2008 Ford F 450 Super Duty "step change ignition control module" Questions

Ad

Question about Ford F-450

1 Answer

ignition lock cylinder is not programmed, is not a PATS key, is damaged or the transceiver, circuitry or IC may be at fault. Viewing the MIN_KEY (minimum number of keys) PID (this PID does not change)

Ad

Question about Ford F-450

1 Answer

...step proseadure is required to perform this task. How ever if your engine has a distributor then the ignition timing is controled by the distributor. Good Luck. From Ernie @ RedDeer, Alberta,

Ad

...How do you know its due to intermittent spark and not a fuel delivery issue? The ignition control module is a good next step if you have changed all of the coils and confirmed it is not a fuel

...step actuators to extend or retract the assist steps. Each actuator consists of an electric motor and a potentiometer. The module supplies a low reference and 10-volt reference source voltage to the ...

...step seems to be the CMI...or any other suggestion ? How do I check the Control Module Ignition? sound like bad ignition module.make sure where coil pack set in module contacts is clean and making ...

...Step 6 -- 6 Turn the ignition OFF for 30 seconds. Start the engine. Does the vehicle operate correctly without any MIL illumination, and without any stored DTCs? System OK Go to Diagnostic System ...

Step 3 Turn the ignition OFF. Remove the transfer case select switch. Disconnect the connector on the transfer case select switch. Turn the ignition ON. Probe the ignition 3 voltage circuit with a DMM

...change while pressing and releasing the brake? YES - Go to Step 6 NO - Go to DTC C0161 6 Remove the electronic brake control module (EBCM) from the vehicle. Refer to Control Module References . ...

...change. CYL missfire, 2 & 3 Diagnostics code on Trans is u0401 Invalid data received from ecm/pcm/a Circuit Description Modules that are connected to the shared communication circuits monitor for ...

...Step 7 4 Turn the ignition switch OFF. Test the encoder signal ground circuit for an open or high resistance. Refer to General Electrical Diagnosis and Wiring Repairs in Wiring Systems. Did you find ...

Not finding what you are looking for?
Cars & Trucks Logo

195 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...