1997 Geo Metro "not idle" Questions

Ad

...idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle ...

Ad

Question about Geo Metro

1 Answer

car does stay on idle start but need to be accelerated but does not stay idling. that is your throttle position sensor or your idle air control module

Ad

...not come off high idle. No vac. leaks, replaced coolant temp sensors (2), tried to adjust tps. no luck there. Timing is correct, car runs great, just won't idle down. Anybody have any thoughts? i ...

...idle. It will not rev up no matter where the throttle is. If you keep it at full throttle it will eventually rev to full throttle and you can increase/decrease rpm's as long as you do not let it go ...

idle, it will not cause no power, and that code could have set, due to no engine power, check fuel filter that it's not clog, could have good fuel pressure, but under load not getting enough gas, also

Question about Geo Metro

1 Answer

...idle speed will not be controllable, your fuel mileage will be poor and your engine will run a little hotter than normal. The coolant flow needs the throttle body to pass fluid freely and also your ...

Question about Geo Metro

2 Answers

...not listed in my manual. Can anyone help me here? Thanks, Jlawx2 Code 46 is indeed the trouble code for the Idle Speed Controller which is that big black box thingy on your throttle body. A lot of ...

Question about Geo Metro

1 Answer

...idle a little high. not too high but what seems higher than normal. but once it gets warm, at a sitting position it will idle then cut out then idle then cut out. kind of like its getting revved then ...

...idle but will not increase RPM's unless you hold the pedal to the floor and then it slooowly increases RPM's (like 30-40 sec.). It will rev up and down then unless you let it go all the way back down ...

Question about Geo Metro

2 Answers

...prob!! wont go to high idle,tps set at 1.0 volts cant get o ohms from test a and b terminals wont go to high idle this is the IAC failing not TPS, the tps only signals to the ECU that you are at

Not finding what you are looking for?
1997 Geo Metro Logo

324 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1995 Geo Metro
1995 Geo Metro

215 Questions

1994 Geo Metro
1994 Geo Metro

193 Questions

1993 Geo Metro
1993 Geo Metro

168 Questions

1996 Geo Metro
1996 Geo Metro

168 Questions

1992 Geo Metro
1992 Geo Metro

150 Questions

Top Geo Experts

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...