Question about 2000 Nissan Frontier

1 Answer

Where is the crankshaft position sensor located on a 2005 Nissan Frontier?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 155 Answers

Should be a mark or line on the crankshaft pulley.It may be full of crude

Posted on Feb 26, 2011

Ad

3 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

mcguyerchris

  • 5 Answers

SOURCE: Can you tell me where the crankshaft position

V6 or 4 cylinder? If you go to www.clubfrontier.org and go to the forums you can find a free manual download in the DIY section. The page is in the EC section and starts at page 970. You will find a picture in the book download but the sensor on the V6 is on the side of the motor on the passenger side (U.S.) to the left of the suspension. You will probably have to remove the plastic inner fender cover to be able to get a clear view of everything.

I spent all day today looking for this because it's not in a normal spot.

Posted on Sep 14, 2010

Steven Gepner

  • 69 Answers

SOURCE: location of Crankshaft Position Sensor 2002

in the rear of the engine on the drivers side at the top of the transmission bell housing

Posted on Jul 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the crankshaft sensor on a 2001 frontier 4 wheel drive 3.3 engine?


Hi Lee,here's a link to a diagram to where your crankshaft position sensor is,just enlarge picture to see better.. GET 25 GIFT CARD FOR EVERY 100 SPENT ON ONLINE SHIP TO HOME ORDERS Here's another link to what the sensor look's like. Crankshaft Position Sensor at AutoZone com Best Crankshaft Position Sensor...

Nov 21, 2015 | 2001 Nissan Frontier Crew Cab

2 Answers

2005 nissan almera,1.5letre.. fault code po725


P0725 NISSAN - Engine Speed Signal

The P0725 Codes is triggered when TCM does not receive the engine speed signal from ECM.

The Engine Control Module (ECM) monitors the engine speed through the Crankshaft Position (CKP) sensor with the engine running, and send signal to the Transmission Control Module (TCM).

Symptoms:
- Engine Light ON (or Service Engine Soon Warning Light)

Possible causes:
- Open or shorted CKP sensor circuit condition
- Poor CKP sensor electrical connection
- Check communication error between the ECM and TCM
- Failed CKP Sensor

Possible solution:
Very common problem with Nissan vehicles, usually replacing the Crankshaft Position sensor takes care of the problem.

Keep us updated.

Feb 12, 2011 | 2005 Nissan Altima

2 Answers

Location of Crankshaft Position Sensor 2002


in the rear of the engine on the drivers side at the top of the transmission bell housing

Jul 08, 2010 | 2002 Nissan Frontier Crew Cab

1 Answer

My 2000 Nissan Frontier has sputtering problems and the tac goes crazy. changed the fuel pump, sending unit, spark plugs, cap & rotor. what could be wrong?


your tach is run by the engine computer, possible cause. also by the crankshaft position sensor, most likely cause, I would start there. some sensors will run within perimeters and be bad enough to cause a lot of problems

Jun 14, 2010 | 2000 Nissan Frontier

1 Answer

Crank won't start


Hello, first thing i would do is check for spark, then fuel, if spark is not present you could have a dead coil or a bad crankshaft position sensor. if fuel is not present you could have a clogged fuel filter or bad fuel pump. good luck

Sep 25, 2009 | 2005 Nissan Frontier

3 Answers

Crankshaft poistion sensor location for 2005 nissan altima


Its right next to the passenger side drive shaft, where it goes into the transmission. Right above the drive shaft. It s black with green slider inside of the connector and it has 3 wires coming out of it.

Jul 23, 2008 | 2005 Nissan Altima

Not finding what you are looking for?
2000 Nissan Frontier Logo

945 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85222 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...