Question about 2005 Big Dog Chopper Base

1 Answer

2004 Big Dog Chopper cuts out while riding

I bought a 2004 big dog chopper & almost every ride it will stall, it just shuts down and it does not matter what gear I'm in, it will just stop running, I've heard the module needs to be completely rewired because big dog company will not stand by their own factory warranty,is there anything I can do to solve this problem ? @

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    One Above All:

    The expert with highest point at the last day of the past 12 weeks.

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

  • Big Dog Master
  • 59,789 Answers

Hi, Anonymous and the usual suspects are:
1. Severely discharged or a damaged battery should have 12.5 volts or more and be able to pass a proper "LOAD" test if necessary, you may have a preliminary reading of 12.5 volts or more but little or zero amperage the battery is faulty and must be replaced, AGM batteries fail in this scenario more so than lead-acid batteries.
2. Failed alternator/generator and or voltage regulator.
3. Loose or corroded battery terminals and or cables especially the "NEGATIVE" cable, look for loose, corroded, or broken connectors inside the cable harness at "BOTH" ends.
4. Failed main circuit breaker or ignition switch, check for loose connections and continuity.
5. Failed system and or ignition relay, check for continuity.
6. Failed ignition coil, stator, magneto, ignition/electronic module.
7. Failed CKP, CPS, CMP, MAP, TPS, or BAS sensor, corroded, loose or broken wire connector pins/sockets.
8. Throttle cables and or idle speed improperly adjusted hot idle speed should be 950 RPM to 1000 RPM.
9. Faulty neutral, side stand or clutch lever safety switch.
10. Faulty or corroded kill switch.
11. Accelerator pump damaged or not working.
12. Water or dirt in the fuel system, carburetor or filter.
13. Restricted, blocked or kinked fuel line.
14. Fuel tank empty.
15. The gas cap is not venting properly or fuel tank venting system blocked, loosen gas cap and go for a test ride.
16. A failed fuel pump, pressure regulator and or fuel injectors.
17. Vacuum line from intake manifold to petcock broken, cracked, or not attached, carburetor vent line plugged.
18. Needle and seat stuck closed in the float bowl.
19. Petcock clogged or damaged.
20. Lean angle switch is faulty or needs adjustment.
21. Catastrophic engine failure, perform a compression test.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
power is cutting out
Big Dog Motorcycles Recall For Potential Electrical Problem
2004 Big Dog BDM Motorcycle Service manual Download Manuals Technical $15
Big Dog Parts Accessories
Big Dog Motorcycles 2005 Bulldog Owner Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Posted on Dec 05, 2017

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 Big Dog vintage classic fork oil capacity


Hi, Roger for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can't find the best tool you ever bought for your Big Dog, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Change fork oil
VIDEO 4 BDM Big Dog Motorcyle Complete Fork Rebuild
Big Dog
Big Dog Motorcycle Parts Speed Dealer Customs
Engine Owners Manuals

Aug 12, 2018 | 2005 Big Dog Chopper Base

1 Answer

2004 Big Dog Softail wiring diagram


Hi, Djtawni for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can't find the best tool you ever bought for your Kawasaki, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
2004 Big Dog Softail wiring diagram Google Search
Needing wiring diagram for 2004 bdm chopper
2004 Big Dog BDM Motorcycle Service manual Tradebit $15
Parts Finder Big Dog Motorcycles Wichita KS
Big Dog 2006 Chopper Owner Manual

Jul 06, 2018 | 2005 Big Dog Chopper Base

1 Answer

2007 Big Dog Chopper Base wiring diagram


Hi, Dallas for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can't find the best tool you ever bought for your Big Dog, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
2007 Big Dog Chopper Base wiring diagram Google Search
Basic Motorcycle Wiring
BIG DOG SERVICE MANUALS
Parts Finder Big Dog Motorcycles Wichita KS
http://rnbcycles.com/pdf/manual-2006-K9.pdf

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Jun 05, 2018 | 2007 Big Dog Chopper Base

1 Answer

Torque specs on a rear axle of a 2004 Big Dog


Hi, Carl for this scenario you will need your service, parts fiche, and owners manual if you can't find the best tool you ever bought for your Big Dog, despair not, for a mere $10 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Torque specs
Rear axle nut
2004 Big Dog BDM Motorcycle Service manual Download Manuals Technical $10
Big Dog Parts Accessories
Big Dog Motorcycles 2005 Bulldog Owner Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Sep 17, 2017 | 2005 Big Dog Chopper Base

