer

99 ford escort code says egr flow is insufficient but valve is almost new and i cleane the egr tube and also made sure the vacumn hose was ok what do i do next


if valve is new and there doesnt seem to be any other problem, you should disconnect your battery cables for 5 min then hook them back up, this will reset the code, hopefully that will take care of it.

Nov 28, 2011 | Cars & Trucks

1 Answer

I have a 99 Windstar 3.8L Keep getting DTC PO401 have replaced DPFE EGR Valve and EGR tube still keep getting Code PO401


Does the egr vavle open ? You will need to use a scanner to test the dpfe voltage when the egr valve is energized you should read around 3.5 4.00 volts. Also you could remove the vacume line from the egr valve and with the engine running you should see around 100 rpm drop in engine rpm at least this would indicate the egr valve is capable of flowing egr gases through the system to the cylinders.

May 30, 2010 | 1999 Ford Windstar

1 Answer

How to replace a ignition lock cylinder in a 99 ford expedtion


I believe you are talking about the cylinder where the key goes that starts the truck. If so, you will need to go to autozone and borrower there steering wheel removing tool. When I did mine it took about 2 hours to do. They have a step by step instruction on how to do it that they can print off. Its not hard to do, I could probably do it in 30 minutes or so now. You have to disconnect the battery to prevent air bag deployment.

May 13, 2010 | 1999 Ford Expedition

1 Answer

99 taurus shakes badly at a stop


Welcome to FixYa.com Have you checked the egr valve ? Check tune and for vacuum leaks with a can of carb spray while engine is running Regards, Lee

Apr 19, 2010 | 2000 Ford Taurus

1 Answer

When they run a test and it said egr insuffince on a 99 ford what is the problem


they have a little switch that monitors flow. on these cars it common place to have those go bad. it is right in line with the egr and are not very expensive.

Jan 24, 2010 | 1999 Ford Crown Victoria

1 Answer

Ford expedtion 2003 air bag lit on turns


i think the problem is clockwise wire in steering column, this is most common problem in cars air bag

Jul 05, 2009 | 2003 Ford Expedition

Not finding what you are looking for?
2000 Ford Expedition Logo

240 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...