Question about Zongshen Motorcycles

1 Answer

Bought a used gio dirt bike with a zongshen CB250 engine and I bought the wire harness and headlight because the harness came with the instrument control for you headlight and signal lights I just don’t have a battery. But I have kickstart but it’s been awhile sines I’ve done this type of wiring and can’t seem to find a diagram for the wiring, I’m alittle lost on what wires go where. Any help with be greatly appreciated

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    One Above All:

    The expert with highest point at the last day of the past 12 weeks.

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

  • Zongshen Master
  • 60,754 Answers

Hi, Chris you need to repost your question under the Gio category, not Zongshen . Thanks, Gregg

Posted on Jan 02, 2020

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 5 Answers

SOURCE: headlight wiring diagram 95 honda accord lx

Red/white is left high beam and red/yellow is left low beam. Red/orange is right high beam and red/green is right low beam.

Posted on Jun 29, 2008

keemo68

Ronald Mueller

  • 1263 Answers

SOURCE: 2007 HHR Wiring diagram

is there spark? is their fuel? also if it was wrecked chances are that the fuel cut-off switch was triggered. i have not ever worked on one so i don't exactly know where it is but i would check behind the fabric/hard plastic right rear/left rear wheel hosing and see if you can hit the reset switch. another suggestion is go to napa or oreillys and get a repair manual for it it has diagrams and schematics in it and it cost about 20 bucks.....good luck please rate this.....thanks

Posted on Sep 01, 2008

Anonymous

  • 88 Answers

SOURCE: need wiring shematic for fog lights 2005 toyota corolla

im pretty sure these cars were already prewired for fog lights .there should be some plugs behind the bumper to fit them.if not get back i will explain how to wire them up.best of luck.

Posted on Oct 17, 2008

inf12

Harry Daehling

  • 13 Answers

SOURCE: need wiring diagram for taillights on 2000 chevy venture van

d7d3cd6.jpg3a50d5e.jpg80738de.jpg8d3e722.jpg GOOD LUCK

Posted on Feb 08, 2009

Anonymous

  • 68 Answers

SOURCE: wiring diagram for pioneer deh-p41

Yellow for memory.
Red for power acc.
Black for ground.
Blue for remote turn on(amps and accessories).
Gray pair is for right front speakers, solid for positive,striped for negative.
White pair for Left front, again solid is pos, striped is neg.
Violet or purple for right rear, same with solid or striped.
Green pair for left rear, same solid/stripe configuration.

Posted on Nov 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Zongshen zs 125-2 commuter valve clearance


Hi, Raymond for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can't find the best tool you ever bought for your Zongshen, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
Valve clearances for pushrod engine ChinaRiders Forums
Honda CG 125 valve clearance tutorial
http://www.mychinamoto.com/forums/showthread.php?3169-Zongshen-Manual
Specialist Online Chinese Bike Spares
http://www.ssrmotorsports.com/store/owners_manual.php

Aug 13, 2018 | Zongshen Motorcycles

1 Answer

2006 Zongshen GS 250 wiring diagram


Hi, DJ for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can't find the best tool you ever bought for your Zongshen, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
2006 Zongshen GS 250 wiring diagram Google Search
Help with 2006 zongshen storm 250cc gs Page 2 ChinaRiders Forums
Zongshen gs 250 service manual
Specialist Online Chinese Bike Spares
https://www.ultimatespecs.com/motorcycles-specs/zongshen/zongshen-gs-250-2006

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

May 03, 2018 | Zongshen Motorcycles

1 Answer

2010 Zongshen M98-H wiring diagram


Hi, Slim for this scenario you will need your service manual that has all fastener torque specs and a wiring diagram on the back pages, parts fiche, and owners manual if you can't find the best tool you ever bought for your Kawasaki, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below. Good luck and have a wonderful day.
2010 Zongshen M98 wiring diagram Google Search
Wiring diagram for zongshen
http://www.yamaha-motor.com/assets/service/manuals/2007/LIT-11626-20-01_ttr125all_1961.pdf
Zongshen Motorcycle Parts eBay
https://www.epa.gov/sites/production/files/2014-10/documents/sa-imports-zongshen-101106.pdf
ZONGSHEN ZS250GY 3 EFI Maintenance Manual

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Mar 09, 2018 | Zongshen Motorcycles