2 Answers

1997 Big Dog Vintage Classic at Sturgis, SD this weekend, just quit ! He (Art/husband) is out there looking for the problem..12 volt from battery to turn on switch Nothing after that In linefuse loca


Hi, Deborah and the usual suspects are:
1. Ignition Switch not in the "ON" position.
2. Engine Run Switch in the "OFF" position.
3. Discharged battery, needs to be 12.5 volts or better and be able to pass a load test if necessary.
4. Check the battery terminals for damage or corrosion check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
5. Bank angle sensor tripped and ignition/light key switch not cycled to the "OFF" position and then back to the "ON" position.
6. Faulty ignition switch.
7. Faulty starter button.
8. Faulty kickstand or clutch pull in switch/sensor.
9. Security alarm needs a reset.
10. Starter control circuit, relay, or solenoid faulty.
11. Main fuse or circuit breaker may be blown or faulty.
12. Electric starter shaft pinion gear is not engaging or over-running starter clutch slipping.
13. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have nice a day.
What to do When Your Motorcycle Won Start
TROUBLE SHOOTING
Steps to Take When Your Motorcycle Won Start Dennis Kirk Powersports Blog
Big Dog manual 2005 all models pdf

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Aug 15, 2016 | Motorcycles

1 Answer

Wiring schematic for 2006 big dog motorcycle


Hi, Anonymous I am sorry you can't find the first and best tool you ever bought for your Big Dog but despair not for a mere $0 you can download another one. For more information about your issue, please visit the websites below. Good luck and have a nice day.
Wiring schematic for 2006 big dog motorcycle Google Search
wiring diagram
Service Manual for 2007 Big Dog K9
Big Dog Parts Cruiser Motorcycle
Big Dog motorcycle manuals

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Jun 22, 2014 | 2006 Big Dog Chopper Base

1 Answer

Motorcycle wiring schematics


Hi, Anonymous I am sorry you can't find the first and best tool you ever bought for your Big Dog but despair not for a mere $0 you can download another one. For more information about your issue, please visit the websites below. Good luck and have a nice day.
2005 Big Dog Chopper Base wiring schematics Google Search
BigDog wiring diagram Club Chopper Forums
Service Manual for 2007 Big Dog K9
Big Dog Parts Cruiser Motorcycle
Big Dog motorcycle manuals

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

May 14, 2014 | 2005 Big Dog Chopper Base

1 Answer

How much oil goes into a BIGDOG 07K9


Hi, Anonymous I am sorry you can't find the first and best tool you ever bought for your Big Dog but despair not for a mere $0 you can download another one. For more information about your issue, please visit the websites below. Good luck and have a nice day.
chopper motorcycle oil change
Big Dog motorcycle manuals
http://www.rnbcycles.com/pdf/manual-2006-K9.pdf
2007 Big Dog 9 Base Accessories Used 2007 K9 Base Parts amp OEM...
BDM Big Dog Motorcycles Tampa 813 935 4166 Big Dog Motorcycle DaytonaMiami...

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


Apr 24, 2014 | 2010 Big Dog K9

1 Answer

Torque specification


Hi Anonymous, most of the fasteners on a Big Dog are made of medium carbon heat treated steel SAE grade 5 or better.
1/4"-10 ft-lbs. 6.4mm-15nm
5/16"-20 ft-lbs. 7.9mm-25nm
3/8"-35 ft-lbs. 9.5mm-45nm
7/16"-55 ft-lbs. 11.1mm-75nm
1/2"--75 ft-lbs. 12.7mm-110nm
For more information about your issue, please visit the websites below. Good luck and have nice a day.
Torque specs
Used 2006 Big Dog Chopper Reviews Prices and Specs at Motorcyclist Magazine
Service Manual for 2007 Big Dog K9
2007 Big Dog 9 Parts
Big Dog motorcycle manuals

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Mar 23, 2014 | 2010 Big Dog Mastiff Base

Not finding what you are looking for?
2005 Big Dog Chopper Base Logo

Related Topics:

291 people viewed this question

Ask a Question

Usually answered in minutes!

Top Big Dog Experts

Arnie Burke
Arnie Burke

Level 3 Expert

5971 Answers

Marvin
Marvin

Level 3 Expert

85216 Answers

richard libby

Level 2 Expert

209 Answers

Are you a Big Dog Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...