Question about 1997 Jeep Grand Cherokee

1 Answer

How do I replace the passenger side corner light and front side turn signal light?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 2,989 Answers

Front Turn Signal & Parking Lights


How do I replace the passenger side corner light - 7ccc73e.gif
Remove the 2 parking light housing retaining screws ...


... then pull the housing away from the vehicle far enough to remove the bulb socket from behind the housing. Turn thHow do I replace the passenger side corner light - a323ae9.gifunterclockwise and pull


a323ae9.gif
Push the bulb in the socket gently and turn clockwise, then pull the bulb out of the socket. Note the offset retaining ears on each side of the bulb


  1. Remove the screws from the lens and separate the lens from the headlight bezel.
  2. Remove the headlight bezel.
  3. Remove the screws from the turn signal housing and pull it out.
  4. Turn the bulb socket counterclockwise 1/3 turn and remove it.
  5. Installation is the reverse of removal.


Side Marker Lights
  1. Remove the screws from the marker lens and separate the lens from the headlight bezel.
  2. Pull the bulb from its socket in the back of the lens.
  3. Installation is the reverse of removal.

Posted on Feb 14, 2010

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

jfirebird71

  • 335 Answers

SOURCE: 2000 sunbird front turn signal bulb

only i could replace mine where to remove clips from the black wheel well cover then the light bulb un screws from the back of the lens

Posted on Apr 08, 2009

Anonymous

  • 25 Answers

SOURCE: front driver side turn signal light doesn't flash

replace flasher......usually located in fuse block area...listen in this area....select passenger side ...then select driver side...you can hear flasher clicking...you have seperate flashers for each...FLASHERS are small cubes plugged into fuse block....probable bad driverside flasher

Posted on May 09, 2009

roniecon

Ronny Bennett Sr.

  • 6927 Answers

SOURCE: 2001 Mercury Cougar turn signal light bulb

3057 bulb

Posted on Jul 09, 2009

Jonah Oneal

  • 14092 Answers

SOURCE: tail lights work on both sides. turn signal and

check fuse to driver side turn signal lamp.check brake light bulb or replace bulb on driver side.also replace the front driver side turn signal bulb that is flashing fast.

Posted on Dec 14, 2009

Anonymous

  • 4 Answers

SOURCE: Right Turn Signal not flashing.

quick fix,try to run jumper wire from solid lime green wire to tail light green/orange wire Your problem is no power

Posted on Apr 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1994 Toyota corolla 1.8, how do I get my passenger front turn signals to work? What wires have to be connected together for my turn signal and side corner marker to work?


does your car have the signal light flasher if so find it and replace it also check the fuses maybe both sides are fused separate

May 05, 2017 | 1994 Toyota Corolla

1 Answer

Passenger side front turn signal/DRL do not work.


Dear Alex,
The problem is in the bulb, or the socket, or the wiring to these.
Whenever a turn signal flashes fast, know that one of the bulbs is not working.
You have already identified the problem as being the front one. Problem could be the hot wire, or the ground wire, or the ground connection to this bulb.
Start by taking a tester to the hot wire, and see if it is receiving electrical impulses when the turn signal is on.
( It probably is, unless the car has been in a wreck and has been improperly repaired.)
Then check the socket or the wires to is and see if the bulb is grounded.
I suspect the ground is defective, and either a new socket or a repair to the ground wire should fix you rights up.
God bless your efforts.

Aug 02, 2016 | 2002 Pontiac Montana

1 Answer

How to replace passenger turn signal bulb


The side marker light must be removed in order to get at the turn signal light.
There are two screws holding the side marker light which is situated above the turn signal.
Open the hood.
Remove the phillips head screw at the top of the side marker light.
Using a long #2 Phillips screwdriver, remove the screw on the outside of the side marker light. This can be seen by looking between the lower side of the side marker light and the top side of the turn signal.
The side marker can be moved.
The turn signal has one screw on the top of the fixture that must be removed.
Slide out the turn signal fixture. There is a small feature on the lower front corner of the turn signal fixture that you must note to properly reinstall the turn signal.
In order to get to the bulb, rotate the bulb socket 1/4 turn CW or CCW. The bulb socket is loose.
The bulb is simply pressed into the socket.
Not sure of the type, but it can be found at your locale auto parts store.
The bulb is used in several places on the 1994 GC, so get apacket with two, if possible.
Assembly in reverse. Be careful not to overtighten the screws as they are replaced

May 08, 2011 | 1994 Jeep Grand Cherokee

1 Answer

How do I replace the frong corner light on my 1993 Grand Cherokee passenger side? I found one screw at the top and took it out still would not budge. Is there another screw someplace else I'm missing?...


If you are talking about the turn signal, there is a second screw located between the bottom of the side marker light and the top of the turn signal light. You will need a long #2 screwdriver to get at the screw. You also may need to pry apart the two light fixtures to see the screw.
There is one screw holding the turn signal in place.

Pay attention to the little protrusion at the front side of the turn signal fixture. It needs to be placed behind the matching fixture near the side of the headlight.

May 07, 2011 | 1993 Jeep Grand Cherokee

2 Answers

Tail lights work on both sides. turn signal and


Sounds like you need to replace the drivers brake/tail light.

Dec 14, 2009 | 1998 GMC Sierra

4 Answers

Front driver side turn signal light doesn't flash.replaced bulb,replaced socket,all other lights work on emergency flasher,except front driver side.rear driver side turn signal light works,but flashes...


replace flasher......usually located in fuse block area...listen in this area....select passenger side ...then select driver side...you can hear flasher clicking...you have seperate flashers for each...FLASHERS are small cubes plugged into fuse block....probable bad driverside flasher

May 09, 2009 | 1998 Buick Century

1 Answer

Right Turn Signal not flashing.


quick fix,try to run jumper wire from solid lime green wire to tail light green/orange wire Your problem is no power

Apr 21, 2009 | Plymouth Acclaim Cars & Trucks

1 Answer

Right turn signal not working on 1992 Ford Explorer Truck


turn on the hazard light so you can identify the bulb that is actually deffective. the procedure to replace can be found on youtube.

Mar 10, 2017 | 1992 Ford Explorer

1 Answer

No passenger side turn signal


you have a broken wire at the bottom of Ur rear end or bad connection

Nov 20, 2008 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
1997 Jeep Grand Cherokee Logo

412 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...