Question about 2004 BMW Z4
After you have removed the 4 nuts securing the pump to the motor, you will need to install 2 6mm bolts in the two holes on the pump and alternately tighten the bolts to push the pump away from the motor. After the pump is loose, I recommend removing the the nuts from the top of the motor mounts and slightly raising the motor until the pump clears.
Posted on Sep 14, 2017
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well
Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)
If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.
Posted on Sep 30, 2009
-Disconnect the negative battery cable.
-Drain the cooling system.
-Remove the distributor cap and rotor. Remove the rotor adapter, the dust shield and the distributor housing.
-Remove the fan. The fan must be held stationary with tool 11 5 030 or some sort of flat blade cut to fit over the hub and drilled to fit over 2 of the studs on the front of the pulley. Remove the fan coupling nut; left hand thread-turn clockwise to remove.
-Remove the belt and pulley.
-Remove the rubber guard and distributor and or upper timing belt cover.
-Compress the timing tensioner spring and clamp pin with the proper tool.
*Observe the installed position of the tensioner spring pin on the water pump housing for reinstallation purposes.*
-Remove the water hoses, remove the 3 water pump bolts and remove the pump.
Posted on Dec 30, 2009
Follow link. Leave positve comment..Thanks
Posted on Jan 06, 2010
CLICK on the following LINK. It has the Belt Diagram you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Posted on Mar 10, 2010
Testimonial: "I thank you very much for your expertise, will install the belts this week end. Poorman, thanks you again. Doing it my self is saving me alot of money"
Tips for a great answer:
Mar 13, 2011 | 1999 Chevrolet Venture
Dec 15, 2010 | 1996 Suzuki Swift
Jul 21, 2010 | 2002 Buick Rendezvous
Jun 12, 2010 | 1998 BMW 5 Series
May 02, 2010 | 1999 GMC Yukon
Feb 20, 2010 | 2002 BMW 3 Series
Dec 01, 2009 | 1997 Chevrolet Venture
Jun 29, 2009 | 2004 Pontiac Grand Prix
May 21, 2009 | 2003 BMW 325
May 15, 2008 | 1999 Pontiac Montana
Aug 30, 2014 | 2004 BMW Z4
166 people viewed this question
Usually answered in minutes!