1 Answer

Can't get bike started our get carb out on gio x35 250cc


Hi, Nick and the usual suspects are:
1. Fuel tank empty.
2. The fuel tank has old dead gas.
3. Fuel tank bottom contaminated with ethanol sludge, dirt, water, rust, etc.
4. Fuel supply valve/petcock turned off.
5. Fouled spark plugs.
6. Engine flooded as a result of overuse of the enrichner.
7. Vacuum hose to the fuel supply valve/petcock disconnected, broken, cracked, or pinched.
8. Fuel valve/petcock or filter clogged.
9. Fuel line to carburetor or throttle body pinched, kinked or blocked.
10. Carburetor float stuck.
11. Fuel injectors clogged.
12. A severely discharged or damaged battery, you need 12.5 volts or better and be able to pass a load test if necessary.
13. Check battery terminals for damage or corrosion, check the battery cables at "BOTH" ends for loose, corroded, or broken connectors, "INSIDE" and outside the cable harness, perform connector wiggle test and check cables with an ohmmeter if necessary.
14. Loose or corroded wire connection at the coil or plug between ignition sensor and ECM module.
15. Spark plug cables in bad condition and shorting check for spark leakage in the dark, cable connections loose, or connected to the wrong cylinders.
16. Ignition timing incorrect due to a faulty ignition coil, ignition module or MAP, CMP, CKP, O2, TPS, ETP, IAC sensors.
17. Faulty neutral, clutch lever, or kickstand safety switch.
18. Faulty fuel pump or fuse or relay.
19. A stuck bent or burnt valve.
20. Tilt sensor needs a reset.
21. Security system not disarming alarm needs a reset.
22. Check for engine trouble codes.
For more information about your issue and valuable "FREE" downloads that you will need please click on the blue links below. Good luck and have a wonderful day.
cranks but wont start
What to Do Check When Dirt Bike Won Start
Dirt Bike Parts
http://bajamotorsports.com/system/documents/83_OWNERS_MANUAL_-_X250_Dirt_Bike_Owners_Manual_VIN_prefix_LZX_.pdf
Gio X31 250cc Review

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e


Mar 25, 2017 | Motorcycles

1 Answer

How to put the whole wiring harness including speedo horn headlight rear light, regulator back on a ktm 300 exc 07


Hi mark first stretch out the harness beside the bike to be sure it's the right one for it. Then look at each connection on the bike and harness try find the mid point ie. the engine electrics and connect them up then work your way forward. Then backwards the harness will have to be inside the frame to avoid damage especially around the seat area. When the harness is in place fit lights and whatever else is there and wire it as you go. If you find a few spare connectors don't worry many harnesses are made to suit other models. Have fun.

May 22, 2015 | 2007 KTM 300 EXC

1 Answer

78 gs750 engine wire harness???


very basic loom , if you lay it over the bike then offer up the same colour connections to parts fitted to the engine and headlight assy , ignition then you should be able to temp re connect and then route the loom down the frame starting from the headstock etc !

Feb 22, 2014 | Suzuki Motorcycles

1 Answer

1998 R1 clocks and speedo go out on headlights and when horn is pressed. all ok when only sidelights are on. please help!!


Hi, Anonymous you may have a faulty wire connector to the instrument wiring harness or faulty ground for that harness for this scenario you will need your service/owners manual if you can't find the first and best tool you ever bought for your Yamaha, despair not, for a mere $0 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please click on the links below. Good luck and have a nice day.
http://www.r1-forum.com/forums/105-07-08-r1-mechanical-help/262996-headlights-instrument-lights-not-working.html
Weird Headlight Problem
1998 1999 Yamaha YZF R1 Service Manual R1 Moto Data Project
OEM parts for Yamaha
http://mybikemanuals.com/yamaha/yamaha-yz-owners-manuals

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Aug 11, 2012 | 1998 Yamaha YZF-R1

1 Answer

No spark


check for the wiring...we used to bought some of those atv hummer style...and there is no continuity in the wiring because of bad terminal connexion to the inside brush of the cable...or you have a faulty stator....coil and cdi is not the main problem on those cheap engine....loncin,bears,zongshen....

Sep 19, 2009 | 2004 Bajaj Caliber 115

Not finding what you are looking for?
Motorcycles Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Zongshen Experts

Joseph Coppeto
Joseph Coppeto

Level 3 Expert

352 Answers

Tom Chichester

Level 3 Expert

55370 Answers

Terry
Terry

Level 3 Expert

10748 Answers

Are you a Zongshen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